Sodium hydride, reaction with alcohols

Sodium cyanoborohydride. reductive ami nation with, 931 Sodium cyclamate, LP50 of, 26 Sodium hydride, reaction with alcohols, 605... 

Write equations for the reaction of a specific alcohol or phenol with sodium or sodium hydride or with an aqueous base (NaOH, KOH). 

Substituted o-benzenesulfonamide 61 was found to be a good source for the synthesis of 4-methoxybenzyl esters by the reaction with alcohols and phenols in the presence of sodium hydride at room temperature <1998TL1799>. Treatment of cyclic sulfonamide 61 with aqueous KOH in dimethylformamide (DMF) yielded 4-methoxybenzyl alcohol together with benzenesulfonamide 53 (Scheme 5). 

Bucherer-Bergs products were also the starting points for the preparation of potent and selective muscarinic M3 receptor antagonists (Table 20) [83]. Hydantoins of general structure 228 (Scheme 40) participated in Mitsunobu reactions with alcohols to provide derivatives 229, which were reduced with sodium bis (2-methoxyethoxy)aluminum hydride (Red-Al) to afford imidazolidinones 230. Removal of the benzyl group allowed for further functionalization of the secondary amines to yield compounds 231. 

The formation of the above anions ("enolate type) depend on equilibria between the carbon compounds, the base, and the solvent. To ensure a substantial concentration of the anionic synthons in solution the pA" of both the conjugated acid of the base and of the solvent must be higher than the pAT -value of the carbon compound. Alkali hydroxides in water (p/T, 16), alkoxides in the corresponding alcohols (pAT, 20), sodium amide in liquid ammonia (pATj 35), dimsyl sodium in dimethyl sulfoxide (pAT, = 35), sodium hydride, lithium amides, or lithium alkyls in ether or hydrocarbon solvents (pAT, > 40) are common combinations used in synthesis. Sometimes the bases (e.g. methoxides, amides, lithium alkyls) react as nucleophiles, in other words they do not abstract a proton, but their anion undergoes addition and substitution reactions with the carbon compound. If such is the case, sterically hindered bases are employed. A few examples are given below (H.O. House, 1972 I. Kuwajima, 1976). 

The speed of the reaction depends both on the metal and on the alcohol, increasing as electropositivity iacreases and decreasiag with length and branching of the chain. Thus sodium reacts strongly with ethanol, but slowly with tertiary butyl alcohol. The reaction with alkaU metals is sometimes carried out ia ether, ben2ene, or xylene. Some processes use the metal amalgam or hydride iastead of the free metal. Alkaline earth metals and aluminum are often covered with an oxide film which hinders the reaction. 

Substitution of an additional nitrogen atom onto the three-carbon side chain also serves to suppress tranquilizing activity at the expense of antispasmodic activity. Reaction of phenothia zine with epichlorohydrin by means of sodium hydride gives the epoxide 121. It should be noted that, even if initial attack in this reaction is on the epoxide, the alkoxide ion that would result from this nucleophilic addition can readily displace the adjacent chlorine to give the observed product. Opening of the oxirane with dimethylamine proceeds at the terminal position to afford the amino alcohol, 122. The amino alcohol is then converted to the halide (123). A displacement reaction with dimethylamine gives aminopromazine (124). ... 

Methylsulfinyl carbanion (dimsyl ion) is prepared from 0.10 mole of sodium hydride in 50 ml of dimethyl sulfoxide under a nitrogen atmosphere as described in Chapter 10, Section III. The solution is diluted by the addition of 50 ml of dry THF and a small amount (1-10 mg) of triphenylmethane is added to act as an indicator. (The red color produced by triphenylmethyl carbanion is discharged when the dimsylsodium is consumed.) Acetylene (purified as described in Chapter 14, Section I) is introduced into the system with stirring through a gas inlet tube until the formation of sodium acetylide is complete, as indicated by disappearance of the red color. The gas inlet tube is replaced by a dropping funnel and a solution of 0.10 mole of the substrate in 20 ml of dry THF is added with stirring at room temperature over a period of about 1 hour. In the case of ethynylation of carbonyl compounds (given below), the solution is then cautiously treated with 6 g (0.11 mole) of ammonium chloride. The reaction mixture is then diluted with 500 ml of water, and the aqueous solution is extracted three times with 150-ml portions of ether. The ether solution is dried (sodium sulfate), the ether is removed (rotary evaporator), and the residue is fractionally distilled under reduced pressure to yield the ethynyl alcohol. 

The most generally useful method of preparing ethers is by the Williamson ether synthesis, in which analkoxido ion reacts with a primary alkyl halide or tosylate in an S 2 reaction. As we saw earlier in Section 17.2, thealkoxide ion is normally prepared by reaction of an alcohol with a strong base such as sodium hydride, NaH. 

Butyl alcohol in synthesis of phenyl 1-butyl ether, 46, 89 1-Butyl azidoacetate, 46, 47 hydrogenation of, 46, 47 1-Butyl chloroacetate, reaction with sodium azide, 46, 47 lre l-4-i-BUTYLCYCLOHEXANOL, 47,16 4-(-Butylcyclohexanonc, reduction with lithium aluminum hydride and aluminum chloride, 47, 17 1-Butyl hypochlorite, reaction with cy-clohexylamine, 46,17 l-Butylthiourea, 46, 72... 

A synthetically useful diastereoselectivity (90% dc) was observed with the addition of methyl-magnesium bromide to a-epoxy aldehyde 25 in the presence of titanium(IV) chloride60. After treatment of the crude product with sodium hydride, the yy -epoxy alcohol 26 was obtained in 40% yield. The yyn-product corresponds to a chelation-controlled attack of 25 by the nucleophile. Isolation of compound 28, however, reveals that the addition reaction proceeds via a regioselective ring-opening of the epoxide, which affords the titanium-complexed chloro-hydrin 27. Chelation-controlled attack of 27 by the nucleophile leads to the -syn-diastereomer 28, which is converted to the epoxy alcohol 26 by treatment with sodium hydride. 

An interesting approach to zr n.v-2,3-disubstituted cyeloalkanones is offered by auxiliary controlled intramolecular Michael additions. The diastereoselectivity depends on the chiral alcohol used193> l94. When the borneol derivative 7 was used as substrate, a single diastereomer of 8 resulted when the reaction was performed at 25 "C under thermodynamic control with a catalytic amount of sodium hydride in benzene. 

Barium oxide and sodium hydride are more potent catalysts than silver oxide. With barium oxide catalysis, reactions occur more rapidly but O-acetyl migration is promoted. With sodiun hydride, even sterically hindered groups may be quantitatively alkylated but unwanted C-alkylation Instead of, or in addition to, 0-alkylatlon is a possibility. Sodium hydroxide is a suitable catalyst for the alkylation of carboxylic acids and alcohols [497J. 

As a practical matter, the alkoxide used as the base must be the same as the alcohol portion of the ester to prevent product mixtures resulting from ester interchange. Sodium hydride with a small amount of alcohol is frequently used as the base for ester condensation. The reactive base is the sodium alkoxide formed by reaction of sodium hydride with the alcohol released in the condensation. 

---