Slug

PPha, pyridine) organic groups (olefines, aromatic derivatives) and also form other derivatives, e.g. halides, hydrides, sulphides, metal cluster compounds Compounds containing clusters of metal atoms linked together by covalent (or co-ordinate) bands, metaldehyde, (C2H40) ( = 4 or 6). A solid crystalline substance, sublimes without melting at I12 1I5" C stable when pure it is readily formed when elhanal is left in the presence of a catalyst at low temperatures, but has unpredictable stability and will revert to the monomer, ft is used for slug control and as a fuel. 

The amount of processing required in the field depends upon the composition of the gas and the temperature and pressure to which the gas will be exposed during transportation. The process engineer is trying to avoid liquid drop-out during transportation, since this may cause slugging, corrosion and possibly hydrate formation (refer to Section 10.1.3). For dry gases (refer to Section 5.2.2) the produced fluids are... 

The inlet section is designed to separate out most of the liquid phase such as large slugs or droplets in a two phase stream. These simple devices redirect the inlet flow... 

If several widely spaced fields are feeding a single gathering and treatment centre it is common to perform primary separation of gas and oil (and possibly water) in the field. A field station may include a simple slug catcher, temporary storage tanks and pumps for getting the separated fluids to the main gathering and treatment centre. 

Aluminum. The majority of aluminum containers are of monobloc (one-piece) constmction, impact extmded from a slug of lubricated aluminum alloy. These containers are widely used for many products and are available in a vast array of heights and diameters. Because these containers lend themselves to additional shaping, many unusual shapes can be found in the marketplace. They may also be coated after the extmsion process. 

If the bed is slugging, bubble motion is retarded by the bed wall, and the bed or tube diameter, Z9, rather than the actual bubble diameter, determines the bubble rise velocity, ie... 

Nitrogen is used for pressure maintenance in oil and gas reservoirs for enhanced recovery. It is sometimes used as a miscible agent to reduce oil viscosity and increase recovery in deep reservoirs. Other appHcations include recovery of oil in attic formations, gas cap displacement, and a sweep gas for miscible CO2 slugs. Nitrogen competes with CO2, a more miscible gas with hydrocarbons (qv), in most of these appHcations. The production mode is typically by on-site cryogenic separation plants. In 1990, nitrogen production in enhanced recovery operations was 20 x 10 m /d (750 million SCF/d)... 

Over the years, a variety of fuel types were employed. Originally, natural uranium slugs canned in aluminum were the source of plutonium, while lithium—aluminum alloy target rods provided control and a source of tritium. Later, to permit increased production of tritium, reactivity was recovered by the use of enriched uranium fuel, ranging from 5—93%. 

Outdoor Pests biting flies, fire ants, hornets, mosquitoes, ticks, wasps mice, moles snails, slugs mil dews, molds, mosses... 

Fig. 1. Carbon dioxide flooding. The WAG process, in which a CO2 slug is followed by alternate water and CO2 injections, is usually employed. The...

Process effectiveness depends on maintaining an ultralow (ca 10 ° N/m (10 dynes/cm)) interfacial tension between the injected surfactant slug and the cmde oil (213). The effect of petroleum composition on oil solubilization by surfactants has been the subject of extensive study (214). 

Flow Regimes in Multiphase Reactors. Reactant contacting, product separations, rates of mass and heat transport, and ultimately reaction conversion and product yields are strong functions of the gas and Hquid flow patterns within the reactors. The nomenclature of commonly observed flow patterns or flow regimes reflects observed flow characteristics, ie, armular, bubbly, plug, slug, spray, stratified, and wavy. 

Analysis of a method of maximizing the usefiilness of smaH pilot units in achieving similitude is described in Reference 67. The pilot unit should be designed to produce fully developed large bubbles or slugs as rapidly as possible above the inlet. UsuaHy, the basic reaction conditions of feed composition, temperature, pressure, and catalyst activity are kept constant. Constant catalyst activity usuaHy requires use of the same particle size distribution and therefore constant minimum fluidization velocity which is usuaHy much less than the superficial gas velocity. Mass transport from the bubble by diffusion may be less than by convective exchange between the bubble and the surrounding emulsion phase. 

Micellar/polymer (MP) chemical enhanced oil recovery systems have demonstrated the greatest potential of all of the recovery systems under study (170) and equivalent oil recovery for mahogany and first-intent petroleum sulfonates has been shown (171). Many somewhat different sulfonate, ie, slug, formulations, slug sizes (pore volumes), and recovery design systems were employed. Most of these field tests were deemed technically successful, but uneconomical based on prevailing oil market prices (172,173). 

---