Self-levelling floors

The calcium sulfate [7778-18-9] discharged from the furnace can also be recovered. This is less the practice in the United States where natural gypsum is plentiful and inexpensive than in Europe, where CaSO recovery for use in cement (qv) and self-leveling floors is common. Some CaSO is recovered in the United States, primarily for lower end uses such as road aggregate. 

These are used to produce prepackaged products such as decorative wall coatings, ceramic tile adhesives, self-leveling floor overlays and patching mortars for concrete structures. On site, addition of the product manufacturers specified amount of water produces a material with the desired properties. During the wet mixing, the... 

Conductive floors provide effective control of static electricity Available in the form of screeds, self-levelling floors and floor coatings Water resistant... 

Epoxies have an excellent resistance to abrasion. The abrasion resistance of a particular system depends upon the type of formulation and conditions. For example coatings have the capacity to resist abrasion from rubber wheels, whereas screed floorings, repair mortar and self-levelling floors can resist thousands of cycles from steel wheels. 

Floor topping A polymeric material applied on concrete floors for a specific reason. Screed floorings and self-levelling floors are included in this category. 

Defoamer formulations or active ingredients can also be applied on solid carriers like silica or organic substances to yield free flowing powders They are used in powder type formulations like plasters, mortars, self-levelling flooring components, etc. 

Table 5 J Self-Leveling Floor Overlay Using Redispersible EVA Powder.

Self-leveling floors are produeed from low-viscosity epoxy systems. Low-exotherm, unfilled systems are preferred. The entire floor should be cast in one operation, and thickness should preferably be at least 5 mm over the entire area. Because of their excellent chemical resistance to a wide range of chemicals, epoxies are often selected for flooring in chemical plants. Systems vary from trowelable to pourable or brushable and are usually filled. Choice of hardener and filler will depend on the specific chemicals encountered. Although tables of chemical resistance from suppliers will aid in selection of a suitable system, this system should always be tested using the chemicals that the floor is expected to withstand. 

Uses Defoamer for powdered joint cements, protein binders, self-leveling flooring compds, tile grout, decorative plaster, masonry coatings, and patching compds., paper/paperboard... 

De Gasparo, A., M. Herwegh, R. Zurbriggen and K. Scrivener (2009). Quantitative distribution patterns of additives in self-leveling flooring compounds (under-layments) as function of application, formulation and climatic conditions . Cement and Concrete Research 39(4) 313-323. 

---