Satisfactory event

In addition, Bill Johnson used a scroll as a normally expected event and an oval as a satisfactory event. The normally expected event distinguishes events that are typically a part of any system, such as change and normal variability. The satisfactory event describes events that may be accident causal factors but are a necessary part of the operation, like functional (part of the system) people or objects in the energy channel. Also, in addition to using the traditional transfer symbol (a triangle), the MORT chart includes capital letters as drafting breaks and small ellipses as risk transfers (Fig. 18-3). 

Figure 18-1 Event Symbols. The General Event symbol, Basic Event symbol, and Undeveloped Terminal event symbol are the same as commonly used for other fault trees. The use of the stretched circle for a Satisfactory Event and the scroll for a Normally Expected Event are unique to the MORT chart.

In addition to these, the MORT chart also uses a rounded rectangle, or elongated circle, to represent a satisfactory event (an event that may have contributed to an accident or incident but whose existence is essential for normal system operation). Also, instead of the house symbol common to fault tree analysis to represent those events that are considered normal and expected in a typical system, MORT uses a scroll symbol. Figure 13.2 shows the MORT symbols as described here. 

For certain types of stochastic or random-variable problems, the sequence of events may be of particular importance. Statistical information about expected values or moments obtained from plant experimental data alone may not be sufficient to describe the process completely. In these cases, computet simulations with known statistical iaputs may be the only satisfactory way of providing the necessary information. These problems ate more likely to arise with discrete manufactuting systems or solids-handling systems rather than the continuous fluid-flow systems usually encountered ia chemical engineering studies. However, there ate numerous situations for such stochastic events or data ia process iadustries (7—10). 

The methodology for assessment of external events is qualitatively satisfactory but not quantitatively. Little confidence should be placed in any estimates of the risk from external initiators compared to those from internal initiators. This is exacerbated by the fact that the external risk is the larger of the two in many cases. 

In the event of any of the checks not being satisfactory the burner is shut down or locked out, as appropriate. 

Sometimes it is not practical to blowdown the level controls and shut down the incinerator. In this case, the situation should be discussed with the insurance company and the boiler supplier. It is possible to include for an extra high working water level giving a safety margin above the heating surfaces. The controls may then be blown down and checked for satisfactory operation with a predetermined time delay before it shuts down the incinerator or operates a bypass in the event of a fault. 

Figures 57 and 58 shows the estimation results for the intervals of the unmeasured states Cti and Z. Notice how the interval bounds estimated by the interval observer envelop correctly these unmeasured states. For all the other unmeasured states, notice that although the interval observer design did not allow us to tune the convergence rate, the interval observer showed excellent robustness and stability properties and provided satisfactory estimation results in the event of highly corrupted measurements and operational failures. Notice in particular, the robustness of the interval observer around day 25 when the inlet concentrations drastically increased and when a major disturbance occurred at day 31, due to an operational failure, resulting in a rapid fall of both, the dilution rate (which actually fell to zero) and the substrate concentration readings. Off-line readings of Cti and Z (not used in the state estimation calculations) were also added to validate the proposed interval observer design (see Figures 57 and 58). It should be noticed that the compromise between the convergence rate and robustness was not fully achieved until the estimation error dynamics reached the steady state.

Several models have been proposed (Cast, 1968 Shaw, 1970 Hertoghen and Gijbels, 1976), but the most satisfactory are those based on iterative calculations, because they allow the evaluation of discontinuous events with sudden modifications of melting proportions, which are common in geological open systems (note that such discontinuities, or even the evolution of melting proportions, cannot be accounted for, if the distribution equations are obtained by integration at the limit). The following distribution model (Ottonello and Ranieri, 1977) is a partial modification of Cast s (1968) approach ... 

Treatment of insulin-dependent type 1 diabetes mellitus and non-insulin-dependent type 2 diabetes mellitus when diet or weight control has failed to maintain satisfactory blood glucose levels or in event of fever, infection, surgery, ortrauma, or severe endocrine, hepatic, or renal dysfunction emergency treatment of ketoacidosis (regular insulin) to... 

Tropisetron. The 5-FIT3 antagonist tropisetron has also been reported to be effective in the treatment of patients with generalized anxiety disorder [Lecrubier et al. 1993). The anxiolytic effect of tropisetron develops quickly, is dose dependent, and is accompanied by satisfactory tolerability and safety. The incidence of adverse events, including headache, nausea, constipation, and nervousness, is low and the severity is generally mild. The most typical adverse effects of benzodiazepine anxiolytics, such as fatigue, muscle relax-... 

Consent decrees typically involve a defendant agreeing to address the areas of noncompliance in a manner satisfactory to the FDA within a certain amount of time. It can also provide for the hiring of an expert consultant to certify in detailed reports that the manufacturing facility, at periodic dates, is in full compliance with the cGMPs, and has adequate adverse-event controls, adequate training, and adequate recall procedures. It may also require the payment of money to the U.S. Treasury such as under the equitable remedy of disgorgement, as described in Figure 8. 

One way to find the envelope mass would be to estimate the circumstellar mass, and subtract. This is unlikely to lead to a satisfactory estimate because the ionizing flux from the supernova is not so large that we can be sure it has ionized all the surrounding material. This approach is also vulnerable to large errors from clumping effects, and in any event requires an accurate knowledge of the density which we are unlikely to possess. 

---