Samples volatile components

If the water insoluble mixture is a liquid, evaporate a small sample (say, 4 ml.) in an evaporating dish on a water bath in order to determine the amount of volatile components, if any. If the solvent distils at the temperature of the boihng water bath, it is advisable to distil ofiF this solvent on a water bath and to replace it by ether. 

Dynamic mechanical analysis provides a useful technique to study the cure kinetics and high temperature mechanical properties of phenoHc resins. The volatile components of the resin do not affect the scan or limit the temperature range of the experiment. However, uncured samples must be... 

The carbon residue is a measure of the carbon compounds left in a fuel after the volatile components have vaporized. Two different carbon residue tests are used, one for light distillates, and one for heavier fuels. For the light fuels, 90% of the fuel is vaporized, and the carbon residue is found in the remaining 10%. For heavier fuels, since the carbon residue is large, 100% of the sample can be used. These tests give a rough approximation of the tendency to form carbon deposits in the combustion system. The metallic compounds present in the ash are related to the corrosion properties of the fuel. 

When the sample solvent evaporates at the front end of the liquid, volatile compounds co-evaporate with the solvent and start moving through the main column. In this way, volatile components can be lost through the early vapour exit or, if venting is delayed, the most volatile compounds reach the detector even before the end of... 

In the preparation of many solid state reference materials, reduction of the grain size plays an important role. Usually this reduction is required because of the measurement methods to be used both in the projects and later by the users of the reference material, as well as to come to an acceptable minimum sample intake. The minimum sample intake can be defined as the minimum amount of material needed, so that the heterogeneity of the material does not affect the repeatability of the measurement method. The reduction of the grain size is usually implemented by crushing and/or grinding techniques. The techniques employed and the equipment used must be suitable for the purpose of processing the material. Potential problems of contamination, loss of volatile components, and/or other physical and... 

Advantages and disadvantages of HS-GC over regular GC are summarised in Table. 4.26. HS-GC fingerprinting chromatograms obviously include only the volatile components present and do not provide a complete picture of sample composition on the other hand, when solvent extraction is used, all the soluble sample constituents are removed, including also those having no appreciable vapour pressure at the equilibration temperature. Headspace analysis enhances the peaks of volatile trace components. 

Dynamic headspace GC-MS involves heating a small amount of the solid polymer sample contained in a fused silica tube in a stream of inert gas. The volatile components evolved on heating the sample are swept away from the sample bulk and condensed, or focused on a cryogenic trap before being introduced onto the chromatographic column via rapid heating of the trap. The technique can be used qualitatively or quantitatively DHS-GC-MS is considered to be well suited towards routine quantitative analysis. 

GC/FID has been used for quantifying sulfur volatiles such as hydrogen sulfide in human saliva (Solis and Volpe 1973). This method included microcoulometric titrations and a procedure for incubation of saliva and sampling of headspace sulfur volatile components. The amount of total sulfur volatiles detected in control samples of saliva incubated at 37°C for 24 hours ranged from 4.55 to 13.13 ppm. 

---