Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Reduction Experimental Procedure

The synthetic procedure described is based on that reported earlier for the synthesis on a smaller scale of anthracene, benz[a]anthracene, chrysene, dibenz[a,c]anthracene, and phenanthrene in excellent yields from the corresponding quinones. Although reduction of quinones with HI and phosphorus was described in the older literature, relatively drastic conditions were employed and mixtures of polyhydrogenated derivatives were the principal products. The relatively milder experimental procedure employed herein appears generally applicable to the reduction of both ortho- and para-quinones directly to the fully aromatic polycyclic arenes. The method is apparently inapplicable to quinones having an olefinic bond, such as o-naphthoquinone, since an analogous reaction of the latter provides a product of undetermined structure (unpublished result). As shown previously, phenols and hydro-quinones, implicated as intermediates in the reduction of quinones by HI, can also be smoothly deoxygenated to fully aromatic polycyclic arenes under conditions similar to those described herein. [Pg.167]

Another important synthetic method for the reduction of ketones and aldehydes to the corresponding methylene compounds is the Woljf-Kishner reduction. This reaction is carried out under basic conditions, and therefore can be applied for the reduction of acid-sensitive substrates it can thus be regarded as a complementary method. The experimental procedure for the Clemmensen reduction is simpler however for starting materials of high molecular weight the Wolff-Kishner reduction is more successful. [Pg.63]

For the formation of oxepincarbaldehydes by oxidation of the corresponding alcohols, see Section A.3.1.1.1. and Houben-Weyl, Vol. 4/1 b, p 519 Vol.6/4, p468. For an experimental procedure for the reduction of oxepincarboxylates with lithium alanate to give the corresponding alcohols, see Houben-Weyl, Vol.6/4, p468f. [Pg.36]

In the future, further studies should be addressed to improve the chemose-lectivity and diastereoselectivity of the reductive coupling process, especially searching for novel reagents and milder experimental conditions. As a matter of fact, a few novel reductive couphng procedures which showed improved efficiency and/or stereoselectivity have not been further apphed to optically active imines. For example, a new electrochemical procedure which makes use of the spatially addressable electrolysis platform with a stainless steel cathode and a sacrificial aluminum anode has been developed for imines derived from aromatic aldehydes, and the use of the N-benzhydryl substituent allowed 1,2-diamines to be obtained with good yields and dl-to-meso ratios... [Pg.12]

Annual Volume 71 contains 30 checked and edited experimental procedures that illustrate important new synthetic methods or describe the preparation of particularly useful chemicals. This compilation begins with procedures exemplifying three important methods for preparing enantiomerically pure substances by asymmetric catalysis. The preparation of (R)-(-)-METHYL 3-HYDROXYBUTANOATE details the convenient preparation of a BINAP-ruthenium catalyst that is broadly useful for the asymmetric reduction of p-ketoesters. Catalysis of the carbonyl ene reaction by a chiral Lewis acid, in this case a binapthol-derived titanium catalyst, is illustrated in the preparation of METHYL (2R)-2-HYDROXY-4-PHENYL-4-PENTENOATE. The enantiomerically pure diamines, (1 R,2R)-(+)- AND (1S,2S)-(-)-1,2-DIPHENYL-1,2-ETHYLENEDIAMINE, are useful for a variety of asymmetric transformations hydrogenations, Michael additions, osmylations, epoxidations, allylations, aldol condensations and Diels-Alder reactions. Promotion of the Diels-Alder reaction with a diaminoalane derived from the (S,S)-diamine is demonstrated in the synthesis of (1S,endo)-3-(BICYCLO[2.2.1]HEPT-5-EN-2-YLCARBONYL)-2-OXAZOLIDINONE. [Pg.266]

In Figures 8 and 9 are shown the data for the dependence of the characteristic film buildup time t on Apg and U. In accord with the model, t is found to be independent of U, with only a very weak dependence on Apg indicated. This latter result could in part be a function of experimental inaccuracy. The data reduction for t introduces no assumptions beyond that needed to draw the exponential flux decline curves such as those shown in Figures 2 and 3. However, an error analysis shows that the maximum errors relative to the exponential curve fits occur at the earlier times of the experiment. This is seen in the typical error curve plotted in Figure 10. The error analysis indicates that during the early fouling stage the relatively crude experimental procedure used is not sufficiently accurate or possibly that the assumed flux decline behavior is not exponential at the early times. In any case, it follows that the accuracy of the determination of 6f is greater than that for t. [Pg.139]

This book encompasses indiscriminately all the types of reductions and superimposes them over a matrix of types of compounds to be reduced. The manner of arrangement of the compounds is a somewhat modified Beilstein system and is explained in the introduction. Numerous tables summarize reducing agents and correlate them with the starting compounds and products of the reductions. Reaction conditions and yields of reductions are mentioned briefly in the text and demonstrated in 175 examples of reductions of simple types of compounds and in 50 experimental procedures. [Pg.319]

The facile reduction of amides by borane[67 69 was used for the reduction of the carbonyl group of the peptide bond.159 This reduction procedure is compatible with Boc, Z, OMe, and OBzl protecting groups. Generally, yields are relatively low. The following experimental procedure describing a dipeptide reduction, is the one which produces the best results/57 ... [Pg.411]

The experimental procedures given below for the synthesis of both enantiomers of 4-substituted butenolides [390] emphasize some aspects of the reactivity of chiral 0-ketosulfoxides their reduction with hydrides can... [Pg.176]

The p-sulfanyl amides 28 are synthesized from N-protected amino acids 24 via amino alcohols 25, which are converted into (5-acetylsulfanyl amides 26 by a Mitsunobu reaction. The (5-amine disulfide 27 is subsequently coupled with a variety of carboxylic acids, followed by reduction with tributylphosphine in aqueous THF in the presence of pyridine to produce the free thiol 28 (Scheme 5).1211 Detailed experimental procedures for these compounds have not been reported. [Pg.313]

The reduction is usually effected catalytically in ethanol solution using hydrogen under pressure in the presence of Raney nickel. As in the reduction of nitriles (Section 5.16.1, p. 771), which also involves the intermediate imine, ammonia or the amines should be present in considerable excess to minimise the occurrence of undesirable side reactions leading to the formation of secondary and tertiary amines. These arise from the further reaction of the carbonyl compound with the initially formed amine product. Selected experimental conditions for these reductive alkylation procedures have been well reviewed.210 Sodium borohydride has also been used as an in situ reducing agent and is particularly effective with mixtures of primary amines and aliphatic aldehydes and ketones.211... [Pg.777]

The use of iron and a little hydrochloric acid (or alternatively of iron and acetic acid) is to be preferred when the use of the more strongly acidic medium leads to the formation of undesirable by-products nuclear chlorination, for example, often results when tin or zinc is used in association with concentrated hydrochloric acid. A suitable experimental procedure for the reduction of 2,4-dinitrotoluene to 2,4-diaminotoluene has been described.23... [Pg.891]

Experimental procedures are given in Expt 6.107 for o- and p-hydroxy-propiophenones (R = Et). The ortho-para ratio in the product is influenced by the nature of the alkyl residue, the temperature, the solvent and the amount of aluminium chloride used generally low temperatures favour the formation of p-hydroxyketones. It is usually possible to separate the two hydroxyketones by fractional distillation under reduced pressure through an efficient fractionating column or by steam distillation the ortho isomers, being chelated, are more steam volatile. It may be mentioned that Clemmensen reduction (cf. Sections 5.1.3, p. 476 and 6.1.1, p. 826) of the hydroxyketones affords an excellent route to alkyl phenols. [Pg.977]


See other pages where Reduction Experimental Procedure is mentioned: [Pg.65]    [Pg.266]    [Pg.278]    [Pg.224]    [Pg.32]    [Pg.217]    [Pg.257]    [Pg.334]    [Pg.143]    [Pg.125]    [Pg.71]    [Pg.4]    [Pg.125]    [Pg.128]    [Pg.80]    [Pg.135]    [Pg.99]    [Pg.464]    [Pg.2]    [Pg.304]    [Pg.656]    [Pg.304]    [Pg.355]    [Pg.159]    [Pg.278]    [Pg.141]    [Pg.147]    [Pg.151]    [Pg.1227]   
See also in sourсe #XX -- [ Pg.278 ]




SEARCH



Birch reduction experimental procedures

Experimental Procedures and Data Reduction

Experimental procedure reduction-precipitation

Experimental procedures

Reduction experimental

Reductive Experimental Procedure

Reductive Experimental Procedure

© 2024 chempedia.info