Palladium pyridines

A similar borderline system, fran -bis[2-(2-chloroethyl)pyridine]palladium chloride (1), has been prepared and structurally characterized by X-ray spectroscopy and computational study.2 A study on the elimination reaction of (1) induced by quinuclidine in acetonitrile has been performed (Scheme 1). The results suggest that the initial product of elimination is a palladium complex of vinylpyridine and that displacement from this complex is partially rate determining in the formation of the uncoordinated product. Despite experimental efforts, it was not possible to distinguish between two possible mechanisms, E2 concerted or ElcB. 

Nitrogen nucleophiles, in a similar manner to oxygen- and sulfur-based functionality, undergo transition metal-catalyzed cross-coupling with halopyridines. The use of palladium(O) catalysts is most effective in combination with chelating bis-(phosphine) ligands such as BINAP that prevent the formation of pyridine-palladium complexes that... 

Bromo- and 2-chloropyridines can be made extremely efficiently by reaction with the halogen, at 0-5°C in the presence of the pyridine-palladium chloride complex. ... 

These results strongly suggest that pyridine acts as a suitable ligand for an active palladium intermediate. In the absence of pyridine, palladium selenide [Pd(SePh)2] molecules, a key species for this hydroselenation of alkynes, easily react with each other by the coordination of the selenide ligand to the other palladium center to form polymerized complex, which is insoluble in usual organic solvent and loses the catalytic activity. Therefore, pyridine is considered to inhibit the polymerization and protect the catalyst from the poisoning [23]. 

A cousin to this reduction is one using stannous chloride (a.k.a. SnCb, a.k.a. Tin chloride) which is done exactly as the calcium one except that about lOOg of SnCb is used in place of the Mg or Ca and the addition occurs at room temperature and the solution is stirred for one hour rather than 15 minutes. Some very good reductions that operate almost exclusively at room temperature with no pressure and give almost 100% yields are to follow. The only reason Strike did not detail these methods is that some of the chemicals involved are a little less common than Strike is used to but all are available to the public. These alternatives include acetlylacetone and triethylamine [73], propanedithlol and trieth-ylamine [74], triphenylphosphine [75], NaBH4 with phase transfer catalyst [76], H2S and pyridine [77], and palladium hydrox-ide/carbon with hydrazine [78], stannous chloride dihydrate [85]. 

CO, and methanol react in the first step in the presence of cobalt carbonyl catalyst and pyridine [110-86-1] to produce methyl pentenoates. A similar second step, but at lower pressure and higher temperature with rhodium catalyst, produces dimethyl adipate [627-93-0]. This is then hydrolyzed to give adipic acid and methanol (135), which is recovered for recycle. Many variations to this basic process exist. Examples are ARCO s palladium/copper-catalyzed oxycarbonylation process (136—138), and Monsanto s palladium and quinone [106-51-4] process, which uses oxygen to reoxidize the by-product... 

Reduction of isoindoles with dissolving metals or catalytically occurs in the pyrrole ring. Reduction of indolizine with hydrogen and a platinum catalyst gives an octahydro derivative. With a palladium catalyst in neutral solution, reduction occurs in the pyridine ring but in the presence of acid, reduction occurs in the five-membered ring (Scheme 38). Reductive metallation of 1,3-diphenylisobenzofuran results in stereoselective formation of the cw-1,3-dihydro derivative (Scheme 39) (80JOC3982). 

As foretold in the introduction, ring formation via attack on a double bond in the endo-trig mode is not well exemplified. The palladium(II) catalyzed oxidative cyclization of o-aminostyrenes to indoles has been described (78JA5800). The treatment of o-methyl-selenocinnamates with bromine in pyridine gives excellent yields of benzoselenophene-2-carboxylates (Scheme 10a) (77BSF157). The base promoted conversion of dienoic thioamides to 2-aminothiophenes is another synthetically useful example of this type (Scheme 10b) (73RTC1331). 

The 5a-isomer is obtained from hydrogenation of A -7-keto steroids over platinum or palladium. In the latter case the addition of pyridine to the reaction mixture greatly increases the amount of 5a- product formedd a Attack also takes place on hydrogenation (deuteration or tritiation )... 

A solution of 0.3 of 3j9-acetoxy-21-ethoxy-17a-pregn-5-en-20-yn-17/3-ol in 7 ml of pure pyridine is hydrogenated over 90 mg of 2.5% palladium-on-calcium carbonate at room temperature and atmospheric pressure. The reaction mixture is filtered and evaporated and the residue recrystallized to give 80 % of the 17a-vinyl product. 

The intermediacy of dipolar species such as 186 has been demonstrated by reaction of enamines with 2-hydroxy-1-aldehydes of the aromatic series (129). The enamine (113) reacts in benzene solution at room temperature with 2-hydroxy-1-naphthaldehyde to give the crystalline adduct (188) in 91 % yield. Oxidation with chromium trioxide-pyridine of 188 gave 189 with p elimination of the morpholine moiety. Palladium on charcoal dehydrogenation of 189 gave the known 1,2-benzoxanthone (129). 

The Boekelheide reaction has been applied to the synthesis of non-natural products with the preparation of quaterpyridines serving as an example. The sequence began with the 2,4-linked bipyridyl-N-oxide 25. Execution under the typical reaction conditions produced the expected bis-pyridone 26. Treatment with POCI3 afforded the corresponding dichloride that was submitted to a palladium-catalyzed coupling with 2-stannyl pyridine to produce the desired quaterpyridine 27. 

A number of di- and tri-(3-A-morpholinopropyn-l-yl)-l-methylpyrazoles were prepared by the condensation of corresponding iodopyrazoles with 4-prop-2-ynylmorpholine in presence of Cu(0), K2CO3 in boiling pyridine, but without palladium catalyst. Despite the low activity of this catalytic system and the long condensation time (75-95 h) the yield of 3,4-di-, 4,5-di-, and 3,4,5-tri-(3-A-morpholinopropyn-l-yl)-l-methylpyrazoles reached 70-80% (Schemes 42 and43). 

Rapoport s findings have been confirmed in the authors laboratory where the actions of carbon-supported catalysts (5% metal) derived from ruthenium, rhodium, palladium, osmium, iridium, and platinum, on pyridine, have been examined. At atmospheric pressure, at the boiling point of pyridine, and at a pyridine-to-catalyst ratio of 8 1, only palladium was active in bringing about the formation of 2,2 -bipyridine. It w as also found that different preparations of palladium-on-carbon varied widely in efficiency (yield 0.05-0.39 gm of 2,2 -bipyridine per gram of catalyst), but the factors responsible for this variation are not knowm. Palladium-on-alumina was found to be inferior to the carbon-supported preparations and gave only traces of bipyridine,... 

Reaction of -picoline with a nickel-alumina catalyst has been reported to give a mixture of four isomeric dimethylbipyridines, one of which has been identified at 6,6 -dimethyl-2,2 -bipyridine. With palladium-on-carbon, 2,4-lutidine was found to be more reactive than pyridine,and the isolated biaryl has been assigned the structure (2). However, some confusion arises from the statement that this... 

Rhodium-on-carbon has also been found to bring about the formation of 2,2 -biquinoline from quinoline, the yield and the percentage conversion being similar to that obtained with palladium-on-carbon. On the other hand, rhodium-on-carbon failed to produce 2,2 -bipyridine from pyridine, and it has not yet been tried with other bases. Experiments with carbon-supported catalysts prepared from ruthenium, osmium, iridium, and platinum have shown that none of these metals is capable of bringing about the formation of 2,2 -biquinoline from quinoline under the conditions used with palladium and rhodium. ... 

Several products other than 2,2 -biaryls have been isolated following reaction of pyridines with metal catalysts. From the reaction of a-picoline with nickel-alumina, Willink and Wibaut isolated three dimethylbipyridines in addition to the 6,6 -dimethyl-2,2 -bipyridine but their structures have not been elucidated. From the reaction of quinaldine with palladium-on-carbon, Rapoport and his co-workers " obtained a by-product which they regarded as l,2-di(2-quinolyl)-ethane. From the reactions of pyridines and quinolines with degassed Raney nickel several different types of by-product have been identified. The structures and modes of formation of these compounds are of interest as they lead to a better insight into the processes occurring when pyridines interact with metal catalysts. 

Methylphenyl)benzothiazole (80IC762) and 2-benzylbenzothiazole (95ICA(239)125) can be cyclopalladated. In the latter case, cylopalladation occurs upon reaction with palladium(II) acetate and gives the product 80. With lithium chloride, sodium bromide, or sodium iodide, a series of three products of substitution of the acetate group 81 (X = C1, Br, I) results. Pyridine, 2- and 3-methylpyridine, 2,6- and 3,5-dimethylpyridine cause the transformation of the chelate complexes 81 (X = C1, Br, I) and formation of the mononuclear products 82 (R = z= R" = = R = H, X = Cl, Br, I ... 

In the first chapter, N. M. Ahmad and J. J. Li (Pfizer, Ann Arbor, USA) discuss the use of palladium in quinoline synthesis, thus filling an important gap in a recent monograph on the uses of palladium catalysis in heterocyclic synthesis authored by the same group. This is followed by an account of pyrimidine-pyridine interconversions by H. C. van der Plas (Wageningen University, The Netherlands) the immense variety of heterocyclic chemistry is illustrated by the large number of diverse strategies for such transformations. 

Choice of catalyst and solvent allowed considerable flexibility in hydrogenation of 8. With calcium carbonate in ethanol-pyridine, the sole product was the trans isomer 9, but with barium sulfate in pure pyridine the reaction came to a virtual halt after absorption of 2 equiv of hydrogen and traws-2-[6-cyanohex-2(Z)-enyl]-3-(methoxycarbonyl)cyclopentanone (7) was obtained in 90% yield together with 10% of the dihydro compound. When palladium-on-carbon was used in ethyl acetate, a 1 1 mixture of cis and trans 9 was obtained on exhaustive hydrogenation (S6). It is noteworthy that in preparation of 7 debenzylation took precedence over double-bond saturation. 

Reductive alkylation by alcohol solvents may occur as an unwanted side reaction 22,39), and it is to avoid this reaction that Freifelder (20) recom mends ruthenium instead of nickel in pyridine hydrogenation. Alkylation by alcohols may occur with surprising ease 67). Reduction of 18 in ethanol over 10% palladium-on carbon to an amino acid, followed bycyclization with /V,/V-dicyclohexylcarbodiimide gave a mixture of 19 and 20 wiih the major product being the /V-ethyl derivative 49,50). By carrying out the reduction in acetic acid, 20 was obtained as the sole cyclized product 40). 

---