Pyridazine acids

Some of these compounds are used as potential intermediates for the preparation of 4,7-dioxo-4,5,6,7-tetrahydrothiazolo[4,5d]pyridazines (78). The diesters (77) are hydrolyzed under appropriate conditions to free acids (79), whose monopotassium salts (80) yield the cyclic anhydrides (81) under the influence of thionylchloride. Pyrolysis of 79, Rj = a-thienyl, results in its decarboxylation to 82. 

Pyridazines with a hydroxy group at an a- or y-position to a ring nitrogen atom, i.e. 3-and 4-hydroxypyridazines (4) and (5), exist predominantly in the oxo form. This conclusion is based on spectroscopic evidence from UV spectra of unsubstituted compounds and their A-methyl and O-methyl derivatives in alkaline, neutral and acidic solutions. In some instances, as for example for 6-oxo-l,6-dihydropyridazine-3-carboxamide, there is also evidence from X-ray analysis <54AX199, 63AX318). Maleic hydrazide and substituted maleic hydrazides exist in the monohydroxymonooxo form (6). 

The ESR spectrum of the pyridazine radical anion, generated by the action of sodium or potassium, has been reported, and oxidation of 6-hydroxypyridazin-3(2//)-one with cerium(IV) sulfate in sulfuric acid results in an intense ESR spectrum (79TL2821). The self-diffusion coefficient and activation energy, the half-wave potential (-2.16 eV) magnetic susceptibility and room temperature fluorescence in-solution (Amax = 23 800cm life time 2.6 X 10 s) are reported. 

Direct oxidation of pyridazine and its derivatives with hydrogen peroxide (50-90%) in acetic acid gives, besides the isomeric mono 1- and 2-oxides, also the corresponding... 

The second most important nucleophilic substitution in pyridazine A-oxides is the replacement of a nitro group. Nitro groups at the 3-, 4-, 5- and 6-position are easily substituted thermally with a chlorine or bromine atom, using acetyl chloride or hydrobromic acid respectively. Phosphorus oxychloride and benzoyl chloride are used less frequently for this purpose. Nitro groups in nitropyridazine A-oxides are easily replaced by alkoxide. The... 

When 6-amino-3-chloropyridazine 1-oxide is diazotized in 50% sulfuric acid, 6-hydroxy-3-pyridazinediazonium anhydro salt is formed. An azido group at either position in pyridazine A-oxides can readily be replaced with sodium alkoxides. 

In some instances a carbon-carbon bond can be formed with C-nucleophiles. For example, 3-carboxamido-6-methylpyridazine is produced from 3-iodo-6-methylpyridazine by treatment with potassium cyanide in aqueous ethanol and l,3-dimethyl-6-oxo-l,6-dihydro-pyridazine-4-carboxylic acid from 4-chloro-l,3-dimethylpyridazin-6-(lH)-one by reaction with a mixture of cuprous chloride and potassium cyanide. Chloro-substituted pyridazines react with Grignard reagents. For example, 3,4,6-trichloropyridazine reacts with f-butyl-magnesium chloride to give 4-t-butyl-3,5,6-trichloro-l,4-dihydropyridazine (120) and 4,5-di-t-butyl-3,6-dichloro-l,4-dihydropyridazine (121) and both are converted into 4-t-butyl-3,6-dichloropyridazine (122 Scheme 38). 

Since the pyridazine ring is generally more stable to oxidation than a benzene ring, oxidation of alkyl and aryl substituted cinnolines and phthalazines can be used for the preparation of pyridazinedicarboxylic acids. For example, oxidation of 4-phenylcinnoline with potassium permanganate yields 5-phenylpyridazine-3,4-dicarboxylic acid, while alkyl substituted phthalazines give pyridazine-4,5-dicarboxylic acids under essentially the same reaction conditions. 

Pyridazine aldehydes and ketones with the carbonyl group at the ring or in a side chain react in the usual manner. They form hydrazones, semicarbazides, oximes, etc. Side-chain aldehydes can be easily oxidized to pyridazinecarboxylic acids with silver nitrate and side-chain ketones are oxidized to carboxylic acids by treatment with potassium permanganate or hydrogen peroxide. 

Pyridazinecarboxylic acids are more acidic than benzoic acids, due to the electronegativity of the pyridazine ring, but oxopyridazinecarboxylic acids are weaker than the corresponding pyridazinecarboxylic acids (Table 11). 

Practically all pyridazine-carboxylic and -polycarboxylic acids undergo decarboxylation when heated above 200 °C. As the corresponding products are usually isolated in high yields, decarboxylation is frequently used as the best synthetic route for many pyridazine and pyridazinone derivatives. For example, pyridazine-3-carboxylic acid eliminates carbon dioxide when heated at reduced pressure to give pyridazine in almost quantitative yield, but pyridazine is obtained in poor yield from pyridazine-4-carboxylic acid. Decarboxylation is usually carried out in acid solution, or by heating dry silver salts, while organic bases such as aniline, dimethylaniline and quinoline are used as catalysts for monodecarboxylation of pyridazine-4,5-dicarboxylic acids. 

Some 4,5-disubstituted pyridazines exhibit ring-chain isomerism involving heterospiro compounds. For example, 5-(o-aminophenylcarbamoyl)pyridazine-4-carboxylic acid exists in a zwitterionic form in the solid state, but in a solution of DMSO it is almost exclusively 3, 4 -dihydro-3 -oxospiro[pyridazine-5(2//),2 (l //)-quinoxaline]-4-carboxylic acid (134). The equilibrium is strongly influenced by the nature of the solvent, the substituents on the pyridazine ring and the nucleophilicity of the group attached to the phenyl ring (Scheme 48) <80JCS(P2)1339). 

Pyridazinecarbohydrazides are prepared in the normal way from an ester or acid chloride and hydrazine or a substituted hydrazine, generally in good yields. Pyridazines with two ortho alkoxycarbonyl groups give cyclic hydrazides with hydrazine, which are pyridazinopyridazines. 

Amino-6-chloro-4-methyl- and 3-amino-6-chloro-5-methyl-pyridazine and 3-amino-6-methylpyridazin-4(l//)-one are transformed with sodium nitrite in the presence of acid into the corresponding oxo compounds. If concentrated hydrochloric acid is used, in some instances the corresponding chloro derivatives are obtained as side products. On the other hand, 3-, 4-, 5- and 6-aminopyridazine 1-oxides and derivatives are transformed into stable diazonium salts, which can easily be converted into the corresponding halo derivatives. In this way 3-, 4-, 5- and 6-bromopyridazine 1-oxides, 5-chloropyridazine 1-oxide, 3,4,5-trichloropyridazine 1-oxide and 6-chloropyridazine 1-oxide can be obtained. 

Pyridazines with an appropriate side chain attached to the sulfur atom at position 3 can be transformed into bicyclic systems. For example, pyridazinyl /3-ketoalkyl sulfides are cyclodehydrated in sulfuric acid to give thiazolopyridazinium salts, and 3-carboxymethyl-thiopyridazines are transformed by acetic anhydride in pyridine into 3-hydroxythiazolo[3,2-6]pyridazinium anhydro salts (Scheme 52). 

With the saturated analogs, i.e. succinic anhydride and its derivatives, pyridazines are formed in only a few cases. The reaction has been applied to the preparation of perhydro-pyridazines and their 3,6-diones (68MI21200, 70JOC1468). For the synthesis of 4,5-dihalopyridazinones, /3-formylacrylic acids, for example mucochloric acid, are useful syn-thons (Scheme 80). 

This synthetic appproach has been used in a few cases for the preparation of pyridazines from diazo compounds and cyclopropenes. In general, cycloadducts (176) are formed first and these rearrange in the presence of acid or alkali to pyridazines (Scheme 98) (69TL2659, 76H(5)40l). Tetrachlorocyclopropene reacts similarly and it was found that the stability of the bicyclic intermediates is mainly dependent on substitution (78JCR(S)40, 78JCR(M)0582>. 

Pyridazines are formed from pyrones or their thioxo analogs or from appropriate pyridones. Pyrones or pyridones react with diazonium salts to give the corresponding hydrazones (187) and (188) which are rearranged under the influence of acid or base into pyridazinones as shown in Scheme 107. On the other hand, kojic acid is transformed with hydrazine into a 1,4-dihydropyridazine and a pyrazole derivative. 4H-Pyran-4-thiones... 

Hydroxyphthalazin-l(2//)-one is obtained in a smooth reaction between phthalic anhydride and hydrazine hydrate and this is again the starting compound for many 1-substituted and/or 1,4-disubstituted phthalazines. The transformations of 1,4-dichloro-phthalazine, which is prepared in the usual manner, follow a similar pattern as shown for pyridazines in Scheme 110. On the other hand, phthalonitrile is the preferential starting compound for amino- and hydrazino-phthalazines. The most satisfactory synthesis of phthalazine is the reaction between a,a,a, a -tetrachloro-o-xylene and hydrazine sulfate in sulfuric acid (67FRP1438827), alt iough catalytic dehalogenation of 1-chloro- or 1,4-dichloro-phthalazine or oxidation of 1-hydrazinophthalazine also provides the parent compound in moderate yield. 

The cleavage of fused pyrazines represents an important method of synthesis of substituted pyrazines, particularly pyrazinecarboxylic acids. Pyrazine-2,3-dicarboxylic acid is usually prepared by the permanganate oxidation of either quinoxalines or phenazines. The pyrazine ring resembles the pyridine ring in its stability rather than the other diazines, pyridazine and pyrimidine. Fused systems such as pteridines may easily be converted under either acidic or basic conditions into pyrazine derivatives (Scheme 75). 

---