Prescribing purpose

This section contains a discussion of some of the products produced from plants. Some of these materials are not species-specific, and are produced from whatever plants are available and suitable for the prescribed purpose. 

The purpose of the nondestructive control consists in detecting local modifications of the material parameters which, by their presence can endanger the quality of the half-finished or finished products. The electromagnetic nondestructive control permits to render evident surface and subsurface discontinuities in the electroconductive material under test. The present tendency of this control is to pass from a qualitative evaluation (the presence or absence of the material discontinuities which give at the output of the control equipment a signal higher or at least equal to that coming from a standard discontinuity whose shape and severity has been prescribed by the product standards) to a quantitative one, which enables to locate as exactly as possible the discontinuity and to make predictions over its shape and severity. 

For qualitative purposes the circle itself isn t even necessary We could locate the Huckel MOs by simply working with the polygons themselves The circle is needed only when Frost s method is used quantitatively In those cases the radius of the circle has a prescribed value allowing each MO to be assigned a specific energy... 

For shaft heights 56 mm and above, ISO 2373 (lEC 60034-14) has prescribed three categories of vibration levels in terms of vibration velocity, one for normal use, N, and the other two for precision applications, i.e. reduced level R and special-purpose S. When required other than normal, these must be specified by the user to the manufacturer. Machines with a higher degree of balance should be used only when this is essential. Such machines may be far too expensive to produce, and sometimes not commensurate with the application. 

Root cause 1 Procedures for shift changeover were inconvenient for use. The prescribed changeover procedure was detailed and elaborate, so it was not used in practice, being seen as too inconvenient for practical purposes. Consequently, one important aspect was omitted. Supervisors are supposed to go through the work permit book at each shift changeover. This was not done. 

The isoprene-derived molecule whose structure is shown here is known alternately as Coumarin and warfarin. By the former name, it is a widely prescribed anticoagulant. By the latter name, it is a component of rodent poisons. How can the same chemical species be used for such disparate purposes The key to both uses lies in its ability to act as an antagonist of vitamin K in the body. 

However, the chief purpose of introduction of fillers into PCM is to make possible the modification of polymers and thereby create materials with a prescribed set of physico-mechanical properties, and, obviously, the properties of filled materials may be controlled by, for example, varying the type of the base polymer (the matrix ) and filler, its particle size distribution and shape. It may not require a large quantity of filler [7]. Thanks to considerable advances in PCM research, their use in a broad range of industries — machine building, construction, aerospace technology, etc. — has become extensive [8 — 11]. 

When developing a teaching plan for the patient and family, tlie nurse emphasizes the importance of uninterrupted drug therapy. The nurse allows the patient and family time to ask questions. The nurse explores any problems that appear to be associated with tlie prescribed drug regimen and then reports them to tlie primary health care provider. The nurse reviews tlie purpose of tlie drug therapy with tlie patient and family, as well as the adverse reactions that may occur. 

PRESCRIBED DISEASE A discasc prescribed for the purpose of payment of disablement benefit under the Social Security Act 1975 and the Social Security (Industrial Injuries) (Prescribed Diseases) Regulations 1985 and subsequent amendments. (Conditions due to physical agents, biological agents and miscellaneous conditions are classified in addition to conditions due to chemical... 

The guiding principles in test plot maintenance are to (1) minimize soil surface disturbance at all times, (2) ensure that control and treated plots are similarly maintained, (3) avoid applying other agrochemicals that may interfere with sample analysis or that are otherwise contrary to the purpose of the study, (4) follow the prescribed irrigation policy determined for the study site, and (5) keep bare-soil test plots free of vegetation, as follows. 

Control urine should be collected from individuals who have no apparent past history of exposure to the active ingredient. This control urine must be stored frozen until used for field fortification purposes. The urine is then thawed, shaken well, and a certain amount should be aliquoted into a small jar/bottle to use for field fortification. The active ingredient is then added to the urine using a 1-mL volumetric pipet, the solution is shaken well, and the sample is immediately frozen. Occasionally, the fortified sample can be left at room temperature or at some lower temperature in a liquid state to simulate field storage during collection of the urine sample. After leaving the sample at such temperatures for the prescribed length of time, the sample is immediately stored frozen. 

Co-payment is an instrument that should not be used on its own. Neither efficiency in drag use nor equity nor the control of pharmaceutical expenditure can rest solely on co-payment. Its effectiveness is reinforced when it is combined with other instruments and incentives. In fact, all European countries combine, in different doses and proportions, multiple instruments that influence the behaviour of the industry, prescribes and patients. It is sufficient to recall that pharmaceutical expenditure is the product of price by quantity, and to consider the enormous international variability of drag prices,35 in order to understand the limitations of co-payment regulation in comparison with other policies that influence prices. Policies aimed at price control can be as effective as co-payment - or more so - for purposes of cost containment. 

For the purpose of analysing incentives of a financial nature in a European context, it is advisable to attach more emphasis to the formula of budgets than to the various physician payment mechanisms. From our point of view, these mechanisms are taken into account indirectly as regards the impact that the articulation of budgets might have on prescriber fees (as in the German case). There are two reasons for this approach first, in most of Europe s public health systems the salary is the predominant form of payment for physicians,... 

The third invention reported by the authors [19] was related to sulfur oxidation, but the invention was not patented. It was only registered with the Statutory Invention Registration (SIR). What this means is that, it is not a utility patent as the rest of the documents considered in this Chapter, rather a SIR registered document containing the specification and drawings of a provisional application filed for a patent, which has not been subjected to examination yet. It is issued by the PTO, if the applicant, among other requirements, waives the right to receive a patent on the invention within such period as may be prescribed by the Commissioner. The invention such as this, on which a statutory invention certificate is published, is not a patented invention for most purposes. 

Because of aging, it is necessary to specify an age for reference measurements at which the capacitance shall be within the prescribed tolerance. This is traditionally fixed at 1000 hours, since for practical purposes there is not much further loss of capacitance after this time. 

---