Polymeric surfactants critical micelle concentration

As an even more explicit example of this effect Figure 6 shows that EPM is able to reproduce fairly well the experimentally observed dependence of the particle number on surfactant concentration for a different monomer, namely methyl methacrylate (MMA). The polymerization was carried at 80°C at a fixed concentration of ammonium persulfate initiator (0.00635 mol dm 3). Because methyl methacrylate is much more water soluble than styrene, the drop off in particle number is not as steep around the critical micelle concentration (22.) In this instance the experimental data do show a leveling off of the particle number at high and low surfactant concentrations as expected from the theory of particle formation by coagulative nucleation of precursor particles formed by homogeneous nucleation, which has been incorporated into EPM. 

Oheme and co-workers investigated335 in an aqueous micellar system the asymmetric hydrogenation of a-amino acid precursors using optically active rhodium-phosphine complexes. Surfactants of different types significantly enhance both activity and enantioselectivity provided that the concentration of the surfactants is above the critical micelle concentration. The application of amphiphilized polymers and polymerized micelles as surfactants facilitates the phase separation after the reaction. Table 2 shows selected hydrogenation results with and without amphiphiles and with amphiphilized polymers for the reaction in Scheme 61.335... 

Silicone surfactants in aqueous solutions show the same general behavior as conventional hydrocarbon surfactants - the surface tension decreases with increasing concentration until a densely packed film is formed at the surface. Above this concentration, the surface tension becomes constant. The concentration at the transition is called the critical micelle concentration (CMC) or critical aggregation concentration (CAC). The surface and interfacial activity of silicone surfactants was reviewed by Hoffmann and Ulbricht [27]. Useful discussions of the dependence of the surface activity of polymeric silicone surfactants on molecular weight and structure are given by Vick [28] and for the trisiloxane surfactants by Gentle and Snow [29]. 

The key feature of Inisurfs is their surfactant behavior. They form micelles and are adsorbed at interfaces, and as such they are characterized by a critical micelle concentration (CMC) and an area/molecule in the adsorbed state. This influences both the decomposition behavior and the radical efficiency, which are much lower than those for conventional, low molecular weight initiators. Tauer and Kosmella [4] have observed that in the emulsion polymerization of styrene, using an Inisurf concentration above the CMC resulted in an increase in the rate constant of the production of free radicals. This was attributed to micellar catalysis effects as described, for example, by Rieger [5]. Conversely, if the Inisurf concentration was below the CMC the rate constant of the production of free radicals decreased with an increase in the Inisurf concentration, which was attributed to enhanced radical recombination. Also note that a similar effect of the dependence of initiator efficiency on concentration was reported by Van Hook and Tobolsky for azobisisobutyronitrile (AIBN) [6]. 

If surfactant is added to a suspension polymerization system, a number of phenomena may occur. If the surfactant is added in small amounts (below the critical micelle concentration or CMC), the reduction in interfacial tension between the organic and aqueous phases will result in smaller monomer droplets, but it has hardly any other effect. If surfactant is added above the CMC, and an oil-soluble initiator is used, the process is commonly termed a microsuspension polymerization. Due to the reduced interfacial tension, the droplet diameter (and hence bead diameter) is reduced to approximately 10-40 pm. Little polymerization takes place in the aqueous phase or in particles generated from surfactant micelles because of the hydrophobic nature of the initiator. However, some smaller particles initiated from surfactant micelles may be found. The kinetics are still essentially those of a bulk free radical polymerization. Microsuspension polymerization is used to produce pressure-sensitive adhesives for repositionable notes. 

Schick and Fowkes (11) studied the effect of alkyl chain length of surfactants on critical micelle concentration (CMC). The maximum lowering of CMC occurred when both the anionic and nonionic surfactants had the same chain length. It was also reported that the coefficient of friction between polymeric surfaces reaches a minimum as the chain length of paraffinic oils approached that of stearic acid (12). In order to delineate the effect of chain length of fatty acids on lubrication, the scuff load was measured by Cameron and Crouch (13). The maximum scuff load was observed when both hydrocarbon oil and fatty acid had the same chain length. Similar results of the effect of chain length compatibility on dielectric absorption, surface viscosity and rust prevention have been reported in the literature (14-16). 

At surfactant concentrations above the equivalent point (>5 x 10 4 mol dm 3) the A curves in the presence of the polyion resemble the behavior of the curve in pine surfactant solutions. They show a break at the so-called apparent critical micellization concentration, cmc [16,42], This term is usually used for characterizing the formation of free surfactant micelles in the presence of the polymeric component. The cmc is higher than the ordinary cmc due to the formation of polyelectrolyte-surfactant complex at lower surfactant concentrations. The bound surfactant ions are not available for... 

The behavior of the surfactant molecules in an emulsion polymerization is complex. The adsorption of the surfactant on the rapidly and continually growing surface of the monomer-swollen latex particles reduces their concentration in the aqueous phase, and also upsets the balance in equilibrium between the dissolved surfactant and the surfactant present in the inactivated micelles (those in which polymerization is not occurring), as shown in Figure 5.11. The point is quickly reached at which the surfactant concentration in the solution falls below its critical micelle concentration, CMC. When this occurs, the inactive micelles become unstable and disintegrate to restore the balance. In time all of the micelles disappear and the monomer droplets shrink in size. After a conversion of 10-20%... 

Typical polymeric pseudostationary phases include micelle polymers, polymeric surfactants, water-soluble anionic siloxanes and dendrimers [223-231]. Micelle polymers [e.g. poly(sodium 10-undecylenate), poly (sodium 10-undecenylsulfate), poly(sodium undeconylvalinate), etc.] are synthesized from polymerizable surfactant monomers at a concentration above their critical micelle concentration. These polymers have similar structures to micelles without the dynamic nature of the micelle structure. Polymeric surfactants are polymers with surfactant properties [e.g. acrylate copolymers, such as 2-acrylamide-2-methyl-l-propanesulfonic acid and alkyl methacrylamide, alkyl methacrylate or alkyl acrylate, poly (ally lamine)-supported phases, poly(ethyleneimine), etc]. Water-soluble anionic siloxane polymers are copolymers of alkylmethylsiloxane... 

Polymeric micelles form stable pseudostationary phases with a critical micelle concentration of virtually zero (aggregation number of 1), and are tolerant of high organic solvent concentrations in the electrolyte solution. Mass transfer kinetics are slow compared with conventional surfactant micelles, and peak distortion from mass overloading is a problem for some polymer compositions. Preliminary studies indicate that polymeric surfactants are effective pseudostationary phases in micellar electrokinetic chromatography, but only a limited number of practical applications have been demonstrated, and uptake has been slow. 

Similar non-polymeric catalysts were prepared by Tagaki et al., who owed that zwitterionic surfactants 14 possessed much eiflianced nucleophilicity toward PNPA above die critical micelle concentration 101). 

In the case of ordered mesoporous oxides, the templating relies on supramolecular arrays micellar systems formed by surfactants or block copolymers. Surfactants consist of a hydrophihc part, for example, ionic, nonionic, zwitterionic or polymeric groups, often called the head, and a hydrophobic part, the tail, for example, alkyl or polymeric chains. This amphiphiUc character enables surfactant molecules to associate in supramolecular micellar arrays. Single amphiphile molecules tend to associate into aggregates in aqueous solution due to hydrophobic effects. Above a given critical concentration of amphiphiles, called the critical micelle concentration (CMC), formation of an assembly, such as a spherical micelle, is favored. These micellar nanometric aggregates may be structured with different shapes (spherical or cylindrical micelles, layered structures, etc. Fig. 9.8 Reference 70). The formation of micelles. 

---