Poly , syndiotactic methacrylate

Figure 7.10 shows the 60-MHz spectra of poly (methyl methacrylate) prepared with different catalysts so that predominately isotactic, syndiotactic, and atactic products are formed. The three spectra in Fig. 7.10 are identified in terms of this predominant character. It is apparent that the spectra are quite different, especially in the range of 5 values between about 1 and 2 ppm. Since the atactic polymer has the least regular structure, we concentrate on the other two to make the assignment of the spectral features to the various protons. 

Figure 7.11 Methylene proton portion of the 220-MHz NMR spectrum of poly(methyl methacrylate) (a) predominately syndiotactic and (b) predominately isotactic. [From F. A. Bovey, High Resolution NMR of Macro molecules, Academic, New York, 1972, used with permission.]...

Unlike most crystalline polymers, PVDF exhibits thermodynamic compatibiUty with other polymers (133). Blends of PVDF and poly(methyl methacrylate) (PMMA) are compatible over a wide range of blend composition (134,135). SoHd-state nmr studies showed that isotactic PMMA is more miscible with PVDF than atactic and syndiotactic PMMA (136). MiscibiUty of PVDF and poly(alkyl acrylates) depends on a specific interaction between PVDF and oxygen within the acrylate and the effect of this interaction is diminished as the hydrocarbon content of the ester is increased (137). Strong dipolar interactions are important to achieve miscibility with poly(vinyhdene fluoride) (138). PVDF blends are the object of many papers and patents specific blends of PVDF and acryflc copolymers have seen large commercial use. 

Commercial poly(methyl methacrylate) is a transparent material, and microscopic and X-ray analyses generally indicate that the material is amorphous. For this reason the polymer was for many years considered to be what is now known as atactic in structure. It is now, however, known that the commercial material is more syndiotactic than atactic. (On one scale of assessment it might be considered about 54% syndiotactic, 37% atactic and 9% isotactic. Reduction in the temperature of free-radical polymerisation down to -78°C increases the amount of syndiotacticity to about 78%). 

The synthesis of isotactic and syndiotactic polymers has been achieved for a number of polymers. For example poly (methyl methacrylate) can be prepared in either isotactic or syndiotactic configurations depending on the details of the polymerisation conditions. 

Horinaka, J., Ono, K. and Yamamoto, M. (1995) Local chain dynamics of syndiotactic poly(methyl methacrylate) studied by the fluorescence depolarization method. Polym. J., 27, 429-435. 

Preparation of Block Copolymers. Poly(styrene-b-methyl methacrylate) and poly(styrene-b-t-butyl methacrylate) were prepared by procedures similar to those reported for poly(styrene-b-methyl methacrylate (12,13). Poly(methyl methacrylate-b-t-butyl methacrylate) was synthesized by adaptation of the method published (14) for syndiotactic poly(methyl methacrylate) polymerization of methyl methacrylate was initiated with fluorenyllithium, and prior to termination, t-butyl methacrylate was added to give the block copolymer. Pertinent analytical data are as follows. 

Crystalline samples of syndiotactic poly(methyl methacrylate) (st-PMMA) may be obtained from chloroacetone 178). This guest could be completely replaced by a variety of other guest molecules such as acetone, 1,3-dichloroacetone, bromoacetone, pinacolone, cyclohexanone, acetophenone and benzene. The X-ray diffraction patterns for these inclusion compounds were similar. These data indicate that the st-PMMA chains adopt a helical conformation of radius about 8 A and pitch 8.85 A. The guest molecules are located both inside the helical canals and in interhelix interstitial sites. 

The tacticity or distribution of asymmetric units in a polymer chain can be directly determined using NMR spectroscopy and infrared (IR) spectroscopy and has been studied for a variety of polymers. Figure 5(a) and 5(b) show the proton NMR spectra [26,27] and IR spectra [28,29], respectively, for the two stereoisomers of poly(methyl methacrylate) (PMMA), syndiotactic and isotactic PMMA. These two structures in a polymer like PMMA give rise to different signatures in both the techniques. In the case of the NMR spectra [26,27], the... 

Table 1 IR peak assignments (cm ) for isotactic and syndiotactic poly(methyl methacrylate)...

Syndiotactic and isotactic poly(methyl methacrylate) are crystalline and melt at 160 and 200 °C, respectively. 

A third factor influencing the value of Tg is backbone symmetry, which affects the shape of the potential wells for bond rotations. This effect is illustrated by the pairs of polymers polypropylene (Tg=10 C) and polyisobutylene (Tg = -70 C), and poly(vinyi chloride) (Tg=87 C) and poly(vinylidene chloride) (Tg =- 19°C). The symmetrical polymers have lower glass transition temperatures than the unsymmetrical polymers despite the extra side group, although polystyrene (100 C) and poly(a-meth-ylstyrene) are illustrative exceptions. However, tacticity plays a very important role (54) in unsymmetrical polymers. Thus syndiotactic and isoitactic poly( methyl methacrylate) have Tg values of 115 and 45 C respectively. 

The synthesis of monodisperse high molecular weight syndiotactic poly(methyl methacrylate) mentioned above was possible at a polymerization temperature as low as — 95 °C [3]. However, methods to synthesize it at a relatively high temperature or to synthesize its isotactic counterpart remain to be found. When the latter is made available, the synthesis of stereo-complexes of poly(methyl methacrylate) will become the focus of considerable interest. 

Figure 1. 40 MHz H NMR spectrum of isotactic (a) and syndiotactic (b) poly(methyl methacrylate). From ref. (54) Copyright John Wiley Sons.

The same type of addition—as shown by X-ray analysis—occurs in the cationic polymerization of alkenyl ethers R—CH=CH—OR and of 8-chlorovinyl ethers (395). However, NMR analysis showed the presence of some configurational disorder (396). The stereochemistry of acrylate polymerization, determined by the use of deuterated monomers, was found to be strongly dependent on the reaction environment and, in particular, on the solvation of the growing-chain-catalyst system at both the a and jS carbon atoms (390, 397-399). Non-solvated contact ion pairs such as those existing in the presence of lithium catalysts in toluene at low temperature, are responsible for the formation of threo isotactic sequences from cis monomers and, therefore, involve a trans addition in contrast, solvent separated ion pairs (fluorenyllithium in THF) give rise to a predominantly syndiotactic polymer. Finally, in mixed ether-hydrocarbon solvents where there are probably peripherally solvated ion pairs, a predominantly isotactic polymer with nonconstant stereochemistry in the jS position is obtained. It seems evident fiom this complexity of situations that the micro-tacticity of anionic poly(methyl methacrylate) cannot be interpreted by a simple Bernoulli distribution, as has already been discussed in Sect. III-A. 

Since radical polymerizations are generally carried out at moderately high temperatures, most of the resulting polymers are highly atactic. This does not mean that there is a complete absence of syndiotacticity. There is a considerable difference in the extent of syndiotacticity from one polymer to another. Thus, methyl methacrylate has a much greater tendency toward syndiotactic placement than vinyl chloride. Whereas the poly(vinyl chloride) produced at the usual commerical polymerization temperature ( 60°C) is essential completely atactic, that is, (r) (m) 0.5, this is not the case for poly(methyl methacrylate). The polymerization of MMA, usually carried out at temperatures up to 100°C, yields polymers with appreciable syndiotacticity—(r) is 0.73 at 100°C. The difference is a consequence of the fact that MMA is a 1,1-disubstituted ethylene, leading to greater repulsions between substituents in adjacent monomer units. 

Optically active polymers are rarely encountered. Most syndiotactic polymers are optically inactive since they are achiral. Most isotactic polymers, such as polypropene and poly(methyl methacrylate), are also inactive (Sec. 8-la-l). Optically active polymers have been obtained in some situations and these are discussed below. 

Preparation of Isotactic and Syndiotactic Poly(Methyl Methacrylate) with Bu llithium in Solution... 

Because of acid-catalyzed hydrolysis of N-vinylpyrrolidone in water, polymerization was carried out in organic solvent - DMF. Three types of samples of poly(methacrylic acid) were used syndiotactic - obtained by radiation polymerization, atactic - obtained by radical polymerization, and isotactic - obtained by hydrolysis of isotactic poly(methyl methacrylate). It was found that in all cases the rate enhancement appeared in comparison with the blank polymerization (without template). The rate enhancement became more pronounced with increasing chain length and syndiotacticity of the template. According to the authors, the rate enhancement is connected with the stronger complex formation between poly(vinyl pyrrolidone) and syndiotactic poly(methacrylic acid) then with isotactic template. This conclusion was supported by turbimetric titration in DMF/DMSO system and by model considerations. It is worth noting, however, that... 

Many radical polymerization systems were examined hy Challa at a/. A number of papers were devoted to polymerization of methyl methacrylate, MM, in the presence of poly(methyl methacrylate). The role of tacticity of template was stressed. Isotactic PMM forms stereocomplex with syndiotactic PMM. Polymerizations of MM in the presence of isotactic PMM were carried out and the product (template + daughter polymer) was analyzed by NMR. When MM is polymerized in the polar solvent in the presence... 

Figure 1. Isotactic, heterotactic, and syndiotactic triad frequencies (i, h, and s) in poly(methyl methacrylate) polymerized and initiated at 225 by t-butylmagnesium bromide fleft), t-butylmagnesium chloride fright,), and di-t-butylmagnesium (top) with initial mole fraction of monomer a = 0.10.

Polymerization. Poly (methyl methacrylate) was obtained commercially. The polymers of other methacrylates and their copolymers were prepared in toluene with 2,2 -azobisisobutyronitrile (AIBN) at 60 °C. All the polymers prepared free radically were syndiotactic or atactic. Isotactic poly(a,a-dimethylbenzyl methacrylate) was obtained using C6H5MgBr as the initiator in toluene at 0°C. Poly(methacrylic acid) was prepared in water using potassium persulfate at as the initiator 60 °C. The molecular weights, glass transition temperatures and tacticities of the polymethacrylates are summarized in Table I. 

Figure 8. X-ray diagrams of syndiotactic poly (methyl methacrylate)(39)...

By using chiral organolanthanide ansa-metallocenes for methyl methacrylate polymerisation, highly stereoregular poly(methyl methacrylate)s were obtained a syndiotactic or isotactic polymer could be synthesised, depending on the kind of metallocene catalyst [536],... 

---