Phase transition deposition

Huckaby D A and Blum L 1991 A model for sequential first-order phase transitions occuring in the underpotential deposition of metals J. Eiectroanai. Chem. 315 255-61... 

Despite the vast quantity of data on the chemistry of electropolymerization, relatively little is known about the processes involved in the deposition of polymers on the electrode, i.e. the heterogeneous phase transition. Research — voltammetric... 

Deposition of adamantane from petroleum streams is associated with phase transitions resulting from changes in temperature, pressure, and/or composition of reservoir fluid. Generally, these phase transitions result in a solid phase from a gas or a liquid petroleum fluid. Deposition problems are particularly cumbersome when the fluid stream is dry (i.e., low LPG content in the stream). Phase segregation of solids takes place when the fluid is cooled and/or depressurized. In a wet reservoir fluid (i.e., high LPG content in the stream) the diamondoids partition into the LPG-rich phase and the gas phase. Deposition of diamondoids from a wet reservoir fluid is not as problematic as in the case of dry streams [74, 75]. 

There are three major classes of palladium-based hydrogen sensors [4], The most popular class of palladium-based sensors is based on palladium resistors. A thin film of palladium deposited between two metal contacts shows a change in conductivity on exposure to hydrogen due to the phase transition in palladium. The palladium field-effect transistors (FETs) or capacitors constitute the second class, wherein the sensor architecture is in a transistor mode or capacitor configuration. The third class of palladium sensors includes optical sensors consisting of a layer of palladium coated on an optically active material that transforms the hydrogen concentration to an optical signal. 

Ten layers of dimyristoylphosphatidylethanolamine (DMPE) LB films were deposited on the QCM. The QCM was immersed into temperature-controlled water phase, and the frequency was followed with time. Typical time-courses of frequency changes are shown in Figure 8. The phase transition temperature from solid to liquid crystalline states of... 

Despite the vast quantity of data on electropolymerization, relatively little is known about the processes involved in the deposition of oligomers (polymers) on the electrode, that is, the heterogeneous phase transition. Research - voltammetric, potential, and current step experiments - has concentrated largely on the induction stage of film formation of PPy [6, 51], PTh [21, 52], and PANI [53]. In all these studies, it has been overlooked that electropolymerization is not comparable with the electrocrystallization of inorganic metallic phases and oxide films [54]. Thus, two-or three-dimensional growth mechanisms have been postulated on the basis that the initial deposition steps involve one- or two-electron transfers of a soluted species and the subsequent formation of ad-molecules at the electrode surface, which may form clusters and nuclei through surface diffusion. These phenomena are still unresolved. 

The electrical potential across a LB film of dioleoyl-lecithin deposited onto a fine-pore membrane, imposed between equimolar aqueous solutions of NaCl and KC1, was reported to exhibit rhythmic and sustained pulsing or oscillations of electrical potential between the two solutions. These oscillations were attributed to the change of permeability of Na+ and K+ ions across the membrane, which originated from the phase transition of lecithin. 

Formation of several successive layers of bulk intermetallic compounds has been shown. Also, Lee et al. [480] have detected, during Al UPD, the formation of two alloys on polycrystalline Au electrodes from acidic l-ethyl-3-methylimidazolium chloroaluminate that melt at room temperature. Moreover, in the Al UPD region, fast phase transition between these two intermetallic compounds has been evidenced. Later, the same group of researchers [481] has performed EQCM studies on Al deposition and alloy formation on Au(lll) in ambient temperature molten salts/benzene mixtures. 

The vapour deposition method is widely used to obtain amorphous solids. In this technique, atoms, molecules or ions of the substance (in dilute vapour phase) are deposited on to a substrate maintained at a low temperature. Most vapour-deposited amorphous materials crystallize on heating, but some of them exhibit an intervening second-order transition (akin to the glass transition). Amorphous solid water and methanol show such transitions. The structural features of vapour-deposited amorphous solids are comparable to those of glasses of the same materials prepared by melt-quenching. 

Crystallization and phase transition, minerals deposit and evaporate. Deposition of minerals as they crystallize is a start of the (ESR) clock.8 Their partial recrystallization gives sometimes misleadingly young ages. Phase transitions also remove the signals in some minerals.22... 

Yoshida et al. recently disclosed an alternative method that allowed them to produce stable suspensions of gold nanoparticles (1-2 nm in diameter) in nematic liquid crystals [315]. They used a simple sputter deposition process, which allowed them to prepare thin liquid crystal films of well-dispersed gold nanoparticles in both 5CB and E47 (available from Merck) with a nanoparticle size depending on the used nematic liquid crystal. Unfortunately, the authors did not provide any details on whether the nanoparticles were capped with a ligand or bare, non-coated particles, which makes it difficult to assess and compare the reported thermal as well as electro-optic data. However, very similar effects were found as a result of nanoparticle doping, including lower nematic-to-isotropic phase transition temperatures compared to the used pure nematics as well as 10% lower threshold voltages at nanoparticle concentrations below 1 wt% [315]. 

The succession of many transition events has created the illusion of succession among species for Darwinians but denied them the intermediates that are required to prove the point. These gaps in turn provide the most powerful evidence for the concept of polyphyletic evolution. The equation of state for the Genomic Potential Hypothesis-type transition is literally pressed into the layers of the Cambrian stones for everybody to see. The time frame of deposit rules out interspecies conversion but rather points to many phase transitions, one for each debutante at the threshold of metazoan life. 

---