Pesticide sprays

Dihexyl sulfosuccinate is used to improve the wetting and spreading characteristics of water-soluble pesticide sprays. In liquid fertilizers, insecticides, and fungicides, dioctyl sulfosuccinate will increase their penetrating ability. 

Bishop CA, Boermans HJ, Ng P, et al. 1998. Health of tree swallows Tachycineta Bicolor nesting in pesticide-sprayed apple orchards in Ontario, Canada. I. Immunological parameters. J Toxicol Environ Health Part A 55 531-559. 

The intent of this article is to provide an overview of methodology and materials for sampling airborne pesticide spray and spray collection on surfaces by sedimentation deposition and impaction after release from field sprayers. The term pesticide will be used as a general term to represent chemicals such as herbicides, insecticides, fungicides and related products. 

Freed, V.H., Davies, J.E., Peters, L.J., and Parveen, F. (1980) Minimizing occupational exposure to pesticides repellency and penetrability of treated textiles to pesticide sprays, Res. Rev., 75 159-167. 

Besides the environmental effects of greenhouse gases, agriculture also contributes to air contamination by ammonia volatilisation (NH3) and pesticide sprays. Therefore, this section is entitled "climate and air", and focuses on the greenhouse gases CO2, N2O and CH4, as well as on NH3 and pesticide sprays. 

Mineau P. 2002. Estimating the probability of bird mortality from pesticide sprays on the basis of the field study record. Environ Toxicol Chem 21 1497-1506. 

These differences in the amount of pesticide sprayed in a given time may be due to the roughness of terrain which would influence the tractor speed and other characteristics of the orchard. 

In addition to these calculated estimates of absorption, a specific estimate of absorbed dose can be made by measuring the metabolites of the pesticide in urine. For pesticides on which good data exist on metabolic excretion, it appears that this method is very sensitive. In a study conducted on orchardists (7), metabolites were detected in the urine samples of all workers, and a statistically significant correlation was found between the total 48 hour metabolite output and the total amount of pesticide sprayed. In contrast the same study indicated that the correlation between urinary output and the total spray time was not significant. This supports the point mentioned earlier that it seems reasonable to presume that exposure is related to the total amount available for contact, and that correlating exposure with the spray time may be misleading. 

Among them are carbon monoxide, cyanide, benzopyrene, and tar, the same toxic chemicals present in cigarette smoke. (Some researchers feel that any beneficial effects that may be found in the medicinal use of marijuana are actually negated by the current lack of a suitable alternative delivery method.) Additionally, any pesticides sprayed on the plant by the grower are present in the smoke, and are inhaled along with the THC. 

Researchers (Armstrong and Yule (6), and Snowden (2)) provided information on distribution of spray in the crown however, data often has been lacking on quantifying the pesticide spray immediately before it penetrates the canopy. 

To illustrate this distribution, Figure 1 shows the result of an actual aerial application of a typical pesticide spray to a broadleafed tree species (3). The "application level" (A) simply assumes that all the spray leaving the aircraft becomes uniformly distributed over the target area (1.12 kg/ha), and the curve shows the parathion levels analytically detected on a statistical sampling of leaves. A major part of the applied pesticide (B) fails to reach the canopy, as corroborated by Barry (2) with conifers, and is assumed to represent airborne drift, volatilization, and, to a lesser extent, penetration to the ground. Once on the... 

I represent the extension faculty in Oregon. I frequently must discuss the risk to human health from pesticide spray... 

There are many variables affecting deposit from drift of pesticide spray and these variables will seldom be quantified or... 

But strawberries are my favorite fruit. Jim says. Do pesticide sprays matter that much ... 

Lower pesticide residues than conventionally grown foods (El-Hage and Hattam 2002). However, organic foods are not pesticide free, due to many factors beyond the control of the organic farmer, for example pesticide spray drift from adjacent fields or soil or irrigation water contamination. 

Tn applying pesticide sprays, the first problem is that of distributing a small quantity of active material over a large target area. The uniformity and extent of the distribution required depend on the type of pest to be controlled and the mode of action of the toxicant a patchy distribution may be satisfactory to control mobile insects or to apply systemic pesticides to foliage, whereas for static pests and contact pesticides, a more uniform spray deposit may be required. The degree of distribution attained depends on ... 

It is necessary to know how the optimum drop size can be achieved. The drop size will be governed by the equipment used, particularly by the type and size of nozzle and by the conditions of pressure and liquid output under which the nozzles are operated. It will be governed also by the physical properties of the spray fluid, such as density, surface tension, and viscosity. For fan-jet nozzles, one of the commonest types of atomizing equipment used in pesticide sprays, Yeo (25) has shown that a simple expression can be used to relate the various parameters governing drop size. For static or slow-moving nozzles, this takes the form ... 

Quantitative data on hollow-cone nozzles, which are also important in pesticide sprays, appear to be even more scanty than the data for fan-jet nozzles. Fraser (16) states that the mean diameter for cone nozzles is proportional to v0 2, and Knight (19) has produced an expression ... 

Before Equation 2 can be tested experimentally, certain assumptions must be made regarding the values assigned to p, V, and y. Although p must include a function of the air density, pesticide spraying operations are usually carried out under normal atmospheric conditions. Thus, it may be assumed that any variation in the air density will be small compared with variations that may be introduced in liquid density and with the considerable variations that may occur in the other parameters in Equation 2. Consequently, the density of the liquid, pL, has been used in place of p in Equation 2, and as discussed before, VE has been used in place of V. 

Physical Properties Determining Chargeability of Pesticide Sprays... 

---