Path of Concentration

Figure 17-3 presents an ordering of nine d-SoCs that are all higher than ordinary consciousness. These are d-SoCsf21 to be obtained sequentially in seeking enlightenment through a path of concentrative meditation in Buddhism. 

Higher states of consciousness on the Buddhist Path of Concentration... 

The underlying value dimension here might be called freedom. The Buddha taught that the ordinary state is one of suffering and entrapment in the forms and delusions of our own minds. The root cause of this suffering is attachment, the (automatized) desire to prolong pleasure and avoid pain. The journey along the Path of Concentration starts when the meditater tries to focus attention on some particular... 

ACCESS CONCENTRATION Previous attainment of access. Concentration on path of concentration BARE INSIGHT Achievement of ability to notice all phenomena of mind, to point where interfering thoughts do not seriously disturb practice. 

Figure 8-1 shows the path of concentration versus time in relation to saturation solubility. With the initial concentration at point A, solvent is removed until the concentration crosses the equilibrium solubility fine at point B, where crystallization may occur. In most cases, however, some degree of supersaturation is necessary before crystallization actually starts. 

ACCESS CONCENTRATION PREVIOUS ATTAINMENT of access CONCENTRATION ON PATH OF CONCENTRATION... 

Atomic Absorption Spectroscopy. Mercury, separated from a measured sample, may be passed as vapor iato a closed system between an ultraviolet lamp and a photocell detector or iato the light path of an atomic absorption spectrometer. Ground-state atoms ia the vapor attenuate the light decreasiag the current output of the photocell ia an amount proportional to the concentration of the mercury. The light absorption can be measured at 253.7 nm and compared to estabUshed caUbrated standards (21). A mercury concentration of 0.1 ppb can be measured by atomic absorption. 

Nicardipine is almost completely absorbed after po adrninistration. Administration of food decreases absorption. It undergoes extensive first-pass metaboHsm in the Hver. Systemic availabiHty is dose-dependent because of saturation of hepatic metaboHc pathways. A 30 mg dose is - 35% bioavailable. Nicardipine is highly protein bound (>95%). Peak plasma concentrations are achieved in 0.5—2.0 h. The principal path of elimination is by hepatic metaboHsm by hydrolysis and oxidation. The metaboHtes are relatively inactive and exert no pharmacological activity. The elimination half-life is 8.6 h. About 60% of the dose is excreted in the urine as metaboHtes (<1% as intact dmg) and 35% as metaboHtes in the feces (1,2,98,99). 

Charge Transport. Side reactions can occur if the current distribution (electrode potential) along an electrode is not uniform. The side reactions can take the form of unwanted by-product formation or localized corrosion of the electrode. The problem of current distribution is addressed by the analysis of charge transport ia cell design. The path of current flow ia a cell is dependent on cell geometry, activation overpotential, concentration overpotential, and conductivity of the electrolyte and electrodes. Three types of current distribution can be described (48) when these factors are analyzed, a nontrivial exercise even for simple geometries (11). 

A problem that affects the accuracy of the prediction of plating thickness is in estimating the actual current density. Current is not evenly distributed over the surface of the part being plated, rather, it takes the path of least resistance. Current also concentrates on sharper points, corners, and edges even the shape of the plating tank can have an influence on the current distribution. The difference in current and, subsequendy, the plate thickness distribution, is minimal when geometrically conforming anodes are part of the system, but this condition is not often achieved. 

In a catalytic reactor, concentrations and temperature change along the flow path of the reactants, and in some cases also normal to the flow. The sum of all these changes over the catalyst-filled volume in time will give the production of the reactor. There are several methods to account for all these changes, illustrated on Figure 8.1.1. 

After dilution with 200 ml. of benzene, the solution is transferred to a 2-1. separatory funnel containing 800 ml. of ice water and shaken thoroughly. The aqueous layer is separated, acidified to pH 3-4 with 2-3 ml. of concentrated hydrochloric acid, and extracted with three 100-ml. portions of benzene. All the organic layers are then combined and dried over anhydrous sodium sulfate. Filtration and concentration of the solution with a rotary evaporator, followed by exposure to high vacuum for 2-3 hours, affords 17.3-19.3 g. of the crude product (Note 3). Low-boiling impurities are removed by vacuum distillation (Note 4), the residual oil (14-15 g.) is transferred to a 50-ml. flask equipped with a short-path distillation apparatus, and vacuum distillation is continued. A forerun is taken until no rise in boiling point is observed, and then 7.2-8.6 g. (23-27%) of dimethyl nitrosuccinate is collected as a colorless oil, b.p. 85° (0.07 mm.), 1.4441 (Note 5). 

If a sample contains groups that can take up or lose a proton, (N//, COO//), then one must expect the pH and the concentration to affect the chemical shift when the experiment is carried out in an acidic or alkaline medium to facilitate dissolution. The pH may affect the chemical shift of more distant, nonpolar groups, as shown by the amino acid alanine (38) in neutral (betaine form 38a) or alkaline solution (anion 38b). The dependence of shift on pH follows the path of titration curves it is possible to read off the pK value of the equilibrium from the point of inflection... 

B. Putrescine dihydrochloride. A 2-1. wide-mouthed Erlen-meyer flask containing 200 ml. of concentrated hydrochloric acid and 400 g. of cracked ice is clamped in an ice-salt bath and provided with an efficient stirrer (inefficient stirring may lower the yield). The stirring is started, and 80 g. (0.46 mole) of adipyl hydrazide is added all at once, followed by 500 ml. of ether (Note 5). While the temperature is maintained below 10° (Note 6), a solution of 80 g. (1.15 moles) of sodium nitrite in 150 ml. of water is added over about 30 minutes through a dropping funnel whose stem reaches below the bottom of the ether layer, but not into the path of the stirrer. The operations in the next paragraph should be conducted without delay after the completion of the addition of the nitrite. 

Applications The differential optical absorption spectrometer has been used to monitor concentrations of gases or intermediate compounds such as SO, NO, O5, HCHO, HNO, CS, NO, and OH in the atmosphere.In atmospheric measurements with open paths of 100 to 1000 m, a detection limit of about 1 ppb can be achieved. In the emission measurements, the path length across the duct or the plume can range in meters. 

Process economics dictate the recycling of the unwanted isomer. Path A in Figure A8.2 illustrates that racemisation of the D-N-benzylidene amino add amide is fadle and can be carried out under very mild reaction conditions. After removal of die benzaldehyde die D,L-amino add amide can be recyded 100% conversion to the L-amino add is theoretically possible. Another method for racemisation and recycling of the L-amino add (path B, Figure A8.2) comprises the conversion of the L-amino add into die ester in the presence of concentrated add, followed by addition of ammonia, resulting in the formation of the amide. Addition of benzaldehyde and racemisation by OH- (pH =13) gives the D,L-amino add amide. In this way 100% conversion to die D-amino add is possible. 

---