P-GEAR

Redford EJ, Smith KJ, Gregson NA, Davies M, Hughes P, Gearing AJ, Miller K, Hughes RA (1997b) A combined inhibitor of matrix metalloproteinase activity and tumour necrosis factor-alpha processing attenuates experimental autoimmune neuritis. Brain 120 1895-1905. 

We thank C. P. Weisel (NRC postdoctoral fellow, NOAA) and R. Zika (University of Miami) for permission to cite their unpublished gel permeation chromatography work, and B. Wrenn for technical assistance. The C analyses were kindly provided by J. and P. Gearing of the Graduate School of Oceanography, University of Rhode Island. This work was supported by the Office of Marine Pollution Assessment, U.S. National Oceanic and Atmospheric Administration. 

Pease, S, Braghetta, P., Gearing, D., Grail, D., and Williams, R. L. Isolation of embryonic stem (ES) cells in media supplemented with recombinant leukemia inhibitory factor (LIF). Dev. Biol. 141, 344-352 (1990). 

M, stirrer motor V, plate cone viscosimeter, Epprecht Rheomat 15 equipped with Viscosclav from Contraves (Zurich) and P, gear pump from Slack and Parr (England) capacity 5 ml /rev, speed range 3-35 rpm. The reacting mass and the measurement apparatus are dipped into the... 

It must place the transmission in the P-Gear or N-Gear when start the engine. 

When manual-operated valve is in position of P-Gear, R-Gear or N-Gear, the transmission fluid is drained and the reverse lock valve maybe affected by pressure S1 -S2 at the same time. 

B2 brake belt is used for P-gear, R-Gear and N-Gear when meets the following conditions. 

If the transmission is in failure mode, then the rear brake belt will be attached in P-Gear, R-Gear and N-Gear. 

Table 5.4------The participating condition of each unit in manual P -Gear...

In the aetion of line 500 pressure, the gear shift valve of 1-2,2-3,3-4 Gear is maintained in P-gear position. 

When the transmission is shifted to P -Gear, the 1-2 Gear shifting valve provides the oil drainage port. 

It should check the cooler after the transmission is installed. Ensure the front and rear cooler pipeline is connected to the proper container. Rotate the vehicle in P-Gear in idle-speed, measure the flow rate within 15s. 

V. It should ensure the position lever is in the position of manual P -Gear before install the valve on the transmission. 

Ortho-phosphate dosing to the City s supplies commenced in 1995 at an average dose of 0.9 mg/1 (P), geared to achieve the lead standard of 50 pg/1 that applied at this time. 

---