Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Observations largest

B) Compare the expected and observed largest-to-smallest intensity ratios. Accidental degeneracies (or am/ line-width dependence) may cause the observed ratio to be bigger than expected. It is rarer (but not unknown) to find a smaller ratio than expected. [Pg.34]

The reaction corroborates the reactivity of the center with the observed largest excess of charge (—0.38) and the HOMO of the ion has a large coefficient at this center. [Pg.936]

Furthermore, actual designs will normally observe the pinch division. Hence A shells should be evaluated and taken as the next largest integer for each side of the pinch. The number-of-shells target is then... [Pg.439]

This is consistent with the observation that the largest difference between the oil-water interface and the free water level (FWL) occurs in the narrowest capillaries, where the capillary pressure is greatest. In the tighter reservoir rocks, which contain the narrower capillaries, the difference between the oil-water interface and the FWL is larger. [Pg.123]

Studies on a large number of aromatic compounds have revealed that for CTAB the largest shift occurs for the alkyl chain protons near the surfactant headgroup, whereas in SDS nearly all proton signals are shifted significantly " ". For SDS, the most pronounced shifts are observed for protons around the centre of the chain. This result has been interpreted in terms of deeper penetration of... [Pg.145]

Table 19 3 lists the ionization constants of some substituted benzoic acids The largest effects are observed when strongly electron withdrawing substituents are ortho to the carboxyl group An o nitro substituent for example increases the acidity of benzoic acid 100 fold Substituent effects are small at positions meta and para to the carboxyl group In those cases the values are clustered m the range 3 5-4 5... [Pg.803]

The nutrient sparing effect of antibiotics may result from reduction or elimination of bacteria competing for consumed and available nutrients. It is also recognized that certain bacteria synthesize vitamins (qv), amino acids (qv), or proteins that may be utilized by the host animal. Support of this mode of action is found in the observed nutritional interactions with subtherapeutic use of antibiotics in animal feeds. Protein concentration and digestibiHty, and amino acid composition of consumed proteins may all influence the magnitude of response to feeding antibiotics. Positive effects appear to be largest... [Pg.410]

OC/P-Proteins. The most frequent domain stmctures observed in proteins are those having a mixture of hehces and sheets. One of the largest... [Pg.210]

Two physically reasonable but quite different models have been used to describe the internal motions of lipid molecules observed by neutron scattering. In the first the protons are assumed to undergo diffusion in a sphere [63]. The radius of the sphere is allowed to be different for different protons. Although the results do not seem to be sensitive to the details of the variation in the sphere radii, it is necessary to have a range of sphere volumes, with the largest volume for methylene groups near the ends of the hydrocarbon chains in the middle of the bilayer and the smallest for the methylenes at the tops of the chains, closest to the bilayer surface. This is consistent with the behavior of the carbon-deuterium order parameters,. S cd, measured by deuterium NMR ... [Pg.488]

Next, the fifth-stage pressure was measured. Once again, a high amplitude at 48A was found. However, a predominant reading was also observed at 1200 Hz frequency. Figures 7-39 and 7-40 show the largest amplitudes at speeds of 5800 and 6800 rpm, respectively. [Pg.315]

Did we predict the number of atoms required to complete additional layers around the metal-coated C(jo correctly Figure 6 shows a spectrum of Qo covered with the largest amount of Ca experimentally possible (note the logarithmic scale). Aside from the edges of A = 32 and a = 104 which we have already discussed, there are additional clear edges at a = 236 and A = 448 (completion of a third layer was also observed at QoSr23g). Note that these values are identical to the ones just predicted above for the completion of the third and fourth layer of metal atoms. We, therefore, feel confident that the alkaline earth metals studied do, in fact, form the distinct layers around a central C50 molecule with the structures depicted in Fig. 5. [Pg.173]

Range The interval defined by the largest and smallest values in a set of observations. [Pg.1471]

Fig. 6.7. The predicted, one-dimensional, mean-bulk temperatures versus location at various times are shown for a typical powder compact subjected to the same loading as in Fig. 6.5. It should be observed that the early, low pressure causes the largest increase in temperature due to the crush-up of the powder to densities approaching solid density. The "spike in the temperature shown on the profiles at the interfaces of the powder and copper is an artifact due to numerical instabilities (after Graham [87G03]). Fig. 6.7. The predicted, one-dimensional, mean-bulk temperatures versus location at various times are shown for a typical powder compact subjected to the same loading as in Fig. 6.5. It should be observed that the early, low pressure causes the largest increase in temperature due to the crush-up of the powder to densities approaching solid density. The "spike in the temperature shown on the profiles at the interfaces of the powder and copper is an artifact due to numerical instabilities (after Graham [87G03]).
Fig. 8.7. The influence of powder morphology (configuration) on shock modification controlling initiation of reaction is shown by the thermal response of mixed Ni-Al powders of different morphologies. The preinitiation event shown in Fig. 8.5 is observed to be strongly influenced by morphology at fixed shoek condition. The eoarse-medium mixture shows the largest preinitiation event [91D01]. The data show mueh larger preinitiation events for the flaky and fine morphologies. Fig. 8.7. The influence of powder morphology (configuration) on shock modification controlling initiation of reaction is shown by the thermal response of mixed Ni-Al powders of different morphologies. The preinitiation event shown in Fig. 8.5 is observed to be strongly influenced by morphology at fixed shoek condition. The eoarse-medium mixture shows the largest preinitiation event [91D01]. The data show mueh larger preinitiation events for the flaky and fine morphologies.
Then, obviously the maximum principal stress is lower than the largest strength. However, 02 is greater than Y, so the lamina must fail under the imposed stresses (perhaps by cracking parallel to the fibers, but not necessarily). The key observation is that strength is a function of orientation of stresses relative to the principal material coordinates of an orthotropic lamina. In contrast, for an isotropic material, strength is independent of material orientation relative to the imposed stresses (the isotropic material has no orientation). [Pg.89]


See other pages where Observations largest is mentioned: [Pg.14]    [Pg.1044]    [Pg.1493]    [Pg.2486]    [Pg.92]    [Pg.102]    [Pg.343]    [Pg.441]    [Pg.658]    [Pg.141]    [Pg.250]    [Pg.413]    [Pg.13]    [Pg.307]    [Pg.340]    [Pg.233]    [Pg.349]    [Pg.421]    [Pg.13]    [Pg.11]    [Pg.492]    [Pg.58]    [Pg.318]    [Pg.185]    [Pg.446]    [Pg.73]    [Pg.115]    [Pg.149]    [Pg.133]    [Pg.163]    [Pg.175]    [Pg.460]    [Pg.653]    [Pg.5]    [Pg.254]   
See also in sourсe #XX -- [ Pg.306 ]




SEARCH



© 2024 chempedia.info