High amplitude

So, a comparison of different types of magnetic field sensors is possible by using the impulse response function. High amplitude and small width of this bell-formed function represent a high local resolution and a high signal-to-noise-characteristic of a sensor system. On the other hand the impulse response can be used for calculation of an unknown output. In a next step it will be shown a solution of an inverse eddy-current testing problem. 

A number of controls are provided to enable the user to tailor the colour, scale and orientation of the displayed image to highlight details of interest. Two types of colour map are available. The Default colour map is a cold-to-hot scheme in which with cold colours such as blue used for low amplitudes and hot colours such as red, yellow and white used for high amplitudes. The Mono colour map uses intensities of red, from black upwards, to indicate increasing amplitude. 

Voltage spikes may have high amplitudes but are of extremely short duration, like an FOW. 

Next, the fifth-stage pressure was measured. Once again, a high amplitude at 48A was found. However, a predominant reading was also observed at 1200 Hz frequency. Figures 7-39 and 7-40 show the largest amplitudes at speeds of 5800 and 6800 rpm, respectively. 

HDH/DHD interface. If the motion of the polymer was the same for each portion of the molecule, i.e., isotropic, the concentration of deuterium across the interface would remain constant. However, if the monomer motion is anisotropic, such as with reptation, where the chain ends lead the centers, a high amplitude ripple in the concentration profile, as described below will be displayed. For a reptating chain, lateral motion of the central segment of the chain is permitted up to depths approximating the tube diameter, after which the central segments must follow the chain ends in a snake-like fashion. 

If, on the other hand, blast modeling is a starting point for structural analysis, the TNT-blast model is less satisfactory because TNT blast and gas explosion blast differ substantially. Whereas a TNT charge produces a shock wave of very high amplitude and short duration, a gas explosion produces a blast wave, sometimes shockless, of lower amplitude and longer duration. In structural analysis, wave shape and positive-phase duration are important parameters these can be more effectively predicted by techniques such as the multienergy method. 

The overall energy from the filtered broadband plotted against measurement location provides an approximation of the mode shape of the installed machine. Figure 44.31 illustrates a vertical broadband plot taken from a Spencer blower. Note that the motor appears to be flexing in the vertical direction. Extremely high amplitudes are present in the motor s outboard bearing and the amplitudes decrease at subsequent measurement points across the machine. 

The reason for this instability is that the blowers are incorrectly sized for the application and are mnning well outside their performance curve. In effect, the blowers have no back-pressure and are operating in a mn-out condition. The result of operating in this condition is that the design load intended to stabilized the rotor is no longer present. This causes the shaft to deflect or flex, generating the high amplitudes observed in the horizontal mode plot. 

Function of speed The high amplitudes at the rotor s natural frequency are strictly speed dependent. If the energy source, in this case speed, changes to a frequency outside the resonant zone, the abnormal vibration will disappear. 

As more air was added to the channel, the slug flow became unstable, the slug bubble broke down, and eventually the churn flow occurred in the channel. As shown in Fig. 5.3d, the most significant feature of flow characteristics in the churn flow is that the pressure oscillated at a relatively high amplitude, since the gas plug and liquid bridge flowed through the test section alternatively. 

PCP produced electrical seizure activity at 12.8 mg/kg IV, EEG spectra were clearly different from those produced by lower doses in that fast-frequency, high-amplitude EEG waves occurred and resulted in a spectral peak at about 15 Hz. EEG activity from 0 to 35 Hz occurred during seizures in contrast to subseizure doses, which produced EEG with little activity beyond 10 Hz. Generally, these seizures occurred immediately after IV injections and lasted 1 to 3 minutes. Similar spectra were obtained with NsBPCA (12.8 mg/kg), SKF-10,047 (25.6 mg/kg), and even with ketamine despite the absence of overt convulsant activity. Motor manifestations of EEG seizure activity included whole body tremors and vigorous twitches of the face and vibrissae. 

FIGURE 15.10 Landscape image of a two-dimensional capillary electrophoresis analysis of the protein content of a single fixed MCF-7 breast-cancer cell. The data consist of a few high-amplitude components. 

Na(j) has high entropy. It exhibits metallic bonding, forming soft crystals with high amplitudes of vibration. 

Basotti G, Betti C, Imbimbo BP, Pelli MA, Morelli A. Colonic high-amplitude propogated contractions (mass movements) repeated 24 h manometric studies in healthy volunteers. J Gastrointest Mot 1992 4 187-191. 

---