Nucleophiles sulfonamide

For the cyclization of the less nucleophilic sulfonamides, this conversion can only be achieved via this two-step protocol. The addition of I2 was highly regioselective, addressing the terminal C=C bond, whereas the second step could deliver several products including the SN2-substitution, SN2 -substitution and bimolecular double substitution products 297-299, depending on the length of the tether connecting the amine and the allene moiety [144, 145],... 

The Paal-Knorr method can be applied to the synthesis of a variety of 1-substituted pyrroles using commercially available 2,5-dialkoxytetrahydrofurans as a butane-1,4-dial equivalent. When an appropriate tetrahydrofuran derivative is available, the reaction can be used for more highly substituted pyrroles. Aliphatic and aromatic amines react readily and even weakly nucleophilic sulfonamides undergo cyclization (equation 66) (73SC303). 

Despite the precedence for lower selectivity, Ellman and co-workers realized that addition of a Grignard reagent proved to be more efficient (745). After Grignard reagent addition to ent- 91, spontaneous cyclization to azepine 201 occurred upon formation of the nucleophilic sulfonamide anion (Scheme 4.3). It is interesting to mention that because Grignard addition provides the opposite diastereoselectivity in comparison to Rh(I)-catalyzed addition, the other enantiomer of A-f-butanesulfinyl imine (enf-197) had to be applied. 

Urea derivadves are of general interest in medicinal chemistry. They may be obtained cither from urea itself (barbiturates, sec p. 306) or from amines and isocyanates. The latter are usually prepared from amines and phosgene under evolution of hydrogen chloride. Alkyl isocyanates are highly reactive in nucleophilic addidon reactions. Even amides, e.g. sulfonamides, are nucleophilic enough to produce urea derivatives. 

The nucleophiles used are OH (32) [the 2-hydroxythiazole can also be obtained by acidic hydrolysis with strong mineral acids (33)], OR" (5, 8, 30, 34), SR" (8, 9, 12), ArSH (35), and amines (4, 7, 14, 33). Benzamide also reacts with 2-bromothiazole, yielding 2-benzamidothiazole (36). Sulfonamide also reacts with 2-halogenothiazoles in presence of a base and copper powder, yielding 2-sulfonamidothiazoles (37, 38). 

Aluminum chloride [7446-70-0] is a useful catalyst in the reaction of aromatic amines with ethyleneknine (76). SoHd catalysts promote the reaction of ethyleneknine with ammonia in the gas phase to give ethylenediamine (77). Not only ammonia and amines, but also hydrazine [302-01-2] (78), hydrazoic acid [7782-79-8] (79—82), alkyl azidoformates (83), and acid amides, eg, sulfonamides (84) or 2,4-dioxopyrimidines (85), have been used as ring-opening reagents for ethyleneknine with nitrogen being the nucleophilic center (1). The 2-oxopiperazine skeleton has been synthesized from a-amino acid esters and ethyleneknine (86—89). 

Acetoiicetyliition Reactions. The best known and commercially most important reaction of diketene is the aceto acetylation of nucleophiles to give derivatives of acetoacetic acid (Fig. 2) (1,5,6). A wide variety of substances with acidic hydrogens can be acetoacetylated. This includes alcohols, amines, phenols, thiols, carboxyHc acids, amides, ureas, thioureas, urethanes, and sulfonamides. Where more than one functional group is present, ring closure often follows aceto acetylation, giving access to a variety of heterocycHc compounds. These reactions often require catalysts in the form of tertiary amines, acids, and mercury salts. Acetoacetate esters and acetoacetamides are the most important industrial intermediates prepared from diketene. 

The fluoraza reagents consist of two types of compounds one in which a fluorine atom is bound to the nitrogen atom of an amide or, more often, a sulfonamide and one in which a fluorine atom is bound to the nitrogen atom of a tertiary amine such as pyridine, quinuclidine, or triethylenediamine 1,4-diaza-bicyclo[2 2.2]octane. The positive charge on the nitrogen is counterbalanced by a non-nucleophilic anion such as triflate or tetrafluoroborate. 

The selective reaction of anionic 3,6-dichloro-4-sulfanilamidopy-ridazine with excess methanolic methoxide at the 3-position is another indication of the absence of major steric effects in most nucleophilic substitutions, as a result of the direction of nucleophilic attack (cf. Section II, A, 1). The selectivity at the 3-position is an example of the interaction of substituent effects. The sulfonamide anion deactivates both the 3-chloro (ortho direct deactivation) and... 

Diuretic activity can be retained in the face of replacement of one of the sulfonamide groups by a carboxylic acid or amide. Reaction of the dichlorobenzoic acid, 174, with chlorsulfonic acid gives the sulfonyl chloride, 175 this is then converted to the amide (176). Reaction of that compound with furfuryl ine leads to nucleophilic aromatic displacement of the highly activated chlorine at the 2 position. There is thus obtained the very potent diuretic furosemide (177). ... 

Two recent reports described addition of nitrogen-centered nucleophiles in usefully protected fonn. Jacobsen reported that N-Boc-protected sulfonamides undergo poorly selective (salen) Co-catalyzed addition to racemic epoxides. However, by performing a one-pot, indirect kinetic resolution with water first (HKR, vide infra, Table 7.1) and then sulfonamide, it was possible to obtain highly enantiomer-ically enriched addition products (Scheme 7.39) [71]. These products were transformed into enantioenriched terminal aziridines in straightforward manner. 

Additions of oxygen and nitrogen nucleophiles to vinyloxiranes can be achieved with Pd(0) catalysis [103, 104]. Acetate, silanols, amines, sulfonamides, and azide have been used as nucleophiles, and the stereochemical outcome of these additions, where applicable, is normally the result of two consecutive SN2 reactions. This is demonstrated by the additions of NaNHTs to vinylepoxides 29 and 30, affording syn- and anti-amino alcohols 31 and 32, respectively, in good yields and with high diastereoselectivities (Scheme 9.22) [105]. 

Nucleophilic displacement by amines and O and S nucleophiles. Subsequent access to inline, carbamate, sulfonamide functions... 

Another way to reduce the nucleophilicity of the sulfur atom is oxidation to the corresponding sulfones, sulfonamides or sultones. Thus, diallyl sulfone undergoes RCM to the corresponding sulfolene smoothly in the presence of... 

Amides are very weak nucleophiles, far too weak to attack alkyl halides, so they must first be converted to their conjugate bases. By this method, unsubstituted amides can be converted to N-substituted, or N-substituted to N,N-disubstituted, amides. Esters of sulfuric or sulfonic acids can also be substrates. Tertiary substrates give elimination. O-Alkylation is at times a side reaction. Both amides and sulfonamides have been alkylated under phase-transfer conditions. Lactams can be alkylated using similar procedures. Ethyl pyroglutamate (5-carboethoxy 2-pyrrolidinone) and related lactams were converted to N-alkyl derivatives via treatment with NaH (short contact time) followed by addition of the halide. 2-Pyrrolidinone derivatives can be alkylated using a similar procedure. Lactams can be reductively alkylated using aldehydes under catalytic hydrogenation... 

Sulfonic esters are most frequently prepared by treatment of the corresponding halides with alcohols in the presence of a base. The method is much used for the conversion of alcohols to tosylates, brosylates, and similar sulfonic esters. Both R and R may be alkyl or aryl. The base is often pyridine, which functions as a nucleophilic catalyst, as in the similar alcoholysis of carboxylic acyl halides (10-21). Primary alcohols react the most rapidly, and it is often possible to sulfonate selectively a primary OH group in a molecule that also contains secondary or tertiary OH groups. The reaction with sulfonamides has been much less frequently used and is limited to N,N-disubstituted sulfonamides that is, R" may not be hydrogen. However, within these limits it is a useful reaction. The nucleophile in this case is actually R 0 . However, R" may be hydrogen (as well as alkyl) if the nucleophile is a phenol, so that the product is RS020Ar. Acidic catalysts are used in this case. Sulfonic acids have been converted directly to sulfonates by treatment with triethyl or trimethyl orthoformate HC(OR)3, without catalyst or solvent and with a trialkyl phosphite P(OR)3. ... 

Feldman reported a route to dihydropyrroles, pyrroles, and indoles via the reaction of sulfonamide anions with alkynyliodonium triflates <96JOC5440>. Thus, upon nucleophilic addition of the anion of 91 to the p-carbon of the alkynyliodonium salt, the alkylidene carbene 92 is generated which can the undergo C-H insertion to the desired product 93. 

The investigation of minor groove-binding polyamides was greatly accelerated by the implementation of solid-phase synthesis [48]. Originally demonstrated on Boc-y9-Ala-PAM resin with Boc-protected monomers, it was also shown that Fmoc chemistry could be employed with suitably protected monomers and Fmoc-y9-Ala-Wang resin (Fig. 3.8) [49]. Recently, Pessi and coworkers used a sulfonamide-based safety-catch resin to prepare derivatives of hairpin polyamides [50]. Upon activation of the linker, resin-bound polyamides were readily cleaved with stoichiometric quantities of nucleophile to provide thioesters or peptide conjugates. 

Sulfonamides are relatively acidic and their anions can serve as nitrogen nucleophiles.64 Sulfonamido groups can be introduced at benzylic positions with a high level of inversion under Mitsunobu conditions.65... 

As an extension to thep-carboxybenzenesulfonamide safety-catch linker [43,44], alkanesulfonamide handle 37 was developed [45]. This linker tethers carboxylic acids to the solid support to give an acylated sulfonamide which is stable to both basic and acidic conditions (Scheme 12). Products were released by treatment with iodoacetonitrile followed by the addition of a nucleophile. 

A-Protected amines were assembled on solid-phase via sulfonamide-based handle 58 (Scheme 27) [67]. Tertiary sulfonamides were generated upon reaction with allylic, benzylic and primary alcohols under Mitsu-nobu conditions. Secondary amines were released from the support using mild nucleophilic conditions such as treatment with thiophenol and potassium carbonate. 

One of the most well used methods for the synthesis of aziridines involves a two (or sometimes more) step process in which an epoxide is opened by a nitrogen nucleophile. The resulting P-amino alcohol (e.g. 79) is then converted to an aziridine via a number of different processes. This method is generally not broadly applicable when a variety of different groups on the nitrogen of the aziridine are desired. A useful method to convert an epoxide to a number of different /V-sulfonyl aziridines (e.g. 80) has been reported <06S425>. Simple addition of a sulfonamide to an epoxide provides high yields of 79 which is readily closed to form the aziridine. 

A sulfonyl chloride group rapidly reacts with amines in the pH range of 9-10 to form stable sulfonamide bonds. Under these conditions, it also may react with tyrosine —OH groups, aliphatic alcohols, thiols, and histidine side chains. Conjugates of sulfonyl chlorides with sulf-hydryls and imidazole rings are unstable, while esters formed with alcohols are subject to nucleophilic displacement (Nillson and Mosbach, 1984 Scouten and Van der Tweel, 1984). The only stable derivative with proteins therefore is the sulfonamide, formed by reaction with e-lysine... 

There are examples of nucleophilic displacement of halide from halo-1,2,5-thiadiazoles by ammonia, primary alkylamines, secondary alkylamines, arylamines, sulfonamides, and phthalimide <1984CHEC(6)513, 1996CHEC-II(4)355>, but the reactions often require high temperatures and excess of the nucleophile. 

With these solid supports in hand, we turned our attention to a new route to the synthesis of our target molecule 23 (Scheme 8). The tricky reductive amination should be replaced by an N-alkylation. To that end, bromoacetic acid is attached to 24c using DIC and Hiinig s base followed by the nucleophilic substitution with the corresponding benzy-lamine in DMSO/toluene (1 1), which can be easily monitored by the Beilstein test, followed by sulfonamide formation in DCM using N-methylmorpholine as base. For the final cleavage, 2% TFA in DCM is used and the resulting solution is filtered in a saturated NaHCC>3 solution to neutralise the acid before evaporation of the solvent. The crude product was then crystallised from ethyl acetate/heptane to yield the desired product in 27% yield overall and 99A% HPLC purity (see Table 4). 

Tanaka and Ohno developed the palladium(0)-catalyzed cyclization of bromoallene 222 bearing a sulfonamide for the synthesis of medium-sized heterocycle 223 (Scheme 37).48b In this reaction, bromoallene acts as an allyl dication equivalent 224, and two different nucleophiles can be introduced regioselectively. The intramolecular nucleophilic... 

---