Nitrobenzene, properties

Physical Properties. Nitrobenzene, C HjNOj pale yellow liquid, insoluble in and heavier than water, characteristic odour of bitter almonds, (similar to that of benzaldehyde and benzonitrile). /> Nitro toluene, C,H4(CH3)N02, usually pale yellow solid, insoluble in water, m-Dinitrobenzene, C8H4(N02)g, colourless solid when pure, but often pale yellow insoluble in water. 

Physical Properties. Both solids, freely soluble in hot water, sparingly in cold water. o-Nitrophcnol, bright yellow, volatile in steam, odour resembling both that of phenol and of nitrobenzene />-m trophenol, colourless when pure, non-volatile in steam, odourless. 

Tetrachloroethane is a good solvent for many compounds which dissolve only slightly in the common solvents it is, however, inferior in solvent power to nitrobenzene, but, on the other hand, it does not possess oxidising properties at the boiling point. 

Physical Properties. Nitrobenzene is readily soluble in most organic solvents and is completely miscible with diethyl ether and benzene. Nitrobenzene is only slightly soluble in water with a solubiUty of 0.19 parts pet 100 parts of water at 20°C and 0.8 pph at 80°C. Nitrobenzene is a good organic solvent. For example, it is used in Friedel-Crafts reactions because aluminum chloride is soluble in nitrobenzene. The physical properties of nitrobenzene are summarized in Table 1. 

Production of cellulose esters from aromatic acids has not been commercialized because of unfavorable economics. These esters are usually prepared from highly reactive regenerated cellulose, and their physical properties do not differ markedly from cellulose esters prepared from the more readily available aHphatic acids. Benzoate esters have been prepared from regenerated cellulose with benzoyl chloride in pyridine—nitrobenzene (27) or benzene (28). These benzoate esters are soluble in common organic solvents such as acetone or chloroform. Benzoate esters, as well as the nitrochloro-, and methoxy-substituted benzoates, have been prepared from cellulose with the appropriate aromatic acid and chloroacetic anhydride as the impelling agent and magnesium perchlorate as the catalyst (29). 

NBO population analysis 195 NBO program 196 Newman projections 290, 292 NewZMat utility xxxvii Windows xlvi nice command xxxviii nitrobenzene 165 NMR properties 21,29, 53, 104 Nobes 117 Norden 218 normal modes 65 normal termination message xlv nuclear displacements 65 numeric second derivatives 61 Nusair 119... 

Compare energies for meta and para-dinitrobenzenium ions (intermediates in nitration of nitrobenzene). Is the ordering the same as those observed for intermediates in toluene and aniline nitration Examine electrostatic potential maps. What does your result suggest about the electron donor/aceptor properties of the nitro substituent ... 

Jha and Bhowmick [51] have reported the development and properties of thermoplastic elastomeric blends from poly(ethylene terephthalate) and ACM by solution-blending technique. For the preparation of the blend the two components, i.e., poly(ethylene terephthalate) and ACM, were dried first in vacuum oven. The ACM was dissolved in nitrobenzene solvent at room temperature with occasional stirring for about three days to obtain homogeneous solution. PET was dissolved in nitrobenzene at 160°C for 30 min and the rubber solution was then added to it with constant stirring. The mixture was stirred continuously at 160°C for about 30 min. The blend was then drip precipitated from cold petroleum ether with stirring. The ratio of the petroleum ether/nitrobenzene was kept at 7 1. The precipitated polymer was then filtered, washed with petroleum ether to remove nitrobenzene, and then dried at 100°C in vacuum. 

Kakiuehi et al. [84] studied the adsorption properties of two types of nonionic surfactants, sorbitan fatty acid esters and sucrose alkanoate, at the water-nitrobenzene interface. These surfactants lower the interfacial capacity in the range of the applied potential with no sign of desorption. On the other hand, the remarkable adsorption-desorption capacity peak analogous to the adsorption peak seen for organic molecules at the mercury-electrolyte interface can be observed in the presence of ionic surfactants, such as triazine dye ligands for proteins [85]. 

When we previously investigated the potentiometric properties of carefully purified plasticizers of low polarity, no EMF responses were observed, whereas for a more polar solvent (nitrobenzene), transient EMF responses were obtained [55,59]. Because of this large difference, we were also interested in the combined SHG and EMF response of more polar ion-exchanger membranes. As previously, we used nitrobenzene for this purpose. 

In this chapter, the voltammetric study of local anesthetics (procaine and related compounds) [14—16], antihistamines (doxylamine and related compounds) [17,22], and uncouplers (2,4-dinitrophenol and related compounds) [18] at nitrobenzene (NB]Uwater (W) and 1,2-dichloroethane (DCE)-water (W) interfaces is discussed. Potential step voltammetry (chronoamperometry) or normal pulse voltammetry (NPV) and potential sweep voltammetry or cyclic voltammetry (CV) have been employed. Theoretical equations of the half-wave potential vs. pH diagram are derived and applied to interpret the midpoint potential or half-wave potential vs. pH plots to evaluate physicochemical properties, including the partition coefficients and dissociation constants of the drugs. Voltammetric study of the kinetics of protonation of base (procaine) in aqueous solution is also discussed. Finally, application to structure-activity relationship and mode of action study will be discussed briefly. 

The solvent dependence of the reaction rate is also consistent with this mechanistic scheme. Comparison of the rate constants for isomerizations of PCMT in chloroform and in nitrobenzene shows a small (ca. 40%) rate enhancement in the latter solvent. Simple electrostatic theory predicts that nucleophilic substitutions in which neutral reactants are converted to ionic products should be accelerated in polar solvents (23), so that a rate increase in nitrobenzene is to be expected. In fact, this effect is often very small (24). For example, Parker and co-workers (25) report that the S 2 reaction of methyl bromide and dimethyl sulfide is accelerated by only 50% on changing the solvent from 88% (w/w) methanol-water to N,N-dimethylacetamide (DMAc) at low ionic strength this is a far greater change in solvent properties than that investigated in the present work. Thus a small, positive dependence of reaction rate on solvent polarity is implicit in the sulfonium ion mechanism. 

The heat of decomposition (238.4 kJ/mol, 3.92 kJ/g) has been calculated to give an adiabatic product temperature of 2150°C accompanied by a 24-fold pressure increase in a closed vessel [9], Dining research into the Friedel-Crafts acylation reaction of aromatic compounds (components unspecified) in nitrobenzene as solvent, it was decided to use nitromethane in place of nitrobenzene because of the lower toxicity of the former. However, because of the lower boiling point of nitromethane (101°C, against 210°C for nitrobenzene), the reactions were run in an autoclave so that the same maximum reaction temperature of 155°C could be used, but at a maximum pressure of 10 bar. The reaction mixture was heated to 150°C and maintained there for 10 minutes, when a rapidly accelerating increase in temperature was noticed, and at 160°C the lid of the autoclave was blown off as decomposition accelerated to explosion [10], Impurities present in the commercial solvent are listed, and a recommended purification procedure is described [11]. The thermal decomposition of nitromethane under supercritical conditions has been studied [12], The effects of very high pressure and of temperature on the physical properties, chemical reactivity and thermal decomposition of nitromethane have been studied, and a mechanism for the bimolecular decomposition (to ammonium formate and water) identified [13], Solid nitromethane apparently has different susceptibility to detonation according to the orientation of the crystal, a theoretical model is advanced [14], Nitromethane actually finds employment as an explosive [15],... 

A series of mixtures of nitric acid with one or more of mono- and di-nitrobenzenes, di- and tri-nitrotoluenes have been shown to possess high-explosive properties [1]. Critical detonation diameters for mixtures of nitric acid with dinitrotoluene and TNT have been determined [2],... 

Aniline is an aromatic amine used in the manufacture of dyes, dye intermediates, rubber accelerators, and antioxidants. It has also been used as a solvent, in printing inks, and as an intermediate in the manufacture of pharmaceuticals, photographic developers, plastics, isocyanates, hydroquinones, herbicides, fungicides, and ion-exchange resins. It is produced commercially by catalytic vapor phase hydrogenation of nitrobenzene (Benya and Cornish 1994 HSDB 1996). Production of aniline oil was listed at approximately 1 billion pounds in 1993 (U.S. ITC 1994). Chemical and physical properties are listed in Table 1-2. 

A method has been offered to characterize variations in the retention properties of RPLC by column-eluent combinations by using retention indices of a set of reference compounds, toluene, nitrobenzene, p-cresol, and 2-naphthylethanol [96]. These compounds were selected by multivariate analysis to give optimum discrimination between eluents and columns. 

Chatteijee, A., Iwasaki, T., Ebina, T., and Mizukami, F. 2003. Intermolecular reactivity study to scale adsorption property of para- and meta-substituted nitrobenzene over 2 1 dioctahedral smectite. J. Chem. Phys. 118 10212-10220. 

Goswami and Sarkar3 claimed to have prepared methyl and ethyl fluoroformates by the action of thallium fluoride on the corresponding chloroformates. These fluoroformates were described as powerful lacrimators. We found that no appreciable reaction took place between potassium fluoride and ethyl chloroformate in boiling carbon tetrachloride or nitrobenzene. Ethyl fluoroformate could, however, be readily produced by the action of potassium fluoride on ethyl chloroformate by using the autoclave technique. It was found not to have the lacrimatory properties claimed for it, and was non-toxic in comparison with M.F.A. This non-toxicity was to be expected, as the fluoroformate contains the COF and not the CH2F- group. 

The property of being converted by energetic reduction into primary amines belongs to the nitro-compounds both of the aliphatic and of the aromatic series. Six atoms of hydrogen are required for the reduction of each nitro-group. In industry nitrobenzene is reduced, not with expensive tin, but with iron filings or iron powder according to the old method of Bechamp, which is still in use at the present time. The amount of hydrochloric acid indicated by the equation... 

Numerous aromatic nitro compounds have explosive properties, and thus it is important to understand the role that enthalpy of formation has on the sensitivity and long-term stability of these compounds. We will examine three nitro-substituted aromatic families for which thermochemical data can be found in the literature2,84 derivatives of nitrobenzene, aniline and toluene. The choice of these three families allows us to compare the various electronic effects exerted by the parent functional group. The parent compounds differ electronically with respect to the aromatic ring in that ... 

Aliphatic analogues of aniline and nitrobenzene were discovered somewhat later. Methy-lamine and ethylamine were first prepared by Wurtz in 184914, and thereafter many aliphatic amines were made and their properties studied13, particularly by Hofmann15. 

Eckert, J.W. Fungistatic and phytotoxic properties of some derivatives of nitrobenzene. Phytopathology, 52 642-650, 1962. 

Kralj, F. and Sincic, D. Mutual solubilities of phenol, salicyaldehyde, phenol-salicyaldehyde mixture, and water with and without the presence of sodium chloride and sodium chloride plus sodium sulfate, J. Chem. Eng. Data, 25 (4) 335-338,1980. Kramer, C.R. and Henze, U. Partitioning properties of benzene derivatives. 1. Temperature dependence of the partitioning of monosubstituted benzenes and nitrobenzenes in the n-octanol/water system, Z. Phys. Chem., 271(3) 503-513,1990. Krasnoshchekova, R.Ya. and Gubergrits, M. Solubility of paraffin hydrocarbons in fresh and salt water, Neftekhlmlya, 13(6) 885-888, 1973. 

---