Neumann

As an example of the application of the method, Neumann and Tanner [54] followed the variation with time of the surface tension of aqueous sodium dode-cyl sulfate solutions. Their results are shown in Fig. 11-15, and it is seen that a slow but considerable change occurred. 

Bianco and Marmur [143] have developed a means to measure the surface elasticity of soap bubbles. Their results are well modeled by the von Szyszkowski equation (Eq. III-57) and Eq. Ill-118. They find that the elasticity increases with the size of the bubble for small bubbles but that it may go through a maximum for larger bubbles. Li and Neumann [144] have shown the effects of surface elasticity on wetting and capillary rise phenomena, with important implications for measurement of surface tension. 

A. W. Neumann et al.. Applied Surface Thermodyrmmics. Interfacial Tension and Contact Angles, Marcel Dekker, New York, 1996. 

Neumann has adapted the pendant drop experiment (see Section II-7) to measure the surface pressure of insoluble monolayers [70]. By varying the droplet volume with a motor-driven syringe, they measure the surface pressure as a function of area in both expansion and compression. In tests with octadecanol monolayers, they found excellent agreement between axisymmetric drop shape analysis and a conventional film balance. Unlike the Wilhelmy plate and film balance, the pendant drop experiment can be readily adapted to studies in a pressure cell [70]. In studies of the rate dependence of the molecular area at collapse, Neumann and co-workers found more consistent and reproducible results with the actual area at collapse rather than that determined by conventional extrapolation to zero surface pressure [71]. The collapse pressure and shape of the pressure-area isotherm change with the compression rate [72]. 

Neumann and co-workers have used the term engulfrnent to describe what can happen when a foreign particle is overtaken by an advancing interface such as that between a freezing solid and its melt. This effect arises in floatation processes described in Section Xni-4A. Experiments studying engulfrnent have been useful to test semiempirical theories for interfacial tensions [25-27] and have been used to estimate the surface tension of cells [28] and the interfacial tension between ice and water [29]. 

The axisymmetric drop shape analysis (see Section II-7B) developed by Neumann and co-workers has been applied to the evaluation of sessile drops or bubbles to determine contact angles between 50° and 180° [98]. In two such studies, Li, Neumann, and co-workers [99, 100] deduced the line tension from the drop size dependence of the contact angle and a modified Young equation... 

The capillary rise on a Wilhelmy plate (Section II-6C) is a nice means to obtain contact angles by measurement of the height, h, of the meniscus on a partially immersed plate (see Fig. 11-14) [111, 112]. Neumann has automated this technique to replace manual measurement of h with digital image analysis to obtain an accuracy of 0.06° (and a repeatability to 95%, in practice, of 0.01°) [108]. The contact angle is obtained directly from the height through... 

Contact angle will vary with liquid composition, often in a regular way as illustrated in Fig. X-13 (see also Ref. 136). Li, Ng, and Neumann have studied the contact angles of binary liquid mixtures on teflon and found that the equation of state that describes... 

Li and Neumann sought an equation of state of interfacial tensions of the form 7 l = /(Tlv. TSv). Based on a series of measurements of contact angles on polymeric surfaces, they revised an older empirical law (see Refs. 216, 217) to produce a numerically robust expression [129, 218]... 

As an extension of Problem 11, integrate a second time to obtain the equation for the meniscus profile in the Neumann method. Plot this profile as y/a versus x/a, where y is the vertical elevation of a point on the meniscus (above the flat liquid surface), x is the distance of the point from the slide, and a is the capillary constant. (All meniscus profiles, regardless of contact angle, can be located on this plot.)... 

Where do you stand on the controversy between Neumann and co-workers [221-223] and those who have criticized this approach [219, 220] ... 

---