N Ratio

Grafe and Wolf have also reported exceedingly high D N ratios (exceeding 10 1) in diabetic patients on an exclusive protein-fat diet. Lusk suggests that such ratios may be the result of surreptitious in- 

---

Minimum exposure times must be observed in order to reach the requisite S/N ratio. As per EN 1435 and EN 584-1, for the different ranges of utilization (energy, wall thickness), definite film elasses are prescribed. They are characterized by the minimum gradient-to-noise ratios. Based on this, one can calculate the minimum values for the S/N ratio based on the IP systems. The exposure time and the device parameter sensitivity and dynamics (latitude) must be adjusted accordingly, with an availability of an at least 12 bit system for the digitalization. 

Due to the conversion process an absorbed photon give rise to less than one electron generated in the CCD. This phenomenon, also called a "quantum sink" shows that the detector is degrading the S/N ratio of the image. The quality of an image being mainly limited by the quantum noise of the absorbed gamma this effect is very important. 

Acrylonitrile reacts with the sodium salt of 4.5-dimethvl-A-4-thiazoline-2-thione (73J (R4 = R5 = Me) to yield 3-(2-cyanoethyl)-4.5-dimethyl-A-4-thiazoline-2-thione (74) (R4 = R, = Me) (Scheme 35 (160). Humphlett s studies of this reaction showed that the size of the R4 substituent is a determinant factor for the S versus N ratio (161. 162). If R4 == H, 100% of the N-substituted product (74) is obtained this drops to 50% when R4 = methyl, and only the S-substituted product (75) is obtained when R4 = phenyl. The same trend is observed with various CH2 = CH-X (X = C00CH3. COCH3) reagents (149). The S/N ratio also depends on the electrophilic center for CH2 = CH-X systems thus S-reaction occurs predominantly with acrylonitrile, whereas N-substitution predominates with methvlvinvlketone (149). 

In reahty the chemistry of breakpoint chlorination is much more complex and has been modeled by computer (21). Conversion of NH/ to monochloramine is rapid and causes an essentially linear increase in CAC with chlorine dosage. Further addition of chlorine results in formation of unstable dichloramine which decomposes to N2 thereby causing a reduction in CAC (22). At breakpoint, the process is essentially complete, and further addition of chlorine causes an equivalent linear increase in free available chlorine. Small concentrations of combined chlorine remaining beyond breakpoint are due primarily to organic chloramines. Breakpoint occurs slightly above the theoretical C1 N ratio (1.75 vs 1.5) because of competitive oxidation of NH/ to nitrate ion. Organic matter consumes chlorine and its oxidation also increases the breakpoint chlorine demand. Cyanuric acid does not interfere with breakpoint chlorination (23). 

Similar reactions occur with ammonia and HOBr (19—25), but since HOBr is a stronger electrophile than HOCl, formation rates are faster. Because of rapid bromine transfer between bromamines, equihbrium concentrations of the respective bromamines are obtained quickly. Mon ohrom amine predominates at basic pH at high N Br ratios. Below pH 8.5, NHBr2 and NBr predominate. Tribromamine formation is favored at lower pH and higher Br N ratios. The bromamines are less stable than chloramines but are better disinfectants. 

Signals generated by high-speed maehinery are very eomplex in nature and are generated by several forees with a net effeet that masks the pure tones. The random portion of the signal, whieh is blended with the pure tones, is ealled noise. The ratio of the total amplitude (area under speetrum) to that of the noise is ealled the signal-to-noise (S/N) ratio. Sometimes this ratio is expressed in deeibels, or db, as follows ... 

If the S/N ratio is less than 10 db, it beeomes diffieult to differentiate the periodie part of the speetrum from noise. 

The second limitation of this pickup is illustrated by an example. Acceleration of one g at 0.5 represents a displacement of 100 inches. It is obvious that in spite of its wide-band response (sometimes 0.1 —15 kH ), it is severely limited at the low end by a poor S/N ratio. 

Averaging is a teehnique to improve the S/N ratio. Two or more sueeessive speetra made up of both periodie and random (noise) signals are added together and then averaged. This eombination results in a speetrum with a periodie eomponent that is mueh the same as when viewed in the instantaneous signals but with random peaks of mueh less amplitude. This result oeeurs beeause the period peak stays at a fixed frequeney in the speetrum, while the noise peak is fluetuating in frequeney over the speetrum. 

Lactam Methylation, 0- N- 0 N ratio Total yield (%) Process... 

The compositions of each component are obtained from the (xi/xh)n ratio. 

Using Table 52 the variables are El(FL ), L(L), d(L), (d - d,)(L), T(FL), and P(F). Note that this I is moment-area which is in the units of ft (not to be confused with I given in Table 52 which is moment of inertia, see Chapter 2, Strength of Materials, for clarification). The number of FI ratios that will describe the problem is equal to the number of variables (6) minus the number of fundamental dimensions (F and L, or 2). Thus, there will be four FI ratios (i.e., 6-2 = 4), FI, flj, fl, and FI. The selection of the combination of variables to be included in each n ratio must be carefully done in order not to create a complicated system of ratios. This is done by recognizing which variables will have the fundamental dimensions needed to cancel with the fundamental dimensions in the other included variables to have a truly dimensionless ratio. With this in mind, FI, is... 

C N ratio The C N ratio should be about 10 1. The organic carbon in the medium provides both a... 

It has been prepd by various procs using chlorinating agents, ie, Cl gas or hypochlorites in aq or anhyd ammonia. For example, the interaction of Cl ammonia N 1 2.04 12.73 at 300° in a flow reactor gives chloramine which is absorbed in a suitable solv at 75° (Ref 9). An app is described in Ref 10 for the improved prepn of chloramine using a Cl ammonia N ratio of 1 8.6 3.2, max yield 95%. It has also been prepd by the hydrolysis of N,N -dichloro-urca (Ref 1)... 

Characteristic length [Eq. (121)] L Impeller diameter also characteristic distance from the interface where the concentration remains constant at cL Li Impeller blade length N Impeller rotational speed also number of bubbles [Eq, (246)]. N Ratio of absorption rate in presence of chemical reaction to rate of physical absorption when tank contains no dissolved gas Na Instantaneous mass-transfer rate per unit bubble-surface area Na Local rate of mass-transfer per unit bubble-surface area Na..Average mass-transfer rate per unit bubble-surface area Nb Number of bubbles in the vessel at any instant at constant operating conditions N Number of bubbles per unit volume of dispersion [Eq. (24)] Nb Defined in Eq. (134)... 

Griess (1860) coined the prefix diazo for the nitrosation product of an aromatic amine, because he assumed that two nitrogen atoms replaced two hydrogen atoms of the parent aromatic compound. On the other hand, azobenzene received its name on the basis of the C H N ratio 6 5 1, indicating the replacement of one hydrogen by one nitrogen atom. 

In the calculations for the inner core and innermost core the decreased volume of the inner spherons (shift to tritons and dineutrons) has been taken into account. The nature of the spherons is indicated by the chart (Fig. 2) and the Z/N ratio. 

---