Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Moisture conditions

Neopentyl alcohol is useful for preparation of masked polyol siUcate esters, capable of releasing the polyol under moisture conditions, in moisture-curable one-component Hquid polyurethane compositions (90). [Pg.373]

By way of comparison, for natural grass playing fields in late autumn ranges from about 75 for wet fields to 280 for fro2en turf (8). The intermediate values observed depend on soil type, moisture, condition, and other variables. [Pg.534]

Glass Frosting. Deposition of siUcon dioxide is used to impart a translucent coating on glass (qv) (50). The surfaces are either exposed to tetraethoxysilane or tetramethoxysilane under high moisture conditions, or the alkoxysilanes are ignited and the resulting powder is appHed to the surface. [Pg.40]

If water losses from the surrounding area are a major component of the total evaporative losses of the pond, then soil moisture conditions will be expected to be high. Under non-limiting soil moisture conditions vegetative moisture losses are often defined as "potential" losses. Evaporative losses in this case would not be expected to differ greatly from free water evaporation. The literature recommends... [Pg.549]

Air quality The concentration of one or more pollutants in the air, measured in either ppm or pg m . It may be related to pollution sources inside an enclosure or outdoor air. Temperature and moisture conditions may also be considered. [Pg.1411]

Finally, both the state of the material and the state of stress affect the laminate strength evaluation. That is, the actual temperature and moisture conditions influence the laminae strengths. Taken together with the laminae stresses, the laminae strengths and the laminate loads lead to an evaluation of the laminate capabilities. [Pg.240]

Type and specifications on fan driver, gear types, pow er voltage, phase, cycles. Motors should at least meet specifications equivalent to totally enclosed, fan cooled, or if in explosive hazardous area, TEFC Class I, Group D (except this not acceptable in hydrogen or acetylene atmosphere). Due to moisture conditions around this equipment, it should be protected against moisture penetration and corrosion. [Pg.387]

CN2 Initial Soil Conservation Service (SCS) runoff curve number for moisture condition II. The SCS curve number is a function of the soil s permeability, land use and antecedent soil water conditions. [Pg.65]

McCabe, G.J. Wolock, D.D. 2002. Trends and temperature sensitivity of moisture conditions in the conterminous United States. Climate Research, 20,19-29. [Pg.196]

Murphy, P.N.C., Ogilvie, J., Arp, P.A. 2009. Topographic modelling of soil moisture conditions a comparison and verification of two models. European Journal of Soil Science, 60, 94-109. [Pg.259]

The water deficiency in Arid ecosystems is the main restricting factor for biogeochem-ical exposure processes. We know that many links of the biogeochemical food web are connected in Steppe soils with invertebrates. Their population varies very much in Steppe ecosystems depending on the moisture conditions (Table 6). For instance, the wet biomass of soil invertebrates in the Meadow Steppe and Forest Steppe ecosystems exceeds that for the Extra-Dry Rocky Desert ecosystems by 150-300 times. [Pg.173]

In watersheds where surface runoff is limited by infiltration rate rather than soil-water storage capacity, areas of the watershed can alternate between sources and sinks of surface flow. This again will be a function of soil properties, rainfall intensity and duration, and antecedent moisture condition. As surface runoff is the main mechanism by which phosphorus is exported from most watersheds, it is clear that, if surface runoff does not occur, phosphorus export can be small. Thus, consideration of hydro-logic pathways and variable source areas is critical to a more detailed understanding of phosphorus export from agricultural watersheds. [Pg.250]

Miyafuji and Saka (2001) treated moisture-conditioned wood with a methanolic solution of MTMS in combination with sodium ethoxide, or sodium acetate, to form Na20-Si02 gels. The gels were found to be mainly located in the cell wall and improved the fire resistance of the wood. The use of benzophenone in combination with a Si-gel treatment has been fonnd to improve the UV stability of wood (Miyafuji etal. 2004). [Pg.165]

Plant Species i. xiaani oncen tration, ppm h Type of Response Moisture Conditions (high low) Reference... [Pg.494]

Markowski, A., and S. Grzesiak. Influence of sulfur dioxide and ozone on vegetation of bean and barley plants under different soil moisture conditions. Bull. Acad. Pol. Sci. Ser. Sci. Biol. 22 875-887, 1975. [Pg.574]

Fig. 12.14 Kerosene retention capacity (KRC) as affected by soil type and soil moisture conditions, expressed as volume of kerosene per bulk volume of air-dry soil. Reprinted from Jarsjo J, Destouni G, Yaron B (1994) Retention and volatilization of kerosene laboratory experiments on glacial and postglacial soils. J Contam Hydrol 17 167-185. Copyright 1994 with permission of Elsevier... Fig. 12.14 Kerosene retention capacity (KRC) as affected by soil type and soil moisture conditions, expressed as volume of kerosene per bulk volume of air-dry soil. Reprinted from Jarsjo J, Destouni G, Yaron B (1994) Retention and volatilization of kerosene laboratory experiments on glacial and postglacial soils. J Contam Hydrol 17 167-185. Copyright 1994 with permission of Elsevier...
E. coli 0157 H7 can survive in high moisture content bovine manure for over 70 days at 5 °C that compared to 49 days at 30 °C (Semenov et al., 2007). The persistence of Salmonella in manure is also favored under low temperature and high moisture conditions (Mannion et al., 2007). However, survival of both pathogens in manure slurry is restricted to a maximum of 10 days (Cote et al, 2006). Laboratory studies on E. coli 0157 H7 and S. Typhimur-ium in cow manure and cow slurry indicated that death rate is a function of temperature and depth in the storage container (Himathongkham et al.,... [Pg.170]

Three fly ash samples, Drax fresh, Drax weathered and Meaford weathered, in their natural moisture condition were lightly packed into acrylic columns (5 cm diameter, 40 cm long) to achieve a uniform bulk density, comparable to values in the literature (dry bulk density 1.01-1.43 mg/m3, Mattigod et al. 1990). Then, lOOOmL of deionized water were passed through each column at a flow rate of 25 mm/ day, and 50 mL of solution samples were collected every two days. [Pg.628]

In nurseries where the soil and moisture conditions are such that heavy equipment would be impractical, a very light hand-drawn outfit can be constructed sWlar to one made by Nursery Superintendent C. C. Mony of Vallonia, Ind. [Pg.89]


See other pages where Moisture conditions is mentioned: [Pg.53]    [Pg.525]    [Pg.269]    [Pg.456]    [Pg.329]    [Pg.291]    [Pg.267]    [Pg.1104]    [Pg.710]    [Pg.550]    [Pg.114]    [Pg.103]    [Pg.181]    [Pg.186]    [Pg.430]    [Pg.443]    [Pg.224]    [Pg.375]    [Pg.194]    [Pg.234]    [Pg.43]    [Pg.59]    [Pg.25]    [Pg.317]    [Pg.9]    [Pg.220]    [Pg.165]    [Pg.170]    [Pg.178]    [Pg.29]    [Pg.513]    [Pg.103]   


SEARCH



Moisture condition value test

Moisture conditioning

Moisture conditioning

© 2024 chempedia.info