Micellar molecule

Some polyanionic dendrimers act as micellar molecules [58]. Newkome et al. first synthesised water-soluble dendrimers, whose hydrophobic molecular niches can accommodate guests. The periphery of such dendrimers was furnished with... 

In 1981, the author s group found large MFEs and MIEs on the radical pair lifetime (Trp) and the escape radical yield (Fe) under magnetic fields of 0 - 70 mT with an ns-laser photolysis at room temperature for the photoreduction reactions of benzophenone (BP), benzophenone-sodium dodecyl sulfate (SDS) solutions [1]. Here, micellar molecules act as hydrogen donors (RH). The scheme of such photoreduction reactions of the benzophenone isotopes (XCO) can be represented by the following reaction scheme ... 

UXab, respectively. Because R is derived from a micellar molecule, its value should be similar to the value of the dipole-dipole interaction. On the other hand, the Tb value should be much smaller than x because XHCO is much smaller than R . 

Other solubilization and partitioning phenomena are important, both within the context of microemulsions and in the absence of added immiscible solvent. In regular micellar solutions, micelles promote the solubility of many compounds otherwise insoluble in water. The amount of chemical component solubilized in a micellar solution will, typically, be much smaller than can be accommodated in microemulsion fonnation, such as when only a few molecules per micelle are solubilized. Such limited solubilization is nevertheless quite useful. The incoriDoration of minor quantities of pyrene and related optical probes into micelles are a key to the use of fluorescence depolarization in quantifying micellar aggregation numbers and micellar microviscosities [48]. Micellar solubilization makes it possible to measure acid-base or electrochemical properties of compounds otherwise insoluble in aqueous solution. Micellar solubilization facilitates micellar catalysis (see section C2.3.10) and emulsion polymerization (see section C2.3.12). On the other hand, there are untoward effects of micellar solubilization in practical applications of surfactants. Wlren one has a multiphase... 

The binding behaviour of benzene can be extrapolated to many other aromatic compounds such as naphthalene and benzene derivativesInterestingly, a large number of probe molecules contain aromatic rings and many of them will prefer the outer regions of micelles, whereas in bilayer systems, the same molecules prefer the interior of the aggregate ". Qearly these probes cannot be used to determine polarity of the micellar interior or the extent of water penetration therein . 

An expression for the number of particles formed during Stage I was developed, assuming micellar entry as the formation mechanism (13), where k is a constant varying from 0.37 to 0.53 depending on the relative rates of radical adsorption in micelles and polymer particles, r is the rate of radical generation, m is the rate of particle growth, is the surface area covered by one surfactant molecule, and S is the total concentration of soap molecules. 

Ahphatic amine oxides behave as typical surfactants in aqueous solutions. Below the critical micelle concentration (CMC), dimethyl dodecyl amine oxide exists as single molecules. Above this concentration micellar (spherical) aggregates predorninate in solution. Ahphatic amine oxides are similar to other typical nonionic surfactants in that their CMC decreases with increasing temperature. 

Possibility of changing the properties of micellar phases by electrolyte inclusions was shown. Under this condition, in the systems with manifestation of complexes formation between the cationic compound of the electrolyte and the polyoxyethylene chain of the surfactant, increase of the hydrophilic properties of micellar phases was observed. The electrolytes that do not have affinity to the surfactant s molecule practically do not influence the liophily of the nonionic surfactant-rich phases. 

The model was tested by the micellar liquid chromatography separ ation of the five rarbornicin derivatives and four ethers of hydroxybenzoic acid. Micellar mobile phases were made with the sodium dodecylsulfate and 1-pentanol or isopentanol as modifier. In all cases the negative signs of the coefficients x and y indicate that at transition of the sorbat from the mobile on the stationar y phase the number of surfactant monomers as well as the number of modifier molecules increases in its microenvironment. 

Ultrafiltration of micellar solutions combines the high permeate flows commonly found in ultrafiltration systems with the possibility of removing molecules independent of their size, since micelles can specifically solubilize or bind low molecular weight components. Characteristics of this separation technique, known as micellar-enhanced ultrafiltration (MEUF), are that micelles bind specific compounds and subsequent ultrafiltration separates the surrounding aqueous phase from the micelles [70]. The pore size of the UF membrane must be chosen such, that the micelles are retained but the unbound components can pass the membrane freely. Alternatively, proteins such as BSA have been used in stead of micelles to obtain similar enan-tioselective aggregates [71]. 

Based on the Smith-Ewart theory, the number of latex particles formed and the rate of polymerization in Interval II is proportional with the 0,6 power of the emulsifier concentration. This relation was also observed experimentally for the emulsion polymerization of styrene by Bartholomeet al. [51], Dunn and Al-Shahib [52] demonstrated that when the concentrations of the different emulsifiers were selected so that the micellar concentrations were equal, the same number of particles having the same size could be obtained by the same polymerization rates in Interval II in the existence of different emulsifiers [52], The number of micelles formed initially in the polymerization medium increases with the increasing emulsifier concentration. This leads to an increase in the total amount of monomer solubilized by micelles. However, the number of emulsifier molecules in one micelle is constant for a certain type of emulsifier and does not change with the emulsifier concentration. The monomer is distributed into more micelles and thus, the... 

The interfacial activity is determined by the sterical properties of the molecule. At the interface the spatial demand A0 of the hydrophobic part of the molecule is higher because of the second chain of the internal sulfonate compared with the terminal sulfonate. Thus, the surface concentration of the surfactant molecules is lower. That means that the hydrocarbon chains are laterally oriented and therefore cover the interface between the solution surface and air more completely. Because the ratio of the spatial demand of the head group to the volume of the alkyl chain governs the radius of the micellar surface, it... 

Mechanisms of micellar reactions have been studied by a kinetic study of the state of the proton at the surface of dodecyl sulfate micelles [191]. Surface diffusion constants of Ni(II) on a sodium dodecyl sulfate micelle were studied by electron spin resonance (ESR). The lateral diffusion constant of Ni(II) was found to be three orders of magnitude less than that in ordinary aqueous solutions [192]. Migration and self-diffusion coefficients of divalent counterions in micellar solutions containing monovalent counterions were studied for solutions of Be2+ in lithium dodecyl sulfate and for solutions of Ca2+ in sodium dodecyl sulfate [193]. The structural disposition of the porphyrin complex and the conformation of the surfactant molecules inside the micellar cavity was studied by NMR on aqueous sodium dodecyl sulfate micelles [194]. 

As indicated earlier, clear cellulose solutions are not necessarily molec-ularly dispersed they may contain aggregates of still ordered cellulose molecules [107]. The structure of these aggregates has been described in terms of a fringed micellar structure. Figure 2a shows a schematic possi-... 

---