Ketones methyl vinyl

CH2 CH C CH. Colourless gas with a sweet odour b.p. 5°C. Manufactured by the controlled low-temperature telomerization of ethyne in the presence of an aqueous solution of CuCI and NH Cl. Reduced by hydrogen to butadiene and, finally, butane. Reacts with water in the presence of HgSO to give methyl vinyl ketone. Forms salts. Forms 2-chloro-butadiene (chloroprene) with hydrochloric acid and certain metallic chlorides. 

Figure A3.8.2 The correlation fimction k( ) for particular case of the reaction of methyl vinyl ketone with cyclopentadiene in water. The leveling-off of this function to reach a constant value at the plateau time tp is clearly seen.

Figure 1.2. Endo and exo pathway for the Diels-Alder reaction of cyclopentadiene with methyl vinyl ketone. As was first noticed by Berson, the polarity of the endo activated complex exceeds that of the exo counterpart due to alignment of the dipole moments of the diene and the dienophile K The symmetry-allowed secondary orbital interaction that is only possible in the endo activated complex is usually invoked as an explanation for the preference for endo adduct exhibited by most Diels-Alder reactions.

Figure 1.5. Chemical potential of the initial state, the transition state and the product of the Diels-Alder reaction between methyl vinyl ketone and cyclopentadiene in water as compared to 1-propanol The data are taken from r. 56.

Tire results of a study of the effect of these catalysts on the model Diels-Alder reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) are summarised in Table 4.1... 

Pyridyl)hydrazine (Aldrich), 4-acetylpyridine (Acros), N,N,N -trimethylethylenediamine (Aldrich), methylrhenium trioxide (Aldrich), InQj (Aldrich), Cu(N0j)2-3H20 (Merck), Ni(N03)2-6Il20 (Merck), Yb(OTf)3(Fluka), Sc(OTf)3 (Fluka), 2-(aminomethyl)pyridine (Acros), benzylideneacetone (Aldrich), and chalcone (Aldrich) were of the highest purity available. Borane dimethyl sulfide (2M solution in THE) was obtained from Aldrich. Methyl vinyl ketone was distilled prior to use. Cyclopentadiene was prepared from its dimer immediately before use. (R)-l-acetyl-5-isopropoxy-3-pyrrolin-2-one (4.15) has been kindly provided by Prof H. Hiemstra (University of Amsterdam). 

Kinetic measurements were performed employii UV-vis spectroscopy (Perkin Elmer "K2, X5 or 12 spectrophotometer) using quartz cuvettes of 1 cm pathlength at 25 0.1 C. Second-order rate constants of the reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) were determined from the pseudo-first-order rate constants obtained by followirg the absorption of 4.6 at 253-260 nm in the presence of an excess of 4.8. Typical concentrations were [4.8] = 18 mM and [4.6] = 0.1 mM. In order to ensure rapid dissolution of 4.6, this compound was added from a stock solution of 5.0 )j1 in 2.00 g of 1-propanol. In order to prevent evaporation of the extremely volatile 4.6, the cuvettes were filled almost completely and sealed carefully. The water used for the experiments with MeReOj was degassed by purging with argon for 0.5 hours prior to the measurements. All rate constants were reproducible to within 3%. 

Finally a general approach to synthesize A -pyrrolines must be mentioned. This is tl acid-catalyzed (NH4CI or catalytic amounts of HBr) and thermally (150°C) induced tea rangement of cyclopropyl imines. These educts may be obtained from commercial cyan> acetate, cyclopropyl cyanide, or benzyl cyanide derivatives by the routes outlined below. Tl rearrangement is reminiscent of the rearrangement of 1-silyloxy-l-vinylcyclopropancs (p. 7 83) but since it is acid-catalyzed it occurs at much lower temperatures. A -Pyrrolines constitut reactive enamines and may be used in further addition reactions such as the Robinson anei lation with methyl vinyl ketone (R.V. Stevens, 1967, 1968, 1971). 

Thallation of aromatic compounds with thallium tris(trifluoroacetate) proceeds more easily than mercuration. Transmetallation of organothallium compounds with Pd(II) is used for synthetic purposes. The reaction of alkenes with arylthallium compounds in the presence of Pd(Il) salt gives styrene derivatives (433). The reaction can be made catalytic by use of CuCl7[393,394], The aryla-tion of methyl vinyl ketone was carried out with the arylthallium compound 434[395]. The /9-alkoxythallium compound 435, obtained by oxythallation of styrene, is converted into acetophenone by the treatment with PdCh[396]. 

The carbopalladation of allylamine with malonate affords the chelating complex 510, which undergoes insertion of methyl vinyl ketone to form the amino enone 511[463]. The allylic sulfide 512 has the same chelating effect to give the five-membered complex 513 by carbopalladation[463.464]. 

In the reaction of Q,/3-unsaturated ketones and esters, sometimes simple Michael-type addition (insertion and hydrogenolysis, or hydroarylation, and hydroalkenylation) of alkenes is observed[53,54]. For example, a simple addition product 56 to methyl vinyl ketone was obtained by the reaction of the heteroaromatic iodide 55[S5]. The corresponding bromide affords the usual insertion-elimination product. Saturated ketones are obtained cleanly by hydroarylation of o,/3l-unsaturated ketones with aryl halides in the presence of sodium formate, which hydrogenolyses the R—Pd—I intermediate to R— Pd—H[56]. Intramolecular hydroarylation is a useful reaction. The diiodide 57 reacts smoothly with sodium formate to give a model compound for the afla-toxin 58. (see Section 1.1.6)[57]. Use of triethylammonium formate and BU4NCI gives better results. 

A solution of l-methylpyrano[4,3-b]indol-3-one (1 mmol) and methyl vinyl ketone (5 ml) in toluene (5 ml) containing 5% Pd/C (40 mg) was heated for 48 h in a sealed tube at 110°C. The reaction mixture was evaporated in vacuo and the residue purified by silica gel chromatography to give the product in 80% yield. 

In this reaction the enolate of diethyl malonate adds to the p carbon of methyl vinyl ketone... 

Methyl Vinyl Ketone. Methyl vinyl ketone [78-94-4] (3-buten-2-one) is a colorless Hquid with a pungent odor. It is stable only below 0°C, and readily polymerizes on standing at room temperature. It can be inhibited for storage and transportation by a mixture of acetic or formic acid and hydroquinone or catechol (266). This ketone is completely soluble in water, and forms a binary azeotrope with water (85 MVK 15 H2O vol %) at 75.8°C. 

Methyl vinyl ketone can be produced by the reactions of acetone and formaldehyde to form 4-hydroxy-2-butanone, followed by dehydration to the product (267,268). Methyl vinyl ketone can also be produced by the Mannich reaction of acetone, formaldehyde, and diethylamine (269). Preparation via the oxidation of saturated alcohols or ketones such as 2-butanol and methyl ethyl ketone is also known (270), and older patents report the synthesis of methyl vinyl ketone by the hydration of vinylacetylene (271,272). 

Methyl vinyl ketone is used as a comonomer in photodegradable plastics, and is an intermediate in the synthesis of steroids and vitamin A. It is highly toxic and faciUties handling over a threshold of 100 lbs (45.5 kg) are subject to special OSHA documentation regulations (273). 

Methyl Isopropenyl Ketone. Methyl isopropenyl ketone [814-78-8] (3-methyl-3-buten-2-one) is a colorless, lachrymatory Hquid, which like methyl vinyl ketone readily polymerizes on exposure to heat and light. Methyl isopropenyl ketone is produced by the condensation of methyl ethyl ketone and formaldehyde over an acid cation-exchange resin at 130°C and 1.5 MPa (218 psi) (274). Other methods are possible (275—280). Methyl isopropenyl ketone can be used as a comonomer which promotes photochemical degradation in polymeric materials. It is commercially available in North America (281). 

Diketones are readily transformed to cycHc derivatives, such as cyclopentanones and furans. In this manner, the fragrance dihydrojasmone (3-meth5l-2-pentyl-2-cyclopenten-l-one) is prepared by the base-catalyzed aldol condensation of 2,5-undecanedione. 2,5-Undecanedione is itself prepared from heptanal and methyl vinyl ketone in the presence of thiazoHum salts (329). i7j -Jasmone can be similarly prepared (330,331). 

Nitroparaffins add 1,4 to conjugated systems methyl vinyl ketones, for example, yield the corresponding y-nitro ketone, which can be reduced to a y-nitro alcohol (48). More than one vinyl group may react with primary nitroparaffins (49). 

Poly(vinyl alcohol) undergoes Michaels addition with compounds containing activated double bonds, including acrylonitrile (145—150), acrylamide (151—153), A/-methylolacrylamide (154—156), methyl vinyl ketone (157,158), acrolein (157), and sodium 2-acrylamido-2-methylpropanesulfonate (159). The reactions have been carried out under conditions spanning from homogeneous reactions in solvent to heterogeneous reactions occurring in the swollen powder or fiber. 

---