Metathesis reversibility

Applications of the olefin metathesis reversible chemical reaction, discovered by Phillips Petroleum in the 1960s, were also developed in the subsequent years. By this reaction, Arco produces propylene from ethylene and butene-2 Hercules prepares its plastic, Metton, from dicyclopentadiene and Shell synthesizes its C12-C14 SHOP (Shell Higher Olefin Process) alcohols used for detergents. 

Disproportionation of Olefins. Disproportionation or the metathesis reaction offers an opportunity to convert surplus olefins to other desirable olefins. Phillips Petroleum and Institut Fransais du Petrc le have pioneered this technology for the dimerization of light olefins. The original metathesis reaction of Phillips Petroleum was intended to convert propylene to 2-butene and ethylene (58). The reverse reaction that converts 2-butene in the presence of excess ethylene to propylene has also been demonstrated (59). A commercial unit with a capacity of about 136,000 t/yr of propylene from ethylene via 2-butene has been in operation in the Gulf Coast since 1985 (60,61). In this process, ethylene is first dimerized to 2-butene foUowed by metathesis to yield propylene. Since this is a two-stage process, 2-butene can be produced from the first stage, if needed. In the dimerization step, about 95% purity of 2-butene is achieved at 90% ethylene conversion. 

Metathesis reactions are sometimes the reverse of those in aqueous systems because of the differing solubility relations. For example because AgBr forms the complex ion [Ag(NH3)2]" " in liquid NH3 it is readily soluble, whereas BaBr2 is not, and can be precipitated ... 

The reversal of ring-closing metathesis, namely ring-opening metathesis, is also a synthetically useful reaction. With strained (small-ring) cycloalkenes, e.g. 12, the equilibrium of the reaction lies on the side of the open-chain product 13 ... 

Olefin metatheses are equilibrium reactions among the two-reactant and two-product olefin molecules. If chemists design the reaction so that one product is ethylene, for example, they can shift the equilibrium by removing it from the reaction medium. Because of the statistical nature of the metathesis reaction, the equilibrium is essentially a function of the ratio of the reactants and the temperature. For an equimolar mixture of ethylene and 2-butene at 350°C, the maximum conversion to propylene is 63%. Higher conversions require recycling unreacted butenes after fractionation. This reaction was first used to produce 2-butene and ethylene from propylene (Chapter 8). The reverse reaction is used to prepare polymer-grade propylene form 2-butene and ethylene ... 

Olefin metathesis is the transition-metal-catalyzed inter- or intramolecular exchange of alkylidene units of alkenes. The metathesis of propene is the most simple example in the presence of a suitable catalyst, an equilibrium mixture of ethene, 2-butene, and unreacted propene is obtained (Eq. 1). This example illustrates one of the most important features of olefin metathesis its reversibility. The metathesis of propene was the first technical process exploiting the olefin metathesis reaction. It is known as the Phillips triolefin process and was run from 1966 till 1972 for the production of 2-butene (feedstock propene) and from 1985 for the production of propene (feedstock ethene and 2-butene, which is nowadays obtained by dimerization of ethene). Typical catalysts are oxides of tungsten, molybdenum or rhenium supported on silica or alumina [ 1 ]. 

As stated above, olefin metathesis is in principle reversible, because all steps of the catalytic cycle are reversible. In preparatively useful transformations, the equilibrium is shifted to one side. This is most commonly achieved by removal of a volatile alkene, mostly ethene, from the reaction mixture. An obvious and well-established way to classify olefin metathesis reactions is depicted in Scheme 2. Depending on the structure of the olefin, metathesis may occur either inter- or intramolecularly. Intermolecular metathesis of two alkenes is called cross metathesis (CM) (if the two alkenes are identical, as in the case of the Phillips triolefin process, the term self metathesis is sometimes used). The intermolecular metathesis of an a,co-diene leads to polymeric structures and ethene this mode of metathesis is called acyclic diene metathesis (ADMET). Intramolecular metathesis of these substrates gives cycloalkenes and ethene (ring-closing metathesis, RCM) the reverse reaction is the cleavage of a cyclo-... 

While diene metathesis or diyne metathesis are driven by the loss of a (volatile) alkene or alkyne by-product, enyne metathesis (Fig. 2) cannot benefit from this contributing feature to the AS term of the reaction, since the event is entirely atom economic. Instead, the reaction is driven by the formation of conjugated dienes, which ensures that once these dienes have been formed, the process is no longer a reversible one. Enyne metathesis can also be considered as an alkylidene migration reaction, because the alkylidene unit migrates from the alkene part to one of the alkyne carbons. The mechanism of enyne metathesis is not well described, as two possible complexation sites (alkene or alkyne) exist for the ruthenium carbene, leading to different reaction pathways, and the situation is further complicated when the reaction is conducted under an atmosphere of ethylene. Despite its enormous potential to form mul-... 

Diene 265, substituted by a bulky silyl ether to prevent cycloaddition before the metathesis process, produced in the presence of catalyst C the undesired furanophane 266 with a (Z) double bond as the sole reaction product in high yield. The same compound was obtained with Schrock s molybdenum catalyst B, while first-generation catalyst A led even under very high dilution only to an isomeric mixture of dimerized products. The (Z)-configured furanophane 266 after desilylation did not, in accordance with earlier observations, produce any TADA product. On the other hand, dienone 267 furnished the desired macrocycle (E)-268, though as minor component in a 2 1 isomeric mixture with (Z)-268. Alcohol 269 derived from E-268 then underwent the projected TADA reaction selectively to produce cycloadduct 270 (70% conversion) in a reversible process after 3 days. The final Lewis acid-mediated conversion to 272 however did not occur, delivering anhydrochatancin 271 instead. 

The reversible nature of cross metathesis is of synthetic importance because, by the use of a sufficiently active metathesis catalyst, it generally ensures the preferential formation of the most thermodynamically stable product. This results in the transformation of terminal olefins into internal ones, and we have seen that undesired self-metathesis products can be recycled by exposing them to a second CM process. 

While alkane metathesis is noteworthy, it affords lower homologues and especially methane, which cannot be used easily as a building block for basic chemicals. The reverse reaction, however, which would incorporate methane, would be much more valuable. Nonetheless, the free energy of this reaction is positive, and it is 8.2 kj/mol at 150 °C, which corresponds to an equihbrium conversion of 13%. On the other hand, thermodynamic calculation predicts that the conversion can be increased to 98% for a methane/propane ratio of 1250. The temperature and the contact time are also important parameters (kinetic), and optimal experimental conditions for a reaction carried in a continuous flow tubiflar reactor are as follows 300 mg of [(= SiO)2Ta - H], 1250/1 methane/propane mixture. Flow =1.5 mL/min, P = 50 bars and T = 250 °C [105]. After 1000 min, the steady state is reached, and 1.88 moles of ethane are produced per mole of propane consmned, which corresponds to a selectivity of 96% selectivity in the cross-metathesis reaction (Fig. 4). The overall reaction provides a route to the direct transformation of methane into more valuable hydrocarbon materials. 

E.O. Fischer s discovery of (CO)sW[C(Ph)(OMe)D in 1964 marks the beginning of the development of the chemistry of metal-carbon double bonds (1). At about this same time the olefin metathesis reaction was discovered (2), but It was not until about five years later that Chauvln proposed (3) that the catalyst contained an alkylidene ligand and that the mechanism consisted of the random reversible formation of all possible metallacyclobutane rings. Yet low oxidation state Fischer-type carbene complexes were found not to be catalysts for the metathesis of simple olefins. It is now... 

Sigma-bond metathesis at hypovalent metal centers Thermodynamically, reaction of H2 with a metal-carbon bond to produce new C—H and M—H bonds is a favorable process. If the metal has a lone pair available, a viable reaction pathway is initial oxidative addition of H2 to form a metal alkyl dihydride, followed by stepwise reductive elimination (the microscopic reverse of oxidative addition) of alkane. On the other hand, hypovalent complexes lack the... 

Olefin metathesis is a catalytic process whose key step is a reaction between an olefin and a transition metal alkylidene complex, usually M=CHR (Eq. 1) or M= CH2, in a 2+2 fashion to give an unstable intermediate metalacyclobutane ring [1]. All possible reactions of this general type are reversible, possibly nonproductive, and in competition with one another, so the overall result depends heavily on relative rates, and in the case of formation of volatile or insoluble products, displacement of equilibria as those products form. 

In turn, the propensity of 1 to respond to steric hindrance can be used to control the site of initiation of an RCM reaction in a polyene substrate (Scheme 9) [20]. Thus, dienyne 25 reacts with the catalyst regioselectively at the least substituted site the evolving ruthenium carbene 26 undergoes a subsequent enyne metathesis leading to a new carbene 27, which is finally trapped by the disubsti-tuted olefin to afford the bicyclo[4.4.0]decadiene product 28. By simply reversing the substitution pattern of the double bonds, the complementary bicyclo [5.3.0] compound 32 is formed exclusively, because the cyclization cascade is then triggered at the other end of the substrate. Note that in both examples tri-substituted olefins are obtained by means of a ruthenium based metathesis catalyst [20] ... 

Considering the facility with which dimerization products 81 and 84 are obtained, we reasoned that, in catalytic ring closure of 77, the derived dimer is perhaps initially formed as well. If the metathesis process is reversible [17b], such adducts may subsequently be converted to the desired macrocycle 76. To examine the validity of this paradigm, diene 77 was dimerized (— 85) by treatment with Ru catalyst lb. When 85 was treated with 22 mol% 2 (after pretreatment with ethylene to ensure formation of the active complex), 50-55% conversion to macrolactam 76 was detected within 7 h by 400 MHz H NMR analysis (Eq. 8). When 76 was subjected to the same reaction conditions, <2% of any of the acyclic products was detected. Although we do not as yet have a positive proof that 85 is formed in cyclization of 77, this observation suggests that if dimerization were to occur, the material can be readily converted to the desired macrolactam, which is kinetically immune to cleavage. 

Like styrene, acrylonitrile is a non-nucleophilic alkene which can stabilise the electron-rich molybdenum-carbon bond and therefore the cross-/self-metathe-sis selectivity was similarly dependent on the nucleophilicity of the second alkene [metallacycle 10 versus 12, see Scheme 2 (replace Ar with CN)]. A notable difference between the styrene and acrylonitrile cross-metathesis reactions is the reversal in stereochemistry observed, with the cis isomer dominating (3 1— 9 1) in the nitrile products. In general, the greater the steric bulk of the alkyl-substituted alkene, the higher the trans cis ratio in the product (Eq. 11). 

Aside from two-center (Patterns 1 and 2) and three-center (Patterns 3, 4, 11, and 12) processes, most of the processes shown in Scheme 1.3 are four-center processes involving either addition (Patterns 5—10) or 0-bond metathesis (Pattern 13). In this context, it should be noted that addition is simply a four-center metathesis in which one molecule happens to be multiply-bonded. In addition to these metathetical processes, there is yet another fundamentally important four-center metathetical process termed migratory insertion and deinsertion (Patterns 14 and 15). It should be clear from Patterns 14 and 15 shown in Scheme 1.3 that distinction between insertion and deinsertion is only a relative and semantic issue. In the current discussion, a process involving cleavage of the C—Zr bond is termed migratory insertion, while the reverse process is termed migratory deinsertion. 

On the other hand, the reaction of bisallenes with Bu3SnSnBu3 may generate cis-bisallene Pd(SnBu3)2 (C) and/or a chelated cj-allylpalladium complex D reversibly. The fast carbocydization of these intermediates would give rise to a vinylpalladium complex E, which then yields a ds-compound by reductive elimination and/or a cis-bicyclodiene through (T-bond metathesis as a kinetically controlled product (Scheme 16.66). 

Olefin metathesis proceeds via reversible formation of metallacyclobutanes by [2 + 2] cycloaddition (Figure 1.7). The precise pathway for such a cycloaddition has been calculated for molybdenum complexes such as 1 (Figure 1.6) [9]. These calculations suggest that although Mo-C and C-C bond formation is concerted the Mo-C bond is formed more quickly than the C-C bond. It was also found, beautifully consistent with experimental results, that the activation barrier for [2 + 2] cycloaddition is lowered by increasingly electron-withdrawing alkoxy ligands. 

Metallacyclobutanes or other four-membered metallacycles can serve as precursors of certain types of carbene complex. [2 + 2] Cycloreversion can be induced thermally, chemically, or photochemically [49,591-595]. The most important application of this process is carbene-complex-catalyzed olefin metathesis. This reaction consists in reversible [2 + 2] cycloadditions of an alkene or an alkyne to a carbene complex, forming an intermediate metallacyclobutane. This process is discussed more thoroughly in Section 3.2.5. 

---