Metal ion potential

Three kinds of equilibrium potentials are distinguishable. A metal-ion potential exists if a metal and its ions are present in balanced phases, e.g., zinc and zinc ions at the anode of the Daniell element. A redox potential can be found if both phases exchange electrons and the electron exchange is in equilibrium for example, the normal hydrogen half-cell with an electron transfer between hydrogen and protons at the platinum electrode. In the case where a couple of different ions are present, of which only one can cross the phase boundary — a situation which may exist at a semiperme-able membrane — one obtains a so called membrane potential. Well-known examples are the sodium/potassium ion pumps in human cells. 

Nernst Equation for the Concentration Dependence of Metal/Metal-Ion Potential. 

Recently there has been interest in the sorptive behavior of natural clays toward metal ions potentially present in radioactive wastes. Initial studies of the transplutonium elements have been carried out to define their sorption behavior with such materials ( ). However, it is also important to understand the stability of the clay-actinide product with regard to radiation damage and to be able to predict what changes in behavior may occur after exposure to radiation, so that accurate transport models may be constructed. 

The Nernst Equation for the Concentration Dependence of Metal/Metal-Ion Potential. In the general case of a metal/metal-ion electrode, a metal M is in an equilibrium with its ions in the solution... 

There are two types of interfacial potential differences equilibrium and non-equilibrium potentials. (From now on we will use potential as shorthand for potential difference . Potentials of individual phases cannot be measured, but some potential differences can be.) The equilibrium potentials can again be subdivided into two categories electron transfer and ion transfer potentials. The metal/metal ion potentials can be considered as... 

As discussed above, concentration gradients will produce a potential drop. Because of the electrode reaction even at equilibrium, that is, with no current flow, there will be a potential drop. The formation of this metal-electrolyte potential difference, which is based on a metal-ion potential, arises from the transfer of metal ions from the metal into the electrolyte, and vice versa. This transfer of metal ions through the electric double layer (here assumed infinitely thin) takes place simultaneously in both directions. The amount of this transference is generally not equal in both directions and gives rise to the metal-electrolyte potential difference. This electrode potential is the potential difference that forms at the boundaries of the two phases. 

A metal ion potential exists if a metal and its ions are present in balanced phases, for example, zinc and zinc ions at the anode of the Daniell element... 

Corrosion protection of metals can take many fonns, one of which is passivation. As mentioned above, passivation is the fonnation of a thin protective film (most commonly oxide or hydrated oxide) on a metallic surface. Certain metals that are prone to passivation will fonn a thin oxide film that displaces the electrode potential of the metal by +0.5-2.0 V. The film severely hinders the difflision rate of metal ions from the electrode to tire solid-gas or solid-liquid interface, thus providing corrosion resistance. This decreased corrosion rate is best illustrated by anodic polarization curves, which are constructed by measuring the net current from an electrode into solution (the corrosion current) under an applied voltage. For passivable metals, the current will increase steadily with increasing voltage in the so-called active region until the passivating film fonns, at which point the current will rapidly decrease. This behaviour is characteristic of metals that are susceptible to passivation. 

At potentials positive to the bulk metal deposition, a metal monolayer-or in some cases a bilayer-of one metal can be electrodeposited on another metal surface this phenomenon is referred to as underiDotential deposition (upd) in the literature. Many investigations of several different metal adsorbate/substrate systems have been published to date. In general, two different classes of surface stmetures can be classified (a) simple superstmetures with small packing densities and (b) close-packed (bulklike) or even compressed stmetures, which are observed for deposition of the heavy metal ions Tl, Hg and Pb on Ag, Au, Cu or Pt (see, e.g., [63, 64, 65, 66, 62, 68, 69 and 70]). In case (a), the metal adsorbate is very often stabilized by coadsorbed anions typical representatives of this type are Cu/Au (111) (e.g. [44, 45, 21, 22 and 25]) or Cu/Pt(l 11) (e.g. [46, 74, 75, and 26 ]) It has to be mentioned that the two dimensional ordering of the Cu adatoms is significantly affected by the presence of coadsorbed anions, for example, for the upd of Cu on Au(l 11), the onset of underiDotential deposition shifts to more positive potentials from 80"to Br and CE [72]. 

In an aquo-complex, loss of protons from the coordinated water molecules can occur, as with hydrated non-transition metal ions (p. 45). To prevent proton loss by aquo complexes, therefore, acid must usually be added. It is for these conditions that redox potentials in Chapter 4 are usually quoted. Thus, in acid solutions, we have... 

So far the four metal ions have been compared with respect to their effect on (1) the equilibrium constant for complexation to 2.4c, (2) the rate constant of the Diels-Alder reaction of the complexes with 2.5 and (3) the substituent effect on processes (1) and (2). We have tried to correlate these data with some physical parameters of the respective metal-ions. The second ionisation potential of the metal should, in principle, reflect its Lewis acidity. Furthermore the values for Iq i might be strongly influenced by the Lewis-acidity of the metal. A quantitative correlation between these two parameters... 

The metal-ion complexmg properties of crown ethers are clearly evident m their effects on the solubility and reactivity of ionic compounds m nonpolar media Potassium fluoride (KF) is ionic and practically insoluble m benzene alone but dissolves m it when 18 crown 6 is present This happens because of the electron distribution of 18 crown 6 as shown m Figure 16 2a The electrostatic potential surface consists of essentially two regions an electron rich interior associated with the oxygens and a hydrocarbon like exterior associated with the CH2 groups When KF is added to a solution of 18 crown 6 m benzene potassium ion (K ) interacts with the oxygens of the crown ether to form a Lewis acid Lewis base complex As can be seen m the space filling model of this... 

Anodic stripping voltammetry consists of two steps (Figure 11.37). The first is a controlled potential electrolysis in which the working electrode, usually a hanging mercury drop or mercury film, is held at a cathodic potential sufficient to deposit the metal ion on the electrode. For example, with Cu + the deposition reaction is... 

Potentiometric electrodes are divided into two classes metallic electrodes and membrane electrodes. The smaller of these classes are the metallic electrodes. Electrodes of the first kind respond to the concentration of their cation in solution thus the potential of an Ag wire is determined by the concentration of Ag+ in solution. When another species is present in solution and in equilibrium with the metal ion, then the electrode s potential will respond to the concentration of that ion. Eor example, an Ag wire in contact with a solution of Ck will respond to the concentration of Ck since the relative concentrations of Ag+ and Ck are fixed by the solubility product for AgCl. Such electrodes are called electrodes of the second kind. 

EthylenediaminetetraaceticAcid. Ethylenediaminetetraacetic acid (EDTAH has six potential donor groups two nitrogen atoms and four carboxylate groups. If EDTA 4— acts as a hexadentate ligand to a metal, the resulting complex contains five five-membered chelate rings and has a charge that is four less than that of the metal ion. 

Interestingly, the Mo2S " 4 (Fig- 3f) core stmcture can be viewed as occupying six of the eight vertices of a distorted cube. Reaction of the dinuclear complexes having the Mo2S " 4 core with appropriate metal ions leads to the plaimed assembly of M2M02S4 thiocubane stmctures (19,20). When M = Co (Fig. 3h) the compounds are potential precursors for hydrodesulfurization catalysts (15). 

Metal Deactivators. The abiUty of metal ions to catalyse oxidation can be inhibited by metal deactivators (19). These additives chelate metal ions and increase the potential difference between the oxidised and reduced states of the metal ions. This decreases the abiUty of the metal to produce radicals from hydroperoxides by oxidation and reduction (eqs. 15 and 16). Complexation of the metal by the metal deactivator also blocks its abiUty to associate with a hydroperoxide, a requirement for catalysis (20). 

The performance of many metal-ion catalysts can be enhanced by doping with cesium compounds. This is a result both of the low ionization potential of cesium and its abiUty to stabilize high oxidation states of transition-metal oxo anions (50). Catalyst doping is one of the principal commercial uses of cesium. Cesium is a more powerflil oxidant than potassium, which it can replace. The amount of replacement is often a matter of economic benefit. Cesium-doped catalysts are used for the production of styrene monomer from ethyl benzene at metal oxide contacts or from toluene and methanol as Cs-exchanged zeofltes ethylene oxide ammonoxidation, acrolein (methacrolein) acryflc acid (methacrylic acid) methyl methacrylate monomer methanol phthahc anhydride anthraquinone various olefins chlorinations in low pressure ammonia synthesis and in the conversion of SO2 to SO in sulfuric acid production. 

By buffering the metal ion concentration using a chelant, E can be adjusted to and stabilized at values that give desirable properties to the deposit. Selective buffering can sequester the properties of interfering ions or can be used to regulate the potentials of two or more ions to approximately the same value in order to effect codeposition. 

---