Magnetic fields resolution

A SQUID [2] provides two basic advantages for measuring small variations in the magnetic field caused by cracks [3-7]. First, its unsurpassed field sensitivity is independent of frequency and thus dc and ac fields can be measured with an resolution of better than IpT/VHz. Secondly, the operation of the SQUID in a flux locked loop can provide a more than sufficient dynamic range of up to 160 dB/VHz in a shielded environment, and about 140 dB/>/Hz in unshielded environment [8]. 

Sensitive parameters are necessary to compare several high resolution magnetic field sensors. Such parameters can be found with methods of signal theory for LTI-systems. The following chapter explains characteristic functions and operations of the signal analysis for linear local invariant systems and their use in non-destructive testing. 

So, a comparison of different types of magnetic field sensors is possible by using the impulse response function. High amplitude and small width of this bell-formed function represent a high local resolution and a high signal-to-noise-characteristic of a sensor system. On the other hand the impulse response can be used for calculation of an unknown output. In a next step it will be shown a solution of an inverse eddy-current testing problem. 

Main system parameters are shown in table 1. The fine field resolution is important. When operating in an unshielded space, however, at least such important is the high common mode rejection and the gradient rejection in order to suppress parasitic magnetic fields. 

Motion, and in particular diffiision, causes a further limit to resolution [14,15]. First, there is a physical limitation caused by spins diflfiising into adjacent voxels durmg the acquisition of a transient. For water containing samples at room temperature the optimal resolution on these grounds is about 5 pm. However, as will be seen in subsequent sections, difhision of nuclei in a magnetic field gradient causes an additional... 

Even for a single radical tire spectral resolution can be enlianced for disordered solid samples if the inliomogeneous linewidth is dominated by iimesolved hyperfme interactions. Whereas the hyperfme line broadening is not field dependent, tire anisotropic g-matrix contribution scales linearly with the external field. Thus, if the magnetic field is large enough, i.e. when the condition... 

Once the primary electron beam is created, it must be demagnified with condenser lenses and then focused onto the sample with objective lenses. These electron lenses are electromagnetic in nature and use electric and magnetic fields to steer the electrons. Such lenses are subject to severe spherical and chromatic aberrations. Therefore, a point primary beam source is blurred into a primary beam disk to an extent dependent on the energy and energy spread of the primary electrons. In addition, these lenses are also subject to astigmatism. AH three of these effects ultimately limit the primary beam spot size and hence, the lateral resolution achievable with sem. 

FT instruments of higher magnetic field strengths, providing greater spectral resolution and sensitivity... 

Magnetic resonance imaging is a noninvasive structural technique for complex systems of molecules, such as people. In its simplest form, MRI portrays the concentration of protons in a sample. If the sample—which may be a living human body—is exposed to a uniform magnetic field in an NMR spectrometer and if we work at a resolution that does not show any chemical shifts or fine structure, then the protons... 

Magnetic sector A low-resolution mass analyser in which the variation of a magnetic field is used to bring ions of different m/z ratios to a detector. 

---