Low carbon Island

Keywords Low carbon island Green transportation Economic input-output life cycle assessment Carbon footprint System dynamics... 

The related literature reviews introduce CF, low carbon island, and applications of EIO-LCA and SD approach. 

The low Carbon Island is also known as the RE Island and the Sustainable Energy Island. Chen et al. [11] said that island development problems are mostly related to imported fossil fuel energy dependence, fresh water availability, waste management, and transportation problems. However RE technology is one solution which produces energy by transforming natural phenomena (or natural resources) into useful energy forms. 

Case Study Penghu Low Carbon Island Implementation... 

This research uses the low carbon island development project implemented on Penghu Island as the case study to demonstrate the proposed methodology. Penghu is the only government county of Taiwan which is an island located between Mainland China and Taiwan [33]. In order to promote local economic growth. 

Finally, this paper uses the results of above four scenarios to compare the carbon reduction goal of the Sustainable Energy Policy 2008, Master Plan of Energy Conservation and Carbon Mitigation 2009 and the Penghu low carbon island development project 2010. We test these four scenarios to see if the carbon reduction goals are achieved. The details of policies are shown in Table 26.9. 

C) Penghu low carbon island development project 2010 This policy plans that the regional carbon emission will go back to 50 % of 2005s level in 2015 2005 7.2261 Gg-C02... 

Trappey AJC, Trappey CV, Hsiao CT, Ou JR, Li SJ, Chen KWP (2012) An evaluation model for low carbon island policy the ease of Taiwan s green transportation policy. Energy Policy 45 510-515... 

Bureau of Energy (2010) Penghu low carbon island development project, Birreau of Energy. http //www.moeaboe.gov.tw/Policy/PoMain.aspx PageId=polistS. Accessed 29 Nov 2010... 

Penghu is being developed as a natural resort and an environmental friendly island. The carbon island development project combines local features with different low carbon actions and appUcations to create a better environment. The lO analysis and LQ methods are used to assess the industrial sectors CF. And then the smdy analyzes the green transportation policy and evaluates its benefits toward CO2 emissions reduction [1, 2]. 

Trappey AJC, Trappey CV, Liu PHY (2013) Using a small island pilot plant approach to analyze low carbon emission policies. Carbon Manage 4(3) 257-260... 

Graphite was tised as substrate for the deposition of carbon vapor. Prior to the tube and cone studies, this substrate was studied by us carefully by STM because it may exhibit anomalotis behavior w ith unusual periodic surface structures[9,10]. In particular, the cluster-substrate interaction w as investigated IJ. At low submonolayer coverages, small clusters and islands are observed. These tend to have linear struc-tures[12j. Much higher coverages are required for the synthesis of nanotubes and nanocones. In addition, the carbon vapor has to be very hot, typically >3000°C. We note that the production of nanotubes by arc discharge occurs also at an intense heat (of the plasma in the arc) of >3000°C. 

Diavik Diamond Mine Inc. is located on an island in Lac de Gras, 300 km northeast of Yellowknife, NT (Fig. 1).). Open pit mining will lead to the eventual development of two 200 Mt permanent stockpiles of waste rock. The country rock consists of granite averaging <0.04 wt.% S and biotite schist averaging >0.08 wt.% S. Both rock types contain low concentrations of carbonate minerals. 

Most contaminated carbon will not be analyzed for agent but will be fed through a carbon micronization system and furnace for disposal. However, inevitably, some carbon will be left at the end (e.g., the carbon in the filtration system for the plant ventilation air while the contaminated carbon is being burned). The residual carbon will have to be shipped off the island for disposal, somewhere in the continental United States. Although concentrations of agent on the contaminated carbon are expected to be low, analysis will be required by the receiving disposal facility. 

Abstract. At this paper novel low temperature (temperature 500°C) deposition method for preparation of the carbon nanotubes cathodes is represented. This method allows to use a glass as cathode substrate. Investigated samples differ by geometry of deposited layer of the carbon nanotubes with complete cover and cover with islands of different diameters. 

---