Liquid influence

C. Draw-off of the mixed liquids influences tlie location of the impeller. For blending, the preferred impeller location in a Z/T =1.0 Vessel is at the midpoint of liquid depth for a continuous flow process, but may not be for a batch system. 

Cabral BJC, Rivail JL, Bigot B (1987) A Monte-Carlo simulation study of a polarizable liquid -influence of the electrostatic induction on its thermodynamic and structural-properties. J Chem Phys... 

Zimmerman, J. B. Kibbey, T. C. G. Cowell, M. A. Hayes, K. F. "Partitioning of Ethoxylated Nonionic Surfactants into Nonaqueous-Phase Organic Liquids Influence on Solubilization Behavior," Environ. Sci. Technol, 1999,33, 169-176. 

Simulation Study of a Polarizable Liquid Influence of the Electrostatic Induction on Its Thermodynamic and Structural Properties. 

In the case of 44 % moisture there is liquid water present in the structure and also the permeability of liquid influences the conversion time of the sample. Figure 6 shows the measured temperature profiles of Figure 1 and the two simulated Cases 6 and 7 in Table 1, simulated for liquid axial permeabilities of 10 and 10 respectively. In both cases the radial permeability is assumed to be 10 lower. It is seen from Figure 6 that the intrinsic permeability of liquid has a large influence on the pyrolysis time. A higher permeability leads to a larger transport of water through the wood and less water evaporates inside the sample, which reduces the time of conversion. 

Rencurosi A, Lay L, Russo G, Caneva E, Poletti L (2005) Glycosylation with trichloroacetimi-dates in ionic liquids influence of the reaction medium on the stereochemical outcome. J Org Chem 70 7765-7768... 

Endres E, Hoffl O, Borisenko N, Gasparotto LH, Prowald A, Al-Salman R, Carstens T, Atkin R, Bund A, El Abedin SZ (2010) Do solvation layers of ionic liquids influence electrochemical reactions Phys Chem Chem Phys 12 1724-1732... 

Lockett, V., R. Sedev, J. Ralston, M. Home, and T. Rodopoulos. 2008. Differential capacitance of the electrical double layer in imidazolium-based ionic liquids Influence of potential, cation size, and temperature. Journal of Physical Chemistry C 112 7486-7495. 

Costa, R., C. M. Pereira, and F. Silva. 2010. Double layer in room temperature ionic liquids Influence of temperature and ionic size on the differential capacitance and electrocapillary curves. Physical Chemistry Chemical Physics 12 11125-11132. 

M iscibility of liquids influenced by rate of shear. Nature, 170 (4324), 450-451. 

As shown in Tab. 1 (samples were measured perpendicular to the aligning field - long axis), all applied ionic liquids influence the cross-linking density of composites and, hence, the tensile strength (T.S.) and elongation at break (E.B). This is surely due to better dispersion of carbonyl iron particles in NBR matrix (Fig. 7, 8). Application of ILs to MRE composites, improves their mechanical properties. 

Wang, X., Vogel, C.S., Heinemann, F.W., Wasserscheid, P. and Meyer, K., Solid-state structures of double-long-chain imidazolium ionic liquids Influence of anion shape on cation geometry and crystal packing, Cryst. Growth Des. 11 (5), 1974-1988 (2011). 

On the basis of observations of work of an investigated deduster it is possible to assert that change of viscosity of an irrigated liquid influences conditions of a generating of an interphase surface and, especially, on intensity of formation of a drop layer. 

For liquids which exit a process as a jet, flow instabilities may cause the stream to break up into droplets before it impacts the ground. The size of the resulting droplets and the rate of air entrainment in the jet, as well as the initial temperature of the liquid, influence the evaporation rate of the droplets while in flight. The time of flight (drop trajectories) influences the fraction of the release which rains out, evaporates, or remains in the aerosol/vapor cloud (DeVatill et al., 1995). 

R. Fetzer and K. Jacobs, Slippage of Newtonian liquids influence on the dynamics of dewetting thin films, Langmuir, 23, 11617-11622 [2007). 

As both the Van der Waals forces and the electrostatic forces are of electrical origin, the presence of ions in the liquid influences the formation of clusters. It is thus found that the formation of floes is promoted for cohesive sediments in seawater in comparison to what is observed in fresh water. 

Lockett, V., Sedev, R., Ralston, J., Home, M., Rodopoulos, T., (2008) Differential Capacitance of the Electrical Double Layer in hnidazolium-Based Ionic liquids Influence of Potential, Cation Size, and Temperature, J. Hiys. Chem. C, 112 (190... 

How do films formed on the surface of metal as a reaction product between stressed solid and a surrounding liquid influence creep and creep-rupture of metals There is no evidence to support the suggestion of surface cracks healing-up by an oxide film. If the relation of the film thickness to the specimen diameter is relatively large (thin wires) compared with common samples, load capacity of the film is a valid hypothesis. For example, a decrease in TY S of single cadmium crystal covered by thick oxide film from 25% to zero was found with an increase in the sample diameter from 0.3 to 2.8 mm [6]. 

Another type of flow is in the pores when the surface of pores is wetted by liquid. According to [62,63], the viscous friction of liquid influences the type of flow. The flow rate is proportional to time in the power of 0.2-0.3. 

Basile A, Bhatt AI, O Mullane AP, Bhargava SK (2011) An investigation of silver electrodeposition from ionic liquids influence of atmospheric water uptake on the silver electrodeposition mechanism and film morphology. Electrochim Acta 56 2895-2905... 

---