Kinetic isotope effects oxidation

Kinetic isotope effect. The oxidation of benzaldehyde by permanganate ions is believed to occur by hydride abstraction. What value of k /kD do you predict for C6H5CHO/ C6H5CDO For C6H5CHO/C6D5CHO ... 

The oxidation by Cr(VI) of aliphatic hydrocarbons containing a tertiary carbon atom has been studied by several groups of workers. Sager and Bradley showed that oxidation of triethylmethane yields triethylcarbinol as the primary product with a primary kinetic isotope effect of about 1.6 (later corrected by Wiberg and Foster to 3.1) for deuterium substitution at the tertiary C-H bond. Oxidations... 

Interest has been shown by several groups on the effect of solvent and of added anions upon the oxidation of alcohols. The oxidation of isopropanol proceeds 2500 times faster in 86.5 % acetic acid than in water at the same hydrogen ion concentration . The kinetics and primary kinetic isotope effect are essentially the same as in water. Addition of chloride ion strongly inhibits the oxidation and the spectrum of chromic acid is modified. The effect of chloride ion was rationalised in terms of the equilibrium,... 

The oxidation by basic permanganate of phenyltrifluoromethyl carbinols which has the same rate law as benzydrol, is characterised by very large primary kinetic isotope effects (c/. Cr(VI) p. 307). 

KINETIC ISOTOPE EFFECTS AND ARRHENIUS PARAMETERS FOR THE OXIDATION OF FLUORAL HYDRATE BY Mn(VH) AND Mn(VI)... 

The reaction between permangante ion and neutral formic acid follows similar bimolecular kinetics with k2 = 1.1 x 10 exp(—16.4x 10 /lt7 )l.mole . sec . No primary kinetic isotope effect was found for this path either in light or heavy water. However, Mocek and Stewart have reported that in very strong sulphuric acid the oxidations of neutral substrate by both HMnO and MnOj display substantial isotope effects. 

Kemp and Waters found a primary kinetic isotope effect of 8.7 for oxidation of C-deuterated mandelic acid and noted a large difference in rate between the oxidations of mandelic acid k at 24.4 °C = 1.7 l.mole . sec ) and a-hydroxy-isobutyric acid ( 2 at 24.4 °C = 5.6 x 10 l.mole . sec ) — a difference not reproduced for the oxidation of these compounds by the one-equivalent reagent, manganic sulphate. The various data are fully in accord with a Westheimer-type mechanism, viz. 

One interesting difference between Pd(II) in aqueous and acetic acid solutions is that whilst oxidation of C2D4 by aqueous Pd(II) displays no primary kinetic isotope effect, the oxidation of CH3-CD-CH2 by PdCl2 in acetic acid-isooctane affords a value of 2.8. The products are a mixture of propenyl and... 

Typical non-enolising aldehydes are formaldehyde and benzaldehyde, which are oxidised by Co(III) Ce(IV) perchlorate and sulphate , and Mn(III) . The main kinetic features and the primary kinetic isotope effects are the same as for the analogous cyclohexanol oxidations (section 4.3.5) and it is highly probable that the same general mechanism operates. kif olko20 for Co(III) oxidation of formaldehyde is 1.81 (ref. 141), a value in agreement with the observed acid-retardation, i.e. not in accordance with abstraction of a hydroxylic hydrogen atom from H2C(OH)2-The V(V) perchlorate oxidations of formaldehyde and chloral hydrate display an unusual rate expression, viz. 

Kinetic data exist for all these oxidants and some are given in Table 12. The important features are (i) Ce(IV) perchlorate forms 1 1 complexes with ketones with spectroscopically determined formation constants in good agreement with kinetic values (ii) only Co(III) fails to give an appreciable primary kinetic isotope effect (Ir(IV) has yet to be examined in this respect) (/ ) the acidity dependence for Co(III) oxidation is characteristic of the oxidant and iv) in some cases [Co(III) Ce(IV) perchlorate , Mn(III) sulphate ] the rate of disappearance of ketone considerably exceeds the corresponding rate of enolisation however, with Mn(ril) pyrophosphate and Ir(IV) the rates of the two processes are identical and with Ce(IV) sulphate and V(V) the rate of enolisation of ketone exceeds its rate of oxidation. (The opposite has been stated for Ce(IV) sulphate , but this was based on an erroneous value for k(enolisation) for cyclohexanone The oxidation of acetophenone by Mn(III) acetate in acetic acid is a crucial step in the Mn(II)-catalysed autoxidation of this substrate. The rate of autoxidation equals that of enolisation, determined by isotopic exchange , under these conditions, and evidently Mn(III) attacks the enolic form. 

This is in accordance with the primary kinetic isotope effect for Mn(III) sulphate With Co(III) electron abstraction may occur to give a radical-cation which suffers further oxidation. The alternative explanation of the lack of an isotope effect is that formation of the Co(III)-ketone complex is rate-determining this lacks, however, other kinetic support . ... 

The oxidations of formic acid by Co(III) and V(V) are straightforward, being first-order with respect to both oxidant and substrate and acid-inverse and slightly acid-catalysed respectively. The primary kinetic isotope effects are l.Sj (25°C)forCo(IU)and4.1 (61.5 C°)for V(V). The low value for Co(lII) is analogous to those for Co(IIl) oxidations of secondary alcohols, formaldehyde and m-nitrobenzaldehyde vide supra). A djo/ h20 for the Co(III) oxidation is about 1.0, which is curiously high for an acid-inverse reaction . The mechanisms clearly parallel those for oxidation of alcohols (p. 376) where Rj and R2 become doubly bonded oxygen. 

The first term was found to correspond to the rate of enolisation (measured by an NMR study of hydrogen-deuterium exchange at the methylene group). The second term predominates at [Cu(II)] > 10 M and is characterised by a primary kinetic isotope effect of 7.4 (25 °C) and a p value of 1.24. Addition of 2,2 -bipridyl (bipy) caused an increase in 2 up to a bipy Cu(II) ratio of 1 1 but at ratios greater than this 2 fell gradually until the enolisation term dominated. The oxidation of a-methoxyacetophenone is much slower but gives a similar rate... 

One-step hydroxylation of aromatic nucleus with nitrous oxide (N2O) is among recently discovered organic reactions. A high eflSciency of FeZSM-5 zeolites in this reaction relates to a pronounced biomimetic-type activity of iron complexes stabilized in ZSM-5 matrix. N2O decomposition on these complexes produces particular atomic oj gen form (a-oxygen), whose chemistry is similar to that performed by the active oxygen of enzyme monooxygenases. Room temperature oxidation reactions of a-oxygen as well as the data on the kinetic isotope effect and Moessbauer spectroscopy show FeZSM-5 zeolite to be a successfiil biomimetic model. 

Chen YX, Heinen M, Jusys Z, Behm RJ. 2007. Kinetic isotope effects in complex reaction networks Formic acid electro-oxidation. ChemPhysChem 8 380-385. 

Kinetic Isotope Effect in Oxidation of Aliphatic Compounds by Ozone... 

The kinetic isotope effect proves the attack of ozone on the C—H bond and consequently the C—D bond of the oxidized compound. The values of the kinetic isotope effect (kH/kD) are collected in Table 3.6. 

Phenols decrease the intensity of CL 7chi in oxidized hydrocarbons as a result of chain termination by the reaction with peroxyl radicals. Since Icu [R02 ]2 (see Chapter 2), the ratio (/0//)12 was found to be proportional to [ArOH] [7]. The kinetic isotope effect (k0K/k0n 1) proves that the peroxyl radical abstracts a hydrogen atom from the O—H bond of phenol [2,8]. 

The authors have also synthesized134 fatty acids labelled with deuterium and carbon-11 in order to investigate if kinetic isotope effects related to fatty acid metabolism can be observed in vivo by pet133,135-137. In vitro, the large kinetic deuterium isotope effects are observed in the oxidation of deuteriated aliphatic carboxylic acids with alkaline permanganate and manganate135-139. 

TABLE 16. The hydrogen-deuterium kinetic isotope effects measured for the oxidation of mandelic acid" by Pb(OAc)4 in benzene and in benzene-pyridine... 

The pyridine-catalysed lead tetraacetate oxidation of benzyl alcohols shows a first-order dependence in Pb(OAc)4, pyridine and benzyl alcohol concentration. An even larger primary hydrogen kinetic isotope effect of 5.26 and a Hammett p value of —1.7 led Baneijee and Shanker187 to propose that benzaldehyde is formed by the two concurrent pathways shown in Schemes 40 and 41. Scheme 40 describes the hydride transfer mechanism consistent with the negative p value. In the slow step of the reaction, labilization of the Pb—O bond resulting from the coordination of pyridine occurs as the Ca—H bond is broken. The loss of Pb(OAc)2 completes the reaction with transfer of +OAc to an anion. 

In the mechanism study of /V-benzyl-/V -alkyl hydroxylamines, regarding oxidation with HgO and p-benzoquinone, it has been proposed on the basis of intra- and intermolecular kinetic isotope effects that, initially, there takes place a one-electron transfer from a nitrogen atom to the oxidant, with a subsequent proton abstraction (106—108). 

VANONI, M.A., MATTHEWS, R.G., Kinetic isotope effects on the oxidation of reduced nicotinamide adenine dinucleotide phosphate by the flavoprotein methylenetetrahydrofolate reductase, Biochemistry, 1984, 23, 5272-5279. 

Palladium-catalyzed room-temperature >rtfe>-alkenylations of anilides have been recently reported, employing benzoquinone as a stoichiometric oxidant. A kinetic isotope effect kn/koof 3 points to a slow C-H functionalization step. Electron-rich acetanilides react faster whereas anilines are unreactive (Equation (138)).120... 

Further evidence for the Aa11 mechanism was obtained from a solvent kinetic isotope study. The theoretical kinetic isotope effects for intermediates in the three reaction pathways as derived from fractionation factors are indicated in parentheses in Scheme 6.143,144 For the Aa11 mechanism (pathway (iii)) a solvent KIE (/ch2o A d2o) between 0.48 and 0.33 is predicted while both bimolecular processes (pathways (i) and (ii)) would have greater values of between 0.48 and 0.69. Acid-catalysed hydrolysis of ethylene oxide derivatives and acetals, which follow an A1 mechanism, display KIEs in the region of 0.5 or less while normal acid-catalysed ester hydrolyses (AAc2 mechanism) have values between 0.6 and 0.7.145,146... 

---