Hydroquinone hydrogenation

Atrazine. Ethylamine. Ethylenimine. Toluene Hydrogen peroxide, see Acetaldehyde. Aniline. 1.1-Dimethylhydrazine. TV.Af-Dimethylaniline. Formaldehyde. Hydroquinone. Hydrogen peroxide. 

Adams platinum than over 5% Rh-Al203. Resorcinol and hydroquinone hydrogenate faster than catechol over both platinum and rhodium catalysts. In particular, it is noted that, over platinum, resorcinol and hydroquinone hydrogenate as fast as or even faster than phenol, and, at the same time, the proportions of hydrogenolysis with these di-hydroxybenzenes are much greater than with phenol and catechol. 

The heat capacity of the hydroquinone hydrogen sulphide clathrate (x = 0.95) was measured between 1 and 300 K [13]. A peak occurred at (7.6 0.1) K. No anomaly was found above that temperature. The... 

THE HYDROQUINONE METHANOL AND HYDROQUINONE HYDROGEN CYANIDE CLATHRATE COMPOUNDS... 

CnHiiN 8.67 H2O, Diethylamine hydrate, 32B, 288 CijHiiN 9.75 H2O, t-Butylamine hydrate, 32B, 289 Ci,H2oFNOii, Tetramethylammonium fluoride tetrahydrate, 32B, 291 C4H23NO6, Tetramethylammonium hydroxide pentahydrate, 31B, 282 C6Hg02 0.33 HCl, Hydroquinone hydrogen chloride clathrate, 43B,... 

C16H36FN 32.8 H2O, Tetra-n-butylammonium fluoride hydrate, 28, 578 CisHigOg 0.768 H2S, Hydroquinone - hydrogen sulfide clathrate,... 

Dihydroxyacetophenone. Finely powder a mixture of 40 g. of dry hydroquinone diacetate (1) and 87 g. of anhydrous aluminium chloride in a glass mortar and introduce it into a 500 ml. round-bottomed flask, fitted with an air condenser protected by a calcium chloride tube and connected to a gas absorption trap (Fig. II, 8, 1). Immerse the flask in an oil bath and heat slowly so that the temperature reaches 110-120° at the end of about 30 minutes the evolution of hydrogen chloride then hegins. Raise the temperature slowly to 160-165° and maintain this temperature for 3 hours. Remove the flask from the oil bath and allow to cool. Add 280 g. of crushed ice followed by 20 ml. of concentrated hydrochloric acid in order to decompose the excess of aluminium chloride. Filter the resulting solid with suction and wash it with two 80 ml. portions of cold water. Recrystallise the crude product from 200 ml. of 95 per cent, ethanol. The 3 ield of pure 2 5-dihydroxyacetophenone, m.p. 202-203°, is 23 g. 

Vinyl ethers and a,P unsaturated carbonyl compounds cyclize in a hetero-Diels-Alder reaction when heated together in an autoclave with small amounts of hydroquinone added to inhibit polymerisation. Acrolein gives 3,4-dihydro-2-methoxy-2JT-pyran (234,235), which can easily be hydrolysed to glutaraldehyde (236) or hydrogenated to 1,5-pentanediol (237). With 2-meth5lene-l,3-dicarbonyl compounds the reaction is nearly quantitative (238). 

Although considered an active participant in the process cycle, the tetrahydroaLkylanthraquinone (10) may not be a significant part of the catalytic hydrogenation because, dependent on the concentration in the working solution, these could all be converted to the hydroquinone by the labile shift per equation 17 and not be available to participate. None of the other first- or second-generation anthraquinone derivatives produce hydrogen peroxide, but most are susceptible to further reaction by oxidative or reductive mechanisms. 

Because the reaction takes place in the Hquid, the amount of Hquid held in the contacting vessel is important, as are the Hquid physical properties such as viscosity, density, and surface tension. These properties affect gas bubble size and therefore phase boundary area and diffusion properties for rate considerations. Chemically, the oxidation rate is also dependent on the concentration of the anthrahydroquinone, the actual oxygen concentration in the Hquid, and the system temperature (64). The oxidation reaction is also exothermic, releasing the remaining 45% of the heat of formation from the elements. Temperature can be controUed by the various options described under hydrogenation. Added heat release can result from decomposition of hydrogen peroxide or direct reaction of H2O2 and hydroquinone (HQ) at a catalytic site (eq. 19). 

During the 1980s few innovations were disclosed in the Hterature. The hydroxylation of phenol by hydrogen peroxide has been extensively studied in order to improve the catalytic system as well as to master the ratio of hydroquinone to catechol. Other routes, targeting a selective access to one of the dihydroxyben2enes, have appeared. World production capacities according to countries and process types are presented in Table 1. 

Aniline Oxidation. Even though this is quite an old process, it still has limited use to produce hydroquinone on a commercial scale. In the first step, aniline is oxidized by manganese dioxide in aqueous sulfuric acid. The resulting benzoquinone, isolated by vapor stripping, is reduced in a second step by either an aqueous acidic suspension of iron metal or by catalytic hydrogenation. 

This process has been widely studied and led to the constmction of new and original industrial units. Interest in the reaction stems from the simplicity of the process as well as the absence of undesirable by-products. However, in order to be economically rehable, such a process has to give high yield of dihydroxybenzenes (based on hydrogen peroxide as well as phenol) and a great flexibiUty for the isomeric ratio of hydroquinone to catechol. This last point generated more research and led to original and commercial processes. 

Oxidation. Oxidation of hydroxybenzaldehydes can result in the formation of a variety of compounds, depending on the reagents and conditions used. Replacement of the aldehyde function by a hydroxyl group results when 2- or 4-hydroxybenzaldehydes are treated with hydrogen peroxide in acidic (42) or basic (43) media pyrocatechol or hydroquinone are obtained, respectively. 

Arsenious oxide, trivalent antimony (73), sulfurous acid (74), hydrogen sulfide (75), stannous ion, and thiocianate (76) have been recommended for the titration of iodine. However, none of these appears to have a greater sensitivity for the deterrnination of minute quantities of iodine than thiosulfate. Organic compounds such as formaldehyde (77), chloral hydrate (78), aldoses (79), acetone (70,80), and hydroquinone have also been suggested for this purpose. 

Conversion of Aromatic Rings to Nonaromatic Cyclic Structures. On treatment with oxidants such as chlorine, hypochlorite anion, chlorine dioxide, oxygen, hydrogen peroxide, and peroxy acids, the aromatic nuclei in lignin typically ate converted to o- and -quinoid stmctures and oxinane derivatives of quinols. Because of thein relatively high reactivity, these stmctures often appear as transient intermediates rather than as end products. Further reactions of the intermediates lead to the formation of catechol, hydroquinone, and mono- and dicarboxyhc acids. 

Hydroquinone [123-31 -9] represents a class of commercially important black-and-white chemical reducing agents (see Hydroquinone,RESORCINOL, AND catechol). The following scheme for silver haUde development with hydroquinone shows the quantitative importance of hydrogen ion and haUde ion concentrations on the two half-ceU reactions that describe the silver—hydroquinone redox system ... 

Titanium Silicates. A number of titanium siUcate minerals are known (160) examples are Hsted in Table 19. In most cases, it is convenient to classify these on the basis of the connectivity of the SiO building blocks, eg, isolated tetrahedra, chains, and rings, that are typical of siUcates in general. In some cases, the SiO units may be replaced, even if only to a limited extent by TiO. For example, up to 6% of the SiO in the garnet schorlomite can be replaced by TiO. In general, replacement of SiO by TiO bull ding blocks increases the refractive indices of these minerals. Ti has also replaced Si in the framework of various zeofltes. In addition, the catalytic activity of both titanium-substituted ZSM-5 (TS-1) and ZSM-11 (TS-2) has received attention (161), eg, the selective oxidation of phenol, with hydrogen peroxide, to hydroquinone and catechol over TS-1 has been operated at the 10,000 t/yr scale in Italy (162). 

The N,]S -dialkyl-/)-PDAs are manufactured by reductively alkylating -PDA with ketones. Alternatively, these compounds can be prepared from the ketone and -lutroaruline with catalytic hydrogenation. The /V-alkyl-/V-aryl- -PDAs are made by reductively alkylating -nitro-, -nitroso-, or /)-aminodipheny1 amine with ketones. The AijAT-dialkyl- PDAs are made by condensing various anilines with hydroquinone in the presence of an acid catalyst (see Amines-aromatic,phenylenediamines). 

EFFECTS OF AMINES IN OXIDATION OF HYDROQUINONE WITH HYDROGEN PEROXIDE CATALYZED BY COPPER(H)... 

Hard hydrogenated cotton-seed oil (m 40-60°) or a 1 1 mixture of cotton-seed oil and castor oil containing about 1% of hydroquinone. 

Hydrogen cyanide Calcium cyanide Potassium cyanide Sodium cyanide Hydrogen fluoride as F Hydrogen peroxide Hydrogen selenide as Se Hydrogen sulphide Hydroquinone... 

---