Hydrocarbons hydrocracking

Catalysis. As of mid-1995, zeoHte-based catalysts are employed in catalytic cracking, hydrocracking, isomerization of paraffins and substituted aromatics, disproportionation and alkylation of aromatics, dewaxing of distillate fuels and lube basestocks, and in a process for converting methanol to hydrocarbons (54). 

Antimony trichloride is used as a catalyst or as a component of catalysts to effect polymerisation of hydrocarbons and to chlorinate olefins. It is also used in hydrocracking of coal (qv) and heavy hydrocarbons (qv), as an analytic reagent for chloral, aromatic hydrocarbons, and vitamin A, and in the microscopic identification of dmgs. Liquid SbCl is used as a nonaqueous solvent. 

Shell Gas B.V. has constructed a 1987 mVd (12,500 bbhd) Fischer-Tropsch plant in Malaysia, start-up occurring in 1994. The Shell Middle Distillate Synthesis (SMDS) process, as it is called, uses natural gas as the feedstock to fixed-bed reactors containing cobalt-based cat- yst. The heavy hydrocarbons from the Fischer-Tropsch reactors are converted to distillate fuels by hydrocracking and hydroisomerization. The quality of the products is very high, the diesel fuel having a cetane number in excess of 75. 

Basic to establishing whether power recovery is even feasible, let alone economical, are considerations of the flowing-fluid capacity available, the differential pressure available for the power recovery, and corrosive or erosive properties of the fluid stream. A further important consideration in feasibihty and economics is the probable physical location, with respect to each other, of fluid source, power-production point, and final fluid destination. In general, the tendency has been to locate the power-recoveiy driver and its driven unit where dictated by the driven-unit requirement and pipe the power-recoveiy fluid to and away from the driver. While early installations were in noncorrosive, nonerosive services such as rich-hydrocarbon absorption oil, the trend has been to put units into mildly severe seiwices such as amine plants, hot-carbonate units, and hydrocracker letdown. 

Solvents are recovered from the oil stream through distillation and steam stripping in a fractionator. The stream extracted from the solvent contains high concentrations of hydrogen sulfide, aromatics, naphthenes and other hydrocarbons, and is often fed to the hydrocracking unit. 

Catalytic Hydrocracking Heater stack gas (CO, SO, NO, hydrocarbons and PM), fugitive emissions (hydrocarbons) and catalyst regeneration (CO, NO, SO, and catalyst dust). 

Because some hydrocracking occurs, Powerforming also produces saturated C to Q light hydrocarbons. The methane and ethane formed normally are consumed as refinery fuel. Propane and butane products are frequently marketed as LPG. The relative quantities of each of these products vary considerably with feed quality, operating conditions and octane severity. 

Bond breaking can occur at any position along the hydrocarbon chain. Because the aromatization reactions mentioned earlier produce hydrogen and are favored at high temperatures, some hydrocracking occurs also under these conditions. However, hydrocracking long-chain molecules can produce Ce, C7, and Cg hydrocarbons that are suitable for hydrode-cyclization to aromatics. 

For more aromatics yield, the end point of the feed may be raised to include higher molecular weight hydrocarbons in favor of hydrocracking and dehydrocyclization. However, excessive hydrocracking is not desirable because it lowers liquid yields. 

Products from hydrocracking processes lack olefinic hydrocarbons. The product slate ranges from light hydrocarbon gases to gasolines to residues. Depending on the operation variables, the process could... 

---