Hollow fiber asymmetric mixed-matrix

The geometries for asymmetric mixed-matrix membranes include flat sheets, hollow fibers and thin-fihn composites. The flat sheet asymmetric mixed-matrix membranes are formed into spirally wound modules and the hollow fiber asymmetric mixed-matrix membranes are formed into hollow fiber modules. The thin-film composite mixed-matrix membranes can be fabricated into either spirally wound or hollow fiber modules. The thin-film composite geometry of mixed-matrix membranes enables selection of different membrane materials for the support layer and low-cost production of asymmetric mixed-matrix membranes utilizing a relatively high-cost zeolite/polymer separating layer on the support layer. 

Hollow Fiber Asymmetric Mixed-Matrix Membranes... 

Zeolite/polymer mixed-matrix membranes can be fabricated into dense film, asymmetric flat sheet, or asymmetric hollow fiber. Similar to commercial polymer membranes, mixed-matrix membranes need to have an asymmetric membrane geometry with a thin selective skin layer on a porous support layer to be commercially viable. The skin layer should be made from a zeohte/polymer mixed-matrix material to provide the membrane high selectivity, but the non-selective porous support layer can be made from the zeohte/polymer mixed-matrix material, a pure polymer membrane material, or an inorganic membrane material. 

Polymer matrix selection determines minimum membrane performance while molecular sieve addition can only improve membrane selectivity in the absence of defects. Intrinsically, the matrix polymer selected must provide industrially acceptable performance. For example, a mixed matrix membrane using silicone rubber could exhibit properties similar to intrinsic silicone rubber properties, O2 permeability of 933 Baiters and O2/N2 permselectivity of 2.1 (8). The resulting mixed matrix membrane properties would lie substantially below the upper boimd trade-off curve for gas permeability and selectivity. In contrast, a polymer exhibiting economically acceptable permeability and selectivity is a likely candidate for a successful polymer matrix. A glassy polymer such as Matrimid polyimide (PI) is an example of such a material because it exhibits acceptable properties and current technology exists for formation of asymmetric hollow fibers for gas separation (10). 

Jiang LY, Chung TS, Cao C, Huang Z, Kulprathipanja S. Fundamental understanding of nano-sized zeolite distribution in the formation of the mixed-matrix single and dual-layer asymmetric hollow fiber membranes. J Membr Sci 2005 252(l-2) 89-100. 

In this regard, there is an excellent review article on MMMs for gas separation, with a detailed discussion on the morphology of the interface between the inorganic particles and the polymer matrix (Chung et al. 2007). Unlike many other articles, this deals with asymmetric membranes for both flat sheets and hollow fibers aimed at the formation of an ultrathin defect-free mixed-matrix skin layer. 

---