Electron high-resolution

Fig. VIII-10. (a) Intensity versus energy of scattered electron (inset shows LEED pattern) for a Rh(lll) surface covered with a monolayer of ethylidyne (CCH3), the structure of chemisorbed ethylene, (b) Auger electron spectrum, (c) High-resolution electron energy loss spectrum. [Reprinted with permission from G. A. Somoijai and B. E. Bent, Prog. Colloid Polym. ScL, 70, 38 (1985) (Ref. 6). Copyright 1985, Pergamon Press.]...

HREELS High-resolution electron energy-loss spectroscopy [129, 130] Same as EELS Identification of adsorbed species through their vibrational energy spectrum... 

As the table shows, a host of other teclmiques have contributed a dozen or fewer results each. It is seen that diffraction teclmiques have been very prominent in the field the major diffraction methods have been LEED, PD, SEXAFS, XSW, XRD, while others have contributed less, such as NEXAFS, RHEED, low-energy position diffraction (LEPD), high-resolution electron energy loss spectroscopy (HREELS), medium-energy electron diffraction (MEED), Auger electron diffraction (AED), SEELFS, TED and atom diffraction (AD). 

Flueli M, Buffat P A and Borel J P 1988 Real time observation by high resolution electron microscopy (HREM) of the coalescence of small gold particles in the electron beam Surf. Sc/. 202 343... 

Henderson R, J M Baldwin, T A Ceska, F Zemlin, E Beckmann and K H Downing 1990. Model fo Structure of Bacteriorhodopsin Based on High-resolution Electron Cryo-microscopy. Joun Molecular Biology 213 899-929. 

Vibrational transitions accompanying an electronic transition are referred to as vibronic transitions. These vibronic transitions, with their accompanying rotational or, strictly, rovibronic transitions, give rise to bands in the spectrum, and the set of bands associated with a single electronic transition is called an electronic band system. This terminology is usually adhered to in high-resolution electronic spectroscopy but, in low-resolution work, particularly in the liquid phase, vibrational structure may not be resolved and the whole band system is often referred to as an electronic band. 

Analysis of Surface Molecular Composition. Information about the molecular composition of the surface or interface may also be of interest. A variety of methods for elucidating the nature of the molecules that exist on a surface or within an interface exist. Techniques based on vibrational spectroscopy of molecules are the most common and include the electron-based method of high resolution electron energy loss spectroscopy (hreels), and the optical methods of ftir and Raman spectroscopy. These tools are tremendously powerful methods of analysis because not only does a molecule possess vibrational modes which are signatures of that molecule, but the energies of molecular vibrations are extremely sensitive to the chemical environment in which a molecule is found. Thus, these methods direcdy provide information about the chemistry of the surface or interface through the vibrations of molecules contained on the surface or within the interface. 

Further investigations were carried out with 3-methyldiazirine (72JCP(57)94l) and with 3-chloro-3-methyldiazirine (72JSP(42)403). The high resolution electronic spectra were submitted to vibrational analysis deuterated derivatives were included. All excitation and ground state fundamentals observed could be assigned. 

Henderson, R., et al. Model for the stmcture of bacteriorhodopsin based on high-resolution electron cryo-microscopy. /. Mol. Biol. 213 899-929, 1990. 

High-Resolution Electron Energy Loss Spectroscopy (HREELS) 1.8.3... 

There are three primary image modes that are used in conventional TEM work, bright-field microscopy, dark-field microscopy, and high-resolution electron microscopy. In practice, the three image modes differ in the way in which an objective diaphragm is used as a filter in the back focal plane. 

In this chapter, three methods for measuring the frequencies of the vibrations of chemical bonds between atoms in solids are discussed. Two of them, Fourier Transform Infrared Spectroscopy, FTIR, and Raman Spectroscopy, use infrared (IR) radiation as the probe. The third, High-Resolution Electron Enetgy-Loss Spectroscopy, HREELS, uses electron impact. The fourth technique. Nuclear Magnetic Resonance, NMR, is physically unrelated to the other three, involving transitions between different spin states of the atomic nucleus instead of bond vibrational states, but is included here because it provides somewhat similar information on the local bonding arrangement around an atom. 

High-Resolution Electron Energy Loss Spectroscopy... 

Figure 2 Schematic of a 127° high-resolution electron energy-loss spectrometer mounted on an 8-in flange for studies of vibrations at surfaces.

A special mention is in order of high-resolution electron microscopy (HREM), a variant that permits columns of atoms normal to the specimen surface to be imaged the resolution is better than an atomic diameter, but the nature of the image is not safely interpretable without the use of computer simulation of images to check whether the assumed interpretation matches what is actually seen. Solid-state chemists studying complex, non-stoichiometric oxides found this image simulation approach essential for their work. The technique has proved immensely powerful, especially with respect to the many types of defect that are found in microstructures. 

Figure 6.4. Piston alloy, showing strengthening preeipitates. imaged by high-resolution electron micro.seopy. The matrix (top and bottom) is aluminium, while the central region is silicon. The outer precipitates were idcntilicd as AlsCu2MgnSi5. (First published by Spence 1999. reproduced here by courtesy of the originator, V. Radmilovic).

Carbon tubules (or nanotubes) are a new form of elemental carbon recently isolated from the soot obtained during the arc-discharge synthesis of fuller-enes[I]. High-resolution electron micrographs do not favor a scroll-like heUcal structure, but rather concentric tubular shells of 2 to 50 layers, with tips closed by curved, cone-shaped, or even polygonal caps. Later work[2] has shown the possibility of obtaining singleshell seamless nanotubes. 

Good semi-quantitative agreements are found in diffraction patterns and proposed models obtained by molecular-dynamics[14], because the results of the ex-periments[31-34] are consistent with the atomic models proposed by us[14]. However, in the present state of high-resolution electron microscopy, taking into account, moreover, the number of sheets and the complicated geometry of the helix, it seems unlikely to directly visualize the pentagon-hexagon pairs. 

Fig. I. High-resolution electron micrographs of graphitic particles (a) as obtained from the electric arc-deposit, they display a well-defined faceted structure and a large inner hollow space, (b) the same particles after being subjected to intense electron irradiation (note the remarkable spherical shape and the disappearance of the central empty space) dark lines represent graphitic layers.

Fig. 3. High-resolution electron micrograph (HREM) of oxidised CNT tips. Note the amorphous carbon residue inside the lower nanotube (marked with an arrow).

---