Hazardous substances exposure limits

Thiophene and 3-methylthiophene are Hsted on the TSCA chemical substances inventory. Thiophene is regulated as a hazardous material under OSHA and also regulated under the Clean Air Act, Section 110, 40 CFR 60.489, but there are no exposure limits or controls set for 3-methylthiophene. Both materials are regulated under sections 311/312 of the Superfund Amendments and Reauthorization Act, 1986 (SARA), as materials with an acute health and fire hazard, and under the Resource Conservation and Recovery Act, as ignitable hazardous wastes (DOOl). 

Control of Substances Hazardous to Health Regulations (COSHH). Guidance on Exposure Limits for Mixtures (Regulation 7). Revised (1993)... 

The first evacuation consideration, determining whether an evacuation is necessary, involves a comprehensive effort to identify and consider both tlie nature of and circumstances surrounding the released hazardous material and its effect on people. No safe exposure limits ha e been established for extremely haairdous substances (EHSs). 

EL = emissions level ERA = Environmental Protection Agency HSDB = Hazardous Substances Data Bank lARC = International Agency for Research on Cancer IRIS = Integrated Risk Information System NIOSH = National Institute of Occupational Safety and Health OEL = occupational exposure limit OSHA = Occupational Safety and Health Administration PEL = permissible exposure limit RAC = reference air concentration REL = recommended exposure limit RCRA = Resource Conservation and Recovery Act RfD = reference dose TLV = threshold limit value TWA = time-weighted average WHO = World Health Organization... 

In the UK (under the Control of Substances Hazardous to Health Regulations 1988) there are maximum exposure limits (MEL) and occupational exposure standards (OES) ... 

Substance for which the TLV is higher than the OSHA Permissible Exposure Limit (PEL) and/or the NIOSH Recommended Exposure Limit (REL). Simple asphyxiant. Some gases and vapours present at high concentrations act as asphyxiants by reducing the oxygen content of air. Many of these are odourless and colourless. Many also pose a fire or explosion risk, often at values below which asphyxiation can occur. (Although capable of asphyxiation, they are not considered to be substances hazardous to health under COSHH.)... 

Substances hazardous to health include substances labelled as dangerous (i.e. very toxic, toxic, harmful, irritant or corrosive) under any other statutory requirements, agricultural pesticides and other chemicals used on farms, and substances with occupational exposure limits. They include harmful micro-organisms and substantial quantities of dust. Indeed any material, mixture or compound used at work, or arising from work activities, which can harm people s health is apparently covered. 

OSHA maintains a list of potential carcinogens. In addition, OSHA sets enforceable permissible exposure limits (PELS) to protect workers against the health effects of exposure to hazardous substances. 

EPA has established that hydrogen sulfide is a regulated toxic substance and is a hazardous substance as defined under the Federal Water Pollution Control Act. OSH A has established an acceptable ceiling concentration of 20 parts per million (ppm) for hydrogen sulfide in the workplace, with a maximum level of 50 ppm allowed for 10 minutes maximum duration if no other measurable exposure occurs. NIOSH has set a maximum Recommended Exposure Limit (REL) ceiling value (10 minutes) of 10 ppm. A complete listing of federal and state regulations and recommendations are found in Chapter 7. 

OSHA requires employers of workers who are occupationally exposed to a toxic or hazardous substance to institute engineering controls and work practices that maintain or reduce their exposure to a level that is at or below the permissible exposure limit (PEL) established for the substance. For occupational exposures to lead, the employer must use engineering controls and work practices to achieve an occupational exposure of 50 pg/nr3 (0.006 ppm) or lower, based on an 8-hour time-weighted average (TWA) (OSHA 1995). When employee exposures to lead can not be maintained at or below 50 pg/rn3... 

Health hazards caused by chemicals are represented by the Toxic Exposure Subindex (ITox). hi the ISI the evaluation of toxic exposure is based on the Threshold Limit Values (TLV) because TLV data is readily available for most substances in process industry. TLV values express the harmful exposure limits of substances in the threshold time of 8 hours. The index value is higher, when the TLV is lower i.e. the substance is more toxic. It is important to use TLVs with same threshold time so that the results are comparable. Score limits in Table 13 are based on Mond Index (ICI, 1985). 

There are no occupational exposure limits for many hazardous substances which may require control of inhalation exposures. The necessary data and other resources required for setting such limits is restricted and unlikely to match the potential demand. A hazard categorisation scheme was, therefore, developed for application within the chemical industry. The scheme used readily-available information on toxicological endpoints to place hazardous substances into a limited range of hazard categories, expressed as Occupational Exposure Bands. These Bands could be used as a basis for risk assessment and the selection of appropriate control regimes. 10 refs. EUROPEAN COMMUNITY EUROPEAN UNION UK WESTERN EUROPE... 

Exposure limits The permissible exposure limits (PELs) in air, set by the Occupational Health and Safety Administration (OSHA), can be found in the Code of Federal Regulations (General Industry Standards for Toxic and Hazardous Substances, 1977). Unless noted otherwise, the PELs are 8-h time-weighted average (TWA) concentrations. 

These two definitions reflect two sides of the same situation. In this book, the term critical effect(s) will be used for the hazard/effect considered as being the essential one(s) for the purpose of the risk characterization, e.g., for the establishment of a health-based guidance value, permissible exposure level, or Reference Dose. It should be noted that the critical effect could be a local as well as a systemic effect. It should also be recognized that the critical effect for the establishment of a tolerable exposure level is not necessarily the most severe effect of the chemical substance. For example, although a substance may cause a serious effect such as liver necrosis, the critical effect for the establishment of, e.g., an occupational exposure limit could be a less serious effect such as respiratory tract irritation, because the irritation occurs at a lower exposure level. 

---