Halides, alkyl reaction with carboxylic acid salts

As noted in the preceding section, one of the most general methods of synthesis of esters is by reaction of alcohols with an acyl chloride or other activated carboxylic acid derivative. Section 3.2.5 dealt with two other important methods, namely, reactions with diazoalkanes and reactions of carboxylate salts with alkyl halides or sulfonate esters. There is also the acid-catalyzed reaction of carboxylic acids with alcohols, which is called the Fischer esterification. 

Alternatively, esterification of carboxylic acid can be carried out in aqueous media by reacting carboxylic acid salts with alkyl halides through nucleophilic substitutions (Eq. 9.10).20 The reaction rate of alkyl halides with alkali metal salts of carboxylic acids to give esters increases with the increasing concentration of catalyst, halide, and solvent polarity and is reduced by water. Various thymyl ethers and esters can be synthesized by the reactions of thymol with alkyl halides and acid chlorides, respectively, in aqueous medium under microwave irradiation (Eq. 9.11).21 Such an esterification reaction of poly(methacrylic acid) can be performed readily with alkyl halides using DBU in aqueous solutions, although the rate of the reaction decreases with increasing water content.22... 

The O-alkylation of carboxylates is a useful alternative to the acid-catalyzed esterification of carboxylic acids with alcohols. Carboxylates are weak, hard nucleophiles which are alkylated quickly by carbocations and by highly reactive, carbocation-like electrophiles (e.g. trityl or some benzhydryl halides). Suitable procedures include treatment of carboxylic acids with alcohols under the conditions of the Mitsunobu reaction [122], or with diazoalkanes. With soft electrophiles, such as alkyl iodides, alkylation of carboxylic acid salts proceeds more slowly, but in polar aprotic solvents, such as DMF, or with non-coordinating cations acceptable rates can still be achieved. Alkylating agents with a high tendency to O-alkylate carboxylates include a-halo ketones [42], dimethyl sulfate [100,123], and benzyl halides (Scheme 6.31). 

The reaction between acyl halides and alcohols or phenols is the best general method for the preparation of carboxylic esters. It is believed to proceed by a 8 2 mechanism. As with 10-8, the mechanism can be S l or tetrahedral. Pyridine catalyzes the reaction by the nucleophilic catalysis route (see 10-9). The reaction is of wide scope, and many functional groups do not interfere. A base is frequently added to combine with the HX formed. When aqueous alkali is used, this is called the Schotten-Baumann procedure, but pyridine is also frequently used. Both R and R may be primary, secondary, or tertiary alkyl or aryl. Enolic esters can also be prepared by this method, though C-acylation competes in these cases. In difficult cases, especially with hindered acids or tertiary R, the alkoxide can be used instead of the alcohol. Activated alumina has also been used as a catalyst, for tertiary R. Thallium salts of phenols give very high yields of phenolic esters. Phase-transfer catalysis has been used for hindered phenols. Zinc has been used to couple... 

A carboxylic acid (not the salt) can be the nucleophile if F is present. Mesylates are readily displaced, for example, by benzoic acid/CsF. Dihalides have been converted to diesters by this method. A COOH group can be conveniently protected by reaction of its ion with a phenacyl bromide (ArCOCH2Br). The resulting ester is easily cleaved when desired with zinc and acetic acid. Dialkyl carbonates can be prepared without phosgene (see 10-21) by phase-transfer catalyzed treatment of primary alkyl halides with dry KHCO3 and K2C03- ... 

Carboxylic acids can be alkylated in the a position by conversion of their salts to dianions [which actually have the enolate structures RCH=C(0")2 ] by treatment with a strong base such as LDA. The use of Li as the counterion is important, because it increases the solubility of the dianionic salt. The reaction has been applied to primary alkyl, allylic, and benzylic halides, and to carboxylic acids of the form RCH2COOH and RR"CHCOOH. This method, which is an example of the alkylation of a dianion at its more nucleophilic position (see p. 458),... 

Especially for large-scale work, esters, may be more safely and efficiently prepared by reaction of carboxylate salts with alkyl halides or tosylates. Carboxylate anions are not very reactive nucleophiles so the best results are obtained in polar aprotic solvents54 or with crown ether catalysts.55 The reactivity for the salts is Na+ < K+ < Rb+ < Cs+. Cesium carboxylates are especially useful in polar aprotic solvents. The enhanced reactivity of the cesium salts is due both to high solubility and to the absence of ion pairing with the anion.56 Acetone has been found to be a good solvent for reaction of carboxylate anions with alkyl iodides.57 Cesium fluoride in DMF is another useful combination.58 Carboxylate alkylation procedures have been particularly advantageous for preparation of hindered esters that can be relatively difficult to prepare by the acid-catalyzed esterification method (Fischer esterification) which will be discussed in Section... 

Typical synthetic procedures include the reaction of alkyl halides with the silver salts of carboxylic acids, the reaction of carboxylate anions in alkali with an excess of a dialkyl sulphate, (especially dimethyl sulphate), and heating tertiary184 or quaternary ammonium salts of carboxylic acids. These routes are particularly valuable for the preparation of esters of seriously sterically hindered acids. For example, Fuson et al.iK made the methyl ester of 2,4,6-triethylbenzoic acid by heating the tetramethyl ammonium salt to 200-250°C, viz. 

Because of the special structural requirements of the resin-bound substrate, this type of cleavage reaction lacks general applicability. Some of the few examples that have been reported are listed in Table 3.19. Lactones have also been obtained by acid-catalyzed lactonization of resin-bound 4-hydroxy or 3-oxiranyl carboxylic acids [399]. Treatment of polystyrene-bound cyclic acetals with Jones reagent also leads to the release of lactones into solution (Entry 5, Table 3.19). Resin-bound benzylic aryl or alkyl carbonates have been converted into esters by treatment with acyl halides and Lewis acids (Entry 6, Table 3.19). Similarly, alcohols bound to insoluble supports as benzyl ethers can be cleaved from the support and simultaneously converted into esters by treatment with acyl halides [400]. Esters have also been prepared by treatment of carboxylic acids with an excess of polystyrene-bound triazenes here, diazo-nium salts are released into solution, which serve to O-alkylate the acid (Entry 7, Table 3.19). This strategy can also be used to prepare sulfonates [401]. 

The silver(I) salts of carboxylic acids react with halogens to give unstable intermediates which readily decarboxylate thermally to yield alkyl halides. The reaction is believed to involve homolysis of the C-C bond and a radical chain mechanism. 

Silver nitrate test The compound to be tested is treated with a few drops of 1% alcoholic silver nitrate. A white precipitate indicates a positive reaction. This could be due to either silver chloride (reaction with a reactive alkyl halide), silver alkynide (reaction with a terminal alkyne), or the silver salt of a carboxylic acid (reaction with a carboxylic acid). 

The reaction sequence in the vinylation of aromatic halides and vinyl halides, i.e. the Heck reaction, is oxidative addition of the alkyl halide to a zerovalent palladium complex, then insertion of an alkene and completed by /3-hydride elimination and HX elimination. Initially though, C-H activation of a C-H alkene bond had also been taken into consideration. Although the Heck reaction reduces the formation of salt by-products by half compared with cross-coupling reactions, salts are still formed in stoichiometric amounts. Further reduction of salt production by a proper choice of aryl precursors has been reported (Chapter III.2.1) [1]. In these examples aromatic carboxylic anhydrides were used instead of halides and the co-produced acid can be recycled and one molecule of carbon monoxide is sacrificed. Catalytic activation of aromatic C-H bonds and subsequent insertion of alkenes leads to new C-C bond formation without production of halide salt byproducts, as shown in Scheme 1. When the hydroarylation reaction is performed with alkynes one obtains arylalkenes, the products of the Heck reaction, which now are synthesized without the co-production of salts. No reoxidation of the metal is required, because palladium(II) is regenerated. 

Thieno[2,3-c]isothiazole-3-carboxylic acid was the compound obtained by the reaction of ethyl 3-cyano-5,5-diethoxy-2-oxopentanoate with phosphorus pentachloride in refluxing toluene, previously assumed (55JA4069) to yield thieno[3,4-c ]isothiazole-4-carboxylic acid. The proposed mechanism involves the cyclization of the intermediate 3-cyano-2,5-dithioxopentanoate as shown in Scheme 20. The parent heterocycle, which is a weak base and fails to give quaternary salts with alkyl halides, was obtained by decarboxylation of the acid and also by independent synthesis (82AJC385). 

Although nitriles lack an acyl group, they are considered acid derivatives because they hydrolyze to carboxylic acids. Nitriles are frequently made from carboxylic acids (with the same number of carbons) by conversion to primary amides followed by dehydration. They are also made from primary alkyl halides and tosylates (adding one carbon) by nucleophilic substitution with cyanide ion. Aryl cyanides can be made by the Sandmeyer reaction of an aryldiazonium salt with cuprous cyanide. a-Hydroxynitriles (cyanohydrins) are made by the reaction of ketones and aldehydes with HCN. 

---