Glyoxals, substituted

Dioxan. 2,3-dihydroxy-, as glyoxal substitute in Westphal condensations,... 

Carbon—nitrogen double bonds in imines, hydrazones, oximes, nitrones, azines, and substituted diazomethanes can be cleaved, yielding mainly ketones, aldehydes and/or carboxyHc acids. Ozonation of acetylene gives primarily glyoxal. With substituted compounds, carboxyHc acids and dicarbonyl compounds are obtained for instance, stearoHc acid yields mainly azelaic acid, and a smaH amount of 9,10-diketostearic acid. 

Ozonation of Aromatics. Aromatic ring unsaturation is attacked much slower than olefinic double bonds, but behaves as if the double bonds in the classical Kekule stmctures really do exist. Thus, benzene yields three moles of glyoxal, which can be oxidized further to glyoxyUc acid and then to oxahc acid. Substituted aromatics give mixtures of aUphatic acids. Ring substituents such as amino, nitro, and sulfonate are cleaved during ozonation. 

A variation involves the reaction of benzylamines with glyoxal hemiacetal (168). Cyclization of the intermediate (35) with sulfuric acid produces the same isoquinoline as that obtained from the Schiff base derived from an aromatic aldehyde and aminoacetal. This method has proved especially useful for the synthesis of 1-substituted isoquinolines. 

Most of the compounds in this class have been prepared from preexisting crown ether units. By far, the most common approach is to use a benzo-substituted crown and an electrophilic condensation polymerization. A patent issued to Takekoshi, Scotia and Webb (General Electric) in 1974 which covered the formation of glyoxal and chloral type copolymers with dibenzo-18-crown-6. The latter were prepared by stirring the crown with an equivalent of chloral in chloroform solution. Boron trifluoride was catalyst in this reaction. The polymer which resulted was obtained in about 95% yield. The reaction is illustrated in Eq. (6.22). 

The reaction of ozone with an aromatic compound is considerably slower than the reaction with an alkene. Complete ozonolysis of one mole of benzene with workup under non-oxidative conditions will yield three moles of glyoxal. The selective ozonolysis of particular bonds in appropriate aromatic compounds is used in organic synthesis, for example in the synthesis of a substituted biphenyl 8 from phenanthrene 7 ... 

Alternatively, cyclocondensation of 1,5-diaminotetrazole 1024 with gly-oxal and substituted glyoxals produced tetrazolo[ 1,5-6][l, 2,4]triazine 1025 (88JOC5371), which can be reduced to 7,8-dihydro derivative 1026 using Pd/C as a hydrogenating catalyst, but NaBH4 gave 5,6,7,8-tetrahydro derivative 1027. 

As the reaction sequence of Scheme 12-38 can be stopped at the stage of the oo-methylglyoxal phenylhydrazone (12.78), it is possible to synthesize asymmetrically substituted formazanes (12.80, Ar = Ar ) by reacting acetone with one equivalent of a diazonium ion ArNJ under acidic conditions and then coupling the co-methyl-glyoxal phenylhydrazone with Ar NJ in alkaline solution. 

Dinitrophenyl-hydrazine has been successfully employed in the analysis of simple aldehydes, substituted aldehydes, glyoxal and gluteraldehyde (43-45), all the isomers of the C3 to C7 aliphatic ketones (44,45) and in the determination of formaldehyde in tobacco smoke (46). 

H). On the other hand, the synthesis of unsymmetricaUy iV,iV -substituted congeners is less straightforward as a functionalised imidazole has to be isolated prior to alkylation or arylation. Two main methods are available for imidazole functionaU-sation deprotonation with metalUc Na or K leading to an imidazoUde (I) followed by reaction with RX or reaction of glyoxal with a primary amine, an ammonium salt and formaldehyde (J). Al-functionalised imidazole can then be alkylated or... 

Polar C=Y double bonds (Y = NR, O, S) with electrophilic carbon have been added to suifinic acids under formation of sulfones. As in the preceding section one must distinguish between carbonyl groups and their derivatives on the one hand, and carboxylic acids (possessing leaving groups at the electrophilic carbon) on the other. Aldehydes " of sufficient reactivity—especially mono-substituted glyoxals - —and their aryl or arylsulfonyl imines have been added to suifinic acids (in a reversible equilibrium) to yield a-hydroxy or a-amino sulfones the latter could also be obtained from the former in the presence of primary amines (equation 26). 

General procedures for the synthesis of the imidazole core have been published in 2000. Solvent-free microwave assisted synthesis of 2,4,5-substituted imidazoles 64 from aldehydes 62 and 1,2-dicarbonyl compounds 63 in the presence of ammonium acetate and alumina has been reported <00TL5031>. V-protected a-amino glyoxals 65 were utilized as potential chiral educts for the synthesis of amino acid-derived imidazoles 66 <00TL1275>. 

Allenyltrimethylsilanes add to ethyl glyoxalate in the presence of a chiral pybox scandium triflate catalyst to afford highly enantioenriched homopropargylic alcohols or dihydrofurans, depending on the nature of the silyl substituent (Tables 9.39 and 9.40) [62]. The trimethylsilyl-substituted silanes give rise to the alcohol products whereas the bulkier t-butyldiphenylsilyl (DPS)-substituted silanes yield only the [3 + 2] cycloadducts. A bidentate complex of the glyoxalate with the scandium metal center in which the aldehyde carbonyl adopts an axial orientation accounts for the observed facial preference ofboth additions. 

Diaminofurazan (DAF) (24) is a starting material for the synthesis of many nitro-substituted furazans and is readily prepared from the cyclization of 1,2-diaminoglyoxime (23) in the presence of aqueous base under pressure at 180 °C the latter prepared from the reaction of glyoxal/ glyoxime/ cyanogen or dithiooxamide with hydroxylamine. 

Replacement of formaldehyde In amlnoplasts by substitution with higher aldehydes (or ketones) Is even more problematic the equilibrium of the condensation shifts strongly towards starting materials, except In cases where the formaldehyde replacement contains electron withdrawing substituents (e.g. with glyoxal... 

Although phenol itself is used in the largest volume, various substituted phenols such as cresol (o-, m-, p-), p-butylphenol, resorcinol, and bisphenol A are used for specialty applications. Some use is also made of aldehydes other than formaldehyde—acetaldehyde, glyoxal, 2-furaldehyde. 

---