Generation of Metal Ions

Manganic sulfate can be generated anodically by electrolysis of manganous sulfate in 55% sulfuric acid at a lead anode 157 After electrolysis, xylene is added and allowed to react at 25-35°, tolualdehyde being formed in 30-45 % current yield. The used electrolyte is then purified and used again. 

Similarly, cobaltic and argentic ion have been generated by anodic oxidation of cobaltous and argentous ion, respectively, and used for the oxidation of methyl-substituted aromatic hydrocarbons to aldehydes 18a Electrogenerated mercuric ion can be used for the conversion of propene to acrolein 18al  

An unusual type of reaction is anodic reduction which can be performed at certain metal anodes. Thus, when magnesium is used as an anode in the electrolysis of benzophenone in pyridine/sodium iodide solution, the anode is consumed and benzopinacol can be isolated from the anolyte 15S). Here reduction by univalent magnesium ion is postulated  

Similarly, an aluminium anode is anodically converted to Al+ which for example can reduce nitrosobenzene in the anode compartment 1591  

---

A somewhat alternative analysis of pitting attributes pit initiation to the activation of defects in the passive film, defects such as those induced during film growth or those induced mechanically due to scratching or stress. The pit behavior is analyzed in terms of the product, xi, a parameter in which x is the pit or crevice depth (cm), and i is the corrosion current density (A/cm2) at the bottom of the pit (Ref 21). Experimental measurements confirm that, for many metal/environment systems, the active corrosion current density in a pit is of the order of 1 A/cm2. Therefore, numerical values for xi may be visualized as a pit depth in centimeters. A defect becomes a pit if the pH in the pit becomes sufficiently low to prevent maintaining the protective oxide film. Establishing the critical pH, for a specific oxide, will depend on the depth (metal ions trapped by diffiisional constraints), the current density (rate of generation of metal ions) and the external pH. In turn, the current density will be determined by the local electrochemical potential established by corrosion currents to the passive external cathodic surface or by a potentiostat. Once the critical condition for dissolution of the oxide has been reached, the pit becomes deeper and develops a still lower pH by further hydrolysis. 

Certainly a thermodynamically stable oxide layer is more likely to generate passivity. However, the existence of the metastable passive state implies that an oxide him may (and in many cases does) still form in solutions in which the oxides are very soluble. This occurs for example, on nickel, aluminium and stainless steel, although the passive corrosion rate in some systems can be quite high. What is required for passivity is the rapid formation of the oxide him and its slow dissolution, or at least the slow dissolution of metal ions through the him. The potential must, of course be high enough for oxide formation to be thermodynamically possible. With these criteria, it is easily understood that a low passive current density requires a low conductivity of ions (but not necessarily of electrons) within the oxide. 

Humans are constantly exposed to background levels of ionizing radiation, which will generate some OH in vivo. This radical may also arise by reaction of metal ions with H2O2 in vivo. Thus, it is not surprising to find that repair systems have evolved to remove at least some of the lesions in DNA that can result from attack of OH (for review, see Breimer, 1991). 

One of the most attractive roles of liquid liquid interfaces that we found in solvent extraction kinetics of metal ions is a catalytic effect. Shaking or stirring of the solvent extraction system generates a wide interfacial area or a large specific interfacial area defined as the interfacial area divided by a bulk phase volume. Metal extractants have a molecular structure which has both hydrophilic and hydrophobic groups. Therefore, they have a property of interfacial adsorptivity much like surfactant molecules. Adsorption of extractant at the liquid liquid interface can dramatically facilitate the interfacial com-plexation which has been exploited from our research. 

Wastewaters generated from manufacturing plants that produce or use inorganic chemicals vary considerably, depending on raw materials, type of process, and the end product, among others. A screening program is often conducted to determine the presence, concentration, and toxicity of metal ions in such wastewaters. The minimum detection limits for the toxic metals are presented in Table 22.1. 

The objective of this chapter is to compile work related to the beginning of sonochemical research and its extension to the aqueous solutions of metal ions. Ultrasound propagation in aqueous salt solutions leads to the hydrolysis, reduction, complexation, decomplexation and crystallization. Such works from different laboratories, along with the effect of dissolved gases on the production of free radicals in water and aqueous solutions upon sonication has been reviewed in this chapter. The generation of turbidity, due to the formation of metal hydroxides and changes in the conductivity of these aqueous solutions, carried out in this laboratory, has also been reported, to give firsthand information of the ultrasound interaction of these solutions. 

A correlation between the spacing of striae and convection downstream of protrusions does not fully describe the process. The initial protrusions arise far from transport control and cannot be attributed to a diffusive instability of the type described in the previous section. Jorne and Lee proposed that striations formed on rotating electrodes by deposition of zinc, copper and silver are generated by an instability that arises only in systems in which the current density at constant overpotential decreases with increasing concentration of metal ion at the interface [59]. 

When a metal ion is surrounded by anions in a crystal, there is an electrostatic field produced by the anions that alters the energies of the d orbitals of the metal ion. The field generated in this way is known as a crystal field. Crystal field theory was developed in 1929 by Hans Bethe in an attempt to explain the spectral characteristics of metal ions in crystals. It soon became obvious that anions surrounding a metal in a crystal gave a situation that is very similar to the ligands (many of which are... 

The lack of selectivity can be circumvented by coupling a postcolumn flow system to a liquid chromatograph. This has promoted the development of a number of efficient liquid chromatography-CL approaches [16, 17]. Eluted analytes are mixed with streams of the substrate and oxidant (in the presence or absence of a catalyst or inhibitor) and the mixed stream is driven to a planar coiled flow cell [18] or sandwich membrane cell [19] in an assembly similar to those of flow injection-CL systems. Many of these postcolumn flow systems are based on an energy-transfer CL process [20], In others, the analytes are mixtures of metal ions and the luminol-hydrogen peroxide system is used to generate the luminescence [21],... 

As in the case with catalytic decomposition of hydrogen peroxide, radical generation by the reaction of metal ions with hydroperoxide consists of several steps. In an aqueous solution, first ROOH is substituted in the internal coordination sphere of the ion followed by the transfer of an electron from the ion to ROOH accompanied by the subsequent cleavage of hydroperoxide to RO and OH, for example,... 

Polymeric pseudocrown ether networks have been generated in situ by the photopolymerization of poly(ethylene glycol) diacrylate transition metal complexes <00CM633>, and the effect of metal ion templation was evaluated. The 1,6,13,18-tetraoxa[6.6]paracyclophane-3,15-diyne (termed pyxophanes) was prepared from hydroquinone and l,4-dichlorobut-2-yne it forms size-selective 7i-complexes with alkali metal cations <00CC2377>. Dibenzo[ ]crown-m have been used in numerous elegant studies in which they were the needles that were threaded by diverse reagents the resultant... 

---