Fractional distillation fractionating column

If, however, the impurities are themselves volatile liquids, then the separation of these impurities from the main bulk of the required substance is achieved by fractional distillation. If an ordinary distilling-flask, such as that shown in Fig. 2, p. 8, is used for this purpose, however, only a very partial separation of the liquid components of the crude mixture is usually obtained, unless there is a considerable difference in boiling-point between the impurities and the main component. T0 obtain a much sharper and more complete separation, a fractionating column is employed. 

Experiment 6. Fractional Distillation of a Mixture of Benzene and Toluene. Fractionally distil about 40 ml. of a mixture of equal volumes of benzene and toluene, using the type of fractionating column shown in Fig. ii(b), in which about 18-20 cm. of the column are actually filled with glass sections, but in which the cotton-wool lagging is not used. Distil very slowlyy so that the total distillation occupies about hours. Shield the apparatus very carefully from draughts. Collect the fractions having the b.ps (a) 80-85°, ( ) 85-107°, (c) 107-111°. A sharp separation should be obtained, e.g.y these fractions should have volumes of about 19, 2, and 17 ml. respectively. 

When a more delicate fractional vacuum-distillation is required, the flask and column shown in Fig. ii(b), p. 26, may be used, the side-arm of the column being fitted directly into receiver C (Fig. 14). A rubber stopper must then be used to fit the flask on to the fractionating column, and it should also carry a capillary tube leading to the bottom of the flask, to provide the usual fine stream of bubbles to prevent bumping. 

Fractional Distillation. Fractional distillation on a semi-micro scale can be carried out satisfactorily with the fractionating column shown in Fig. 39. The column is 10 cm. long and is filled with pieces... 

Carefully refractionate the liquid of b.p. 150-160°, either by direct distillation from a small distilling-flask or (preferably) by using a short fractionating column, of the type shown in Fig. ii(b), p. 26. Almost pure bromobenzene is thus obtained, of... 

The pure quinaldine can now be isolated by either of the following methods, (a) Transfer the acetylated mixture to a Claisen flask (preferably having a short fractionating column below the side-arm) and distil the mixture slowly at water-pump pressure by heating the flask in an oil or silicone bath. The first fraction, of b.p. ca. 50715 mm., contains acetic acid and... 

FRACTIONAL DISTILLATION. DISTILLATION WITH A FRACTIONATING COLUMN... 

An account of the elementary theory of fractional distillation is given in Section 1,4. Fractionating columns suitable for both elementary and advanced work will be described in the following pages. 

Reflux ratio. This is defined as the ratio between the number of moles of vapour returned as refluxed liquid to the fractionating column and the number of moles of final product (collected as distillate), both per unit time. The reflux ratio should be varied according to the difficulty of fractionation, rather than be maintained constant a high efficiency of separation requires a liigh reflux ratio. ... 

Attention is directed to the fact that ether is highly inflammable and also extremely volatile (b.p. 35°), and great care should be taken that there is no naked flame in the vicinity of the liquid (see Section 11,14). Under no circumstances should ether be distilled over a bare flame, but always from a steam bath or an electrically-heated water bath (Fig.//, 5,1), and with a highly efficient double surface condenser. In the author s laboratory a special lead-covered bench is set aside for distillations with ether and other inflammable solvents. The author s ether still consists of an electrically-heated water bath (Fig. 11, 5, 1), fitted with the usual concentric copper rings two 10-inch double surface condensers (Davies type) are suitably supported on stands with heavy iron bases, and a bent adaptor is fitted to the second condenser furthermost from the water bath. The flask containing the ethereal solution is supported on the water bath, a short fractionating column or a simple bent still head is fitted into the neck of the flask, and the stUl head is connected to the condensers by a cork the recovered ether is collected in a vessel of appropriate size. 

Di-n-butyl ether. Technical n-butyl ether does not usually contain appreciable quantities of peroxides, unless it has been stored for a prolonged period. It should, however, be tested for peroxides, and, if the test is positive, the ether should be shaken with an acidified solution of a ferrous salt or with a solution of sodium sulphite (see under Diethyl ether). The ether is dried with anhydrous calcium chloride, and distilled through a fractionating column the portion, b.p. 140-141°, is collected. If a fraction of low boiling point is obtained, the presence of n-butyl... 

If it is desired to purify an inferior product, 1 litre of it is refiuxed for 6 hours with 85 ml. of acetic anhydride and then distilled through a fractionating column the liquid passing over at 56-57° is collected. The distillate is shaken with 20 g. of anhydrous potassium carbonate for 10 minutes, filtered and redistilled. The resulting methyl acetate has a purity of 99- 9 %. 

Pure pyridine may be prepared from technical coal-tar pyridine in the following manner. The technical pyridine is first dried over solid sodium hydroxide, distilled through an efficient fractionating column, and the fraction, b.p. 114 116° collected. Four hundred ml. of the redistilled p)rridine are added to a reagent prepared by dissolving 340 g. of anhydrous zinc chloride in a mixture of 210 ml. of concentrated hydrochloric acid and 1 litre of absolute ethyl alcohol. A crystalline precipitate of an addition compound (probable composition 2C5H5N,ZnCl2,HCl ) separates and some heat is evolved. When cold, this is collected by suction filtration and washed with a little absolute ethyl alcohol. The yield is about 680 g. It is recrystaUised from absolute ethyl alcohol to a constant m.p. (151-8°). The base is liberated by the addition of excess of concentrated... 

The 40-45 per cent, hydrazine solution may be concentrated as follows. A mixture of 150 g. (144 ml.) of the solution and 230 ml. of xylene is distilled from a 500 ml. round-bottomed flask through a well-lagged Hempel (or other efficient fractionating) column fitted into a cork covered with tin foil. All the xylene passes over with about 85 ml. of water. Upon distillation of the residue, about 50 g. of 90-95 per cent, hydrazine hydrate (5) are obtained. 

Sulphuric acid method. Place 20 g. of commercial cycZohexanol and 0-6 ml. of concentrated sulphuric acid in a 150 or 200 ml. round-bottomed or bolt head flask, add 2-3 chips of porous porcelain, and mix well. Fit the flask with a fractionating column, a Liebig condenser, adapter and filter flask receiver as in Section 111,10 (1). Heat the flask in an air bath (Fig. II, 5, 3) at such a rate that the temperature at the top of the column does not rise above 90° alternatively, an oil bath, heated to a temperature of 130-140°, may be used. Stop the distillation when only a small residue remains and the odour of sulphur dioxide is apparent. Transfer the distillate to a small separatory funnel. 

Use the apparatus detailed in Section 111,20. Dissolve 100 g. (123 ml.) of methyl n-butyl ketone (2-hexanone) (Section 111,152) in 750 ml. of ether and add 150 ml. of water. Introduce 69 g. of clean sodium in the form of wire (or small pieces) as rapidly as possible the reaction must be kept under control and, if necessary, the flask must be cooled in ice or in running water. When all the sodium has reacted, separate the ethereal layer, wash it with 25 ml. of dilute hydrochloric acid (1 1), then with water, dry with anhydrous potassium carbonate or with anhydrous calcium sulphate, and distil through a fractionating column. Collect the fraction of b.p. 136-138°. The yield of methyl n-butyl carbinol (2-hexanol) is 97 g. 

Freshly distilled ethyl formate must be used. Commercial ethyl formate may be purified as follows. Allow the ethyl formate to stand for 1 hour with 16 per cent, of its weight of anhydrous potassium carbonate with occasional shaking. Decant the ester into a dry flask containing a little fresh anhydrous potassium carbonate and allow to stand for a further hour. Filter into a di flask and distil through an efficient fractionating column, and collect the fraction, b.p. 53-54° protect the receiver from atmospheric moisture. 

The lower pyridine layer contains most of the excess of thionyl chloride it may be recovered by distillation through an efficient fractionating column. 

By the controlled oxidation of primary alcohols with a solution of potassium or sodium dichromate in dilute sulphuric acid. To avoid the further oxidation to the corresponding acid, the aldehyde is removed as rapidly as possible by distillation through a fractionating column, for example ... 

To obtain pure acetaldehyde, the product must be redistilled. Clean and dry the 200-250 ml. flask first used, immerse it in cold or ice water pour in the crude acetaldehyde rapidly, attach the fractionating column, etc. Immerse the receiver in crushed ice. Heat the flask gently in a water bath and adjust the temperature so that the aldehyde distils slowly and at a uniform temperature. The temperature recorded at the top of the column may depend partly upon the temperature of the laboratory, if this is above 21°. Pure acetaldehyde boils at 21°. 

Fit a 750 ml. round-bottomed flask with a fractionating column attached to a condenser set for downward distillation. Place 500 g. of diacetone alcohol (the crude product is quite satisfactory), 01 g. of iodine and a few fragments of porous porcelain in the flask. Distil slowly. with a small free flame (best in an air bath) and collect the following fractions (a) 56-80° (acetone and a little mesityl oxide) (6) 80-126° (two layers, water and mesityl oxide) and (c) 126-131° (mesityl oxide). Whilst fraction (c) is distilling, separate the water from fraction (6), dry with anhydrous potassium carbonate or anhydrous magnesium sulphate, and fractionate from a small flask collect the mesityl oxide at 126-131°. The yield is about 400 g. 

---