Fourier NMR

Equation (4.2.11) describes the response to three delta pulses separated by ti =oi — 02 >0, t2 = 02 — 03 > 0, and t3 = 03 > 0. Writing the multi-pulse response as a function of the pulse separations is the custom in multi-dimensional Fourier NMR [Eml ]. Figure 4.2.3 illustrates the two time conventions used for the nonlinear impulse response and in multi-dimensional NMR spectroscopy for n = 3. Fourier transformation of 3 over the pulse separations r, produces the multi-dimensional correlation spectra of pulsed Fourier NMR. Foinier transformation over the time delays <7, produces the nonlinear transfer junctions known from system theory or the nonlinear susceptibilities of optical spectroscopy. The nonlinear susceptibilities and the multi-dimensional impulse-response functions can also be measured with multi-resonance CW excitation, and with stochastic excitation piul]. 

Broadening of the projection by the NMR spectrum (see Equation (5.11)), can be avoided if the spatial information is detected indirectly in the fashion of multidimensional Fourier NMR [16] A magnetic-field gradient is switched on for an evolution time ty following an rf excitation pulse, and the signal is acquired in a detection time t2 after the gradient has been switched off. For this 2D scheme, the signal can be written as... 

Processing of the NMR data has significant contribution to the quantitativity of the spectrum. To achieve a 2D NMR spectrum where cross peaks can be integrated with confidence, several factors that affect the spectrum must be considered. In the ID pulse-Fourier NMR spectroscopy the excited magnetization... 

A. G. Redfield and S. D. Kunz, "Quadrature Fourier NMR detection Simple multiplex for dual detection and discussion,"... 

Hi. Planar-integral projection reconstruction. Fourier NMR imaging techniques suggested the possibility of exciting the entire volume of an object, thereby obtaining planar-integral data sets with which an efficient volume image reconstruction could be formed. 

As in the case of infrared, progress in computing and the development of powerful algorithms for Fourier transforms has made the development of pulse NMR possible. 

The general task is to trace the evolution of the third order polarization of the material created by each of the above 12 Raman field operators. For brevity, we choose to select only the subset of eight that is based on two colours only—a situation that is connnon to almost all of the Raman spectroscopies. Tliree-coloiir Raman studies are rather rare, but are most interesting, as demonstrated at both third and fifth order by the work in Wright s laboratory [21, 22, 23 and 24]- That work anticipates variations that include infrared resonances and the birth of doubly resonant vibrational spectroscopy (DOVE) and its two-dimensional Fourier transfomi representations analogous to 2D NMR [25]. 

The remarkable stability and eontrollability of NMR speetrometers penults not only the preeise aeeiimulation of FIDs over several hours, but also the aequisition of long series of speetra differing only in some stepped variable sueh as an interpulse delay. A peak at any one ehemieal shift will typieally vary in intensity as this series is traversed. All the sinusoidal eomponents of this variation with time ean then be extraeted, by Fourier transfomiation of the variations. For example, suppose that the nomial ID NMR aequisition sequenee (relaxation delay, 90° pulse, eolleet FID) is replaeed by the 2D sequenee (relaxation delay, 90° pulse, delay i -90° pulse, eolleet FID) and that x is inereased linearly from a low value to ereate the seeond dimension. The polarization transfer proeess outlined in die previous seetion will then eause the peaks of one multiplet to be modulated in intensity, at the frequeneies of any other multiplet with whieh it shares a eoupling. 

The original method employed was to scan eitiier the frequency of the exciting oscillator or to scan the applied magnetic field until resonant absorption occiined. Flowever, compared to simultaneous excitation of a wide range of frequencies by a short RF pulse, the scanned approach is a very time-inefficient way of recording the spectrum. Flence, with the advent of computers that could be dedicated to spectrometers and efficient Fourier transfomi (FT) algoritluns, pulsed FT NMR became the nomial mode of operation. 

For quadnipolar nuclei, the dependence of the pulse response on Vq/v has led to the development of quadnipolar nutation, which is a two-dimensional (2D) NMR experiment. The principle of 2D experiments is that a series of FIDs are acquired as a fimction of a second time parameter (e.g. here the pulse lengdi applied). A double Fourier transfomiation can then be carried out to give a 2D data set (FI, F2). For quadnipolar nuclei while the pulse is on the experiment is effectively being carried out at low field with the spin states detemiined by the quadnipolar interaction. In the limits Vq v the pulse response lies at v and... 

Miller R J and Closs G L 1981 Application of Fourier transform-NMR spectroscopy to submicrosecond time-resolved detection in laser flash photolysis experiments Rev. Sc/. Instrum. 52 1876-85... 

This is the description of NMR chemical exchange in the time domain. Note that this equation and equation (B2.4.11)) are Fourier transfomis of each other. The time-domain and frequency-domain pictures are always related in this way. 

An alternative approach to obtaining microwave spectroscopy is Fourier transfonn microwave (FTMW) spectroscopy in a molecular beam [10], This may be considered as the microwave analogue of Fourier transfonn NMR spectroscopy. The molecular beam passes into a Fabry-Perot cavity, where it is subjected to a short microwave pulse (of a few milliseconds duration). This creates a macroscopic polarization of the molecules. After the microwave pulse, the time-domain signal due to coherent emission by the polarized molecules is detected and Fourier transfonned to obtain the microwave spectmm. 

One of the teehniques to whieh ehemists are frequently exposed is Fourier transforms. They are used in NMR and IR speetroseopy, quantum meehanies, and elassieal meehanies. 

Like NMR spectrometers some IR spectrometers oper ate in a continuous sweep mode whereas others em ploy pulse Fourier transform (FT IR) technology All the IR spectra in this text were obtained on an FT IR instrument... 

From the Heisenberg uncertainty principle as stated in Equation (1.16) estimate, in cm and Hz, the wavenumber and frequency spread of pulsed radiation with a pulse length of 30 fs, typical of a very short pulse from a visible laser, and of 6 ps, typical of pulsed radiofrequency radiation used in a pulsed Fourier transform NMR experiment. 

Fourier transform spectroscopy in the radio frequency region has been applied most importantly in pulsed Fourier transform NMR spectroscopy, which is not a subject which... 

Most hydrocarbon resins are composed of a mixture of monomers and are rather difficult to hiUy characterize on a molecular level. The characteristics of resins are typically defined by physical properties such as softening point, color, molecular weight, melt viscosity, and solubiHty parameter. These properties predict performance characteristics and are essential in designing resins for specific appHcations. Actual characterization techniques used to define the broad molecular properties of hydrocarbon resins are Fourier transform infrared spectroscopy (ftir), nuclear magnetic resonance spectroscopy (nmr), and differential scanning calorimetry (dsc). 

---