Extractive alkylation with

One example of normal-phase liquid chromatography coupled to gas chromatography is the determination of alkylated, oxygenated and nitrated polycyclic aromatic compounds (PACs) in urban air particulate extracts (97). Since such extracts are very complex, LC-GC is the best possible separation technique. A quartz microfibre filter retains the particulate material and supercritical fluid extraction (SPE) with CO2 and a toluene modifier extracts the organic components from the dust particles. The final extract is then dissolved in -hexane and analysed by NPLC. The transfer at 100 p.1 min of different fractions to the GC system by an on-column interface enabled many PACs to be detected by an ion-trap detector. A flame ionization detector (PID) and a 350 p.1 loop interface was used to quantify the identified compounds. The experimental conditions employed are shown in Table 13.2. 

Flowever, information concerning the characteristics of these systems under the conditions of a continuous process is still very limited. From a practical point of view, the concept of ionic liquid multiphasic catalysis can be applicable only if the resultant catalytic lifetimes and the elution losses of catalytic components into the organic or extractant layer containing products are within commercially acceptable ranges. To illustrate these points, two examples of applications mn on continuous pilot operation are described (i) biphasic dimerization of olefins catalyzed by nickel complexes in chloroaluminates, and (ii) biphasic alkylation of aromatic hydrocarbons with olefins and light olefin alkylation with isobutane, catalyzed by acidic chloroaluminates. 

The necessary C10/13 cut for the hydrophobic part of the molecule can be obtained by various methods. Suitable paraffins were obtained in the USA from kerosene (distillation range 200-250°C). The kerosene was extracted above all from Pennsylvania oil. These mainly straight chain paraffins with 12-14 C atoms were chlorinated and their reaction products alkylated with benzene in the presence of a Lewis acid and sulfonated with oleum. The first products in the USA were called Nacconol NR and NRSF (National Aniline and Chemical Co., NACCO ), as well as Santomerse 1 (Monsanto) [4]. 

Ethylenethiourea (ETU) is a toxic decomposition product/metabolite of alky-lenebis(dithiocarbamates). This compound could be generated during processing of treated crops at elevated temperature. Different chromatographic methods to determine the residue levels of ETU have been published. After extraction with methanol, clean-up on a Gas-Chrom S/alumina column and derivatization (alkylation) with bro-mobutane, ETU residues can be determined by GC with a flame photometric detector in the sulfur mode. Alternatively, ETU residues can also be determined by an HPLC method with UV detection at 240 nm or by liquid chromatography/mass spectrometry (LC/MS) or liquid chromatography/tandem mass spectrometry (LC/MS/MS) (molecular ion m/z 103). ... 

Extractive alkylation is used to derivatize acids, phenols, alcohols or amides in aqueous solution [435,441,448,502]. The pH of the aqueous phase is adjusted to ensure complete ionization of the acidic substance which is then extracted as an ion pair with a tetraalkylammonium hydroxide into a suitable immiscible organic solvent. In the poorly solvating organic medium, the substrate anion possesses high reactivity and the nucleophilic displacement reaction with an alkyl halide occurs under favorable conditions. 

Reactions of trident and ambident anions of hydroxy compounds with alkylating reagents were also studied.121 The ion-pair extraction method was found to be superior alkylating agents were methyl iodide (soft) and dimethyl sulfate (hard). Upon alkylation by ion-pair extraction the 5-methyl-substituted selenolene-2-one system gives mainly C-alkylation with the soft acid, methyl iodide, and mainly O-alkylation with the hard acid, dimethyl sulfate. 

Takada and Ishimatari [20] extracted alkylbenzenes with normal C10-C14 and branched Cn-C13 alkyl chains from marine and coastal sediment and suspended matter in benzene methanol. The extract in benzene was then applied to a Florisil column for removal of copper sulphide and polar materials, and then subjected to silica gel column chromatography. Alkyl benzenes were quantified and identified using gas chromatography with flame ionization detection. The recoveries of alkyl benzenes were 81-94%. 

Hattori [77] extracted alkyl and alkyltin compounds from sediments with methanoic hydrochloric acid and then, following mixture with sodium chloride and water, the mixture was extracted with benzene and converted to hydrides with sodium borohydride and analysed by gas chromatography using an electron capture detector. Down to 0.02mg kg 1 organotin compounds in sediments could be determined with a recovery of 70-95%. 

Methylenesulphones are more acidic than the simple esters, ketones and cyano compounds and are more reactive with haloalkanes [e.g. 48-57] to yield precursors for the synthesis of aldehydes [53], ketones [53], esters [54] and 1,4-diketones [55] (Scheme 6.4). The early extractive alkylation methods have been superseded by solidtliquid phase-transfer catalytic methods [e.g. 58] and, combined with microwave irradiation, the reaction times are reduced dramatically [59]. The reactions appear to be somewhat sensitive to steric hindrance, as the methylenesulphones tend to be unreactive towards secondary haloalkanes and it has been reported that iodomethylsulphones cannot be dialkylated [49], although mono- and di-chloromethylsulphones are alkylated with no difficulty [48, 60] and methylenesulphones react with dihaloalkanes to yield cycloalkyl sulphones (Table 6.5 and 6.6). When the ratio of dihaloalkane to methylene sulphone is greater than 0.5 1, open chain systems are produced [48, 49]. Vinyl sulphones are obtained from the base-catalysed elimination of the halogen acid from the products of the alkylation of halomethylenesulphones [48]. 

SYNTHESIS and CHARACTERIZATION of O-ALKYLATED EXTRACTS. Alkylation occurs when tetrabutylanunonium hydroxide is used to promote the reaction of the alkyl iodide with the coal in tetrahydrofuran.(14) The alkylation reaction occurs primarily on acidic oxygen functionalities such as phenolic hydroxyl and carboxylic acid groups, as shown below. 

SURFACE AREAS. CO2 B-E-T surface areas of the unground and ground extracts were determined. The results are shown in Table III. O-methylation increases the surface area of the extract, but then the surface area of the extract decreases with increasing size of the added alkyl group. Ttit effect of... 

Such reactions can take place predominantly in either the continuous or disperse phase or in both phases or mainly at the interface. Mutual solubilities, distribution coefficients, and the amount of interfadal surface are factors that determine the overall rate of conversion. Stirred tanks with power inputs of 5-10 HP/1000 gal or extraction-type equipment of various kinds are used to enhance mass transfer. Horizontal TFRs usually are impractical unless sufficiently stable emulsions can be formed, but mixing baffles at intervals are helpful if there are strong reasons for using such equipment. Multistage stirred chambers in a single shell are used for example in butene-isobutane alkylation with sulfuric acid catalyst. Other liquid-liquid processes listed in Table 17.1 are numbers 8, 27, 45, 78, and 90. 

This has been studied much less frequently and appears to be a rather more complex reaction. The first results obtained, for the butyl-lithium, styrene reaction in benzene have already been described. In a similar way the addition of butyllithium to 1,1-diphenylethylene shows identical kinetic behaviour in benzene (26). Even the proton extraction reaction with fluorene shows the typical one-sixth order in butyllithium (27). It appears therefore that in benzene solution at least, lithium alkyls react via a small equilibrium concentration of unassociated alkyl. This will of course not be true for reactions with polar molecules for reasons which will be apparent later. No definite information can be obtained on the dissociation process. It is possible that the hexamer dissociates completely on removal of one molecule or that a whole series of penta-mers, tetramers etc. exist in equilibrium. As long as equilibrium is maintained, the hexamer is the major species present and only monomeric butyllithium is reactive, the reaction order will be one-sixth. A plausible... 

Endonuclease II of E. coli was first recognized by Friedberg and Goldthwait as an activity in extracts of E. coli mutants lacking endonuclease I, that specifically attacked double-stranded DNA alkylated with the monofunctional alkylating agent methyl methane sulfonate (56). It was subsequently found that the partially purified enzyme could in fact... 

Amino acid synthesis (8, 389). Alkylation of the aldimine (1) from glycine ethyl ester and /j-chlorobenzaldehyde under phase-transfer conditions offers a general route to amino acids. Either liquid-liquid phase-transfer or solid-liquid phase-transfer catalytic conditions are satisfactory with active halides, but alkylation with allylic halides and less active alkyl halides is best effected under ion-pair extraction conditions (6,41), with 1 equiv. of tetra-n-butylammonium hydrogen sulfate (76-95% yields).1... 

---