Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Ethers infrared spectrum

Infrared Spectroscopy of Ethers Infrared spectra do not show obvious or reliable... [Pg.633]

Although no chemical reaction occurs, measurements of the freezing point and infra-red spectra show that nitric acid forms i i molecular complexes with acetic acid , ether and dioxan. In contrast, the infrared spectrum of nitric acid in chloroform and carbon tetrachloride - is very similar to that of nitric acid vapour, showing that in these cases a close association with the solvent does not occur. [Pg.32]

Section 16 18 An H—C—O—C structural unit m an ether resembles an H—C—O—H unit of an alcohol with respect to the C—O stretching frequency m its infrared spectrum and the H—C chemical shift m its H NMR spectrum Because sulfur is less electronegative than oxygen the H and chemical shifts of H—C—S—C units appear at higher field than those of H—C—O—C... [Pg.695]

In a 250 ml Erlenmeyer flask covered with aluminum foil, 14.3 g (0.0381 mole) of 17a-acetoxy-3j5-hydroxypregn-5-en-20-one is mixed with 50 ml of tetra-hydrofuran, 7 ml ca. 0.076 mole) of dihydropyran, and 0.15 g of p-toluene-sulfonic acid monohydrate. The mixture is warmed to 40 + 5° where upon the steroid dissolves rapidly. The mixture is kept for 45 min and 1 ml of tetra-methylguanidine is added to neutralize the catalyst. Water (100 ml) is added and the organic solvent is removed using a rotary vacuum evaporator. The solid is taken up in ether, the solution is washed with water and saturated salt solution, dried over sodium sulfate, and then treated with Darco and filtered. Removal of the solvent followed by drying at 0.2 mm for 1 hr affords 18.4 g (theory is 17.5 g) of solid having an odor of dihydropyran. The infrared spectrum contains no hydroxyl bands and the crude material is not further purified. This compound has not been described in the literature. [Pg.56]

The infrared spectrum of 2-hydroxythiophene was originally interpreted as showing both vOH and vC=0 peaks indicating that it exists as a mixture of the hydroxy form 39 (R — H) and at least one of the 0X0 forms, 40 and/or 41. The ultraviolet spectrum of 2-hydroxythiophene is different from that of the corresponding methyl ether (39, R = Me) suggesting the presence of the chromophore contained in structure 40. The facts that this compound gives a positive... [Pg.8]

The chemical reactions of this compound were recently reconsidered, and both structures 64 and 65 were rejected in favor of the zwit-terion formulation 66, which is supported by the presence of a band at S.lfx (3226 cm ) in the infrared spectrum and is merely an alternative canonical form of 64. On the other hand, the ultraviolet spectrum of 4-hydroxypyrrole-2-carboxylic acid (67) resembles that of its ethyl ether, possibly indicating that the 2-acid exists in the hydroxy form. -... [Pg.15]

Infrared spectrum, benzaldehyde, 730 butanoic acid, 771 cyclohexane., 436 cyclohexanol, 633 cyclohexanone, 730 cyclohexene. 436 cyclohexylamine, 952 diethyl ether, 671 ethanol, 421 hexane. 424 1-hexene, 424 1-hexyne, 424 phenol, 633... [Pg.1302]

The ethereal filtrate and washings are distilled under reduced pressure (Note 9) with the use of a 6-in. Vigreux column, and pure ketene di(2-methoxyethyl) acetal (Note 10) is obtained b.p. 81-84° (2.0 mm.), m25d 1.4411, yield 98-132 g. (56-75%). The infrared spectrum of the product shows a very strong C=C absorption band at 1640 cm.-1. [Pg.79]

The reactions of arenediazonium ions with 7V-alkyl- or 7V-arylhydroxylamines were investigated by Bamberger (1920b, and earlier papers). Mitsuhashi et al. (1965) showed that the l,3-diaryl-3-hydroxytriazenes are tautomeric with 1,3-diaryltriazene-3-oxides (Scheme 6-16). Oxidation of 1,3-diaryltriazenes with peroxybenzoic acid in ether yields the same product as that from diazonium salts and TV-arylhydroxyl-amine. The infrared spectrum of the product obtained by coupling diazotized relabeled aniline with A/-phenylhydroxylamine indicates that the diaryltriazene-oxide is the preponderant tautomer. [Pg.121]

Otsuka et al. (107) describe [Ni(CNBu )2], as a reddish brown microcrystalline substance, which is extremely air-sensitive. It can be recrystallized from ether at —78°C, and is soluble in benzene in the latter solution the infrared spectrum (2020s, br, 1603m, 1210m) and proton NMR (three peaks of equal intensity at t8.17, 8.81, and 8.94) were obtained. Neither analytical data nor molecular weight is available on this complex. The metal-ligand stoichiometry is presumably established by virtue of the molar ratio of reactants and by the stoichiometries of various reaction products. [Pg.70]

After the completion of the reaction, the solution was acidified to a pH of 4 with 2N sulfuric acid, followed by the addition of 50 ml of water. The solution was then extracted several times with ether. The extractant was dried over magnesium sulfate and the solvent was removed by evaporation at reduced pressure. Cold petroleum ether was then added to the resultant oily material to precipitate the product. The product was further washed with cold (10° C) petroleum ether and recrystallized several times from warm petroleum ether. The melting point of the final product was 73.5° C. Infrared spectrum of the product showed major absorption peaks relevant to the pure monomer (Figure 1). Under UV radiation, white flakes of the monomer solid turned deep blue (partial polymerization). [Pg.216]

The infrared spectrum of erythromycin is commonly used for its identification. Figure 2 shows the spectrum of a 75 mg./ml. chloroform solution. The bands at 1685 and 1730 cm- are due to the ketone carbonyl and the lactone carbonyl, respectively. The absorption peaks between 1000 and 1200 cm-1 are due to the ethers and amine functions. The CH2 bending is evidenced by peaks between 1340 and 1460 cm-, and alkane stretching peaks appear between 2780 and 3020 cm-. Hydrogen bonded OH and water appear as bands between 3400 and 3700 cm-1. [Pg.163]

C. 1 -Phenylcyclopentanecarboxaldehyde. The crude tetrahy-drooxazine (25.0 g., 0.092 mole) from Part B is heated at reflux with 300 ml. of water containing 37.8 g. (0.300 mole) of oxalic acid dihydrate for 3 hours. The solution is cooled, and the aldehyde is extracted with four 150-ml. portions of petroleum ether (b.p. 40-60°). The organic extracts are combined and washed with 10 ml. of saturated sodium bicarbonate solution and dried with anhydrous powdered magnesium sulfate. The petroleum ether is removed by distillation with a rotary evaporator, and the product is distilled through a Vigreux column to give 7.8-8.7 g. (50-55%) of 1-phenylcyclopentane-carboxaldehyde, b.p. 70-73° (0.1 mm.) n26-BD 1.5350, infrared spectrum (neat) 1720 cm.-1 (C= 0) (Note 12). [Pg.14]

B. Hydrogenolysis of the Phenolic Ether Biphenyl. To a solution of 10 g. (0.032 mole) of the product from Part A in 200 ml. of benzene is added 2 g. of 5% palladium-on-charcoal, and the mixture is shaken with hydrogen in a Parr apparatus at 40 p.s.i. and 35-40° for 8 hours (Note 3). The mixture is filtered, and the insoluble residue is washed with three 100-ml. portions of hot ethanol (Note 4). The filtrates are combined, and the solvent is removed by means of a rotary evaporator at 60° (12 mm.) to leave a solid residue. The product is dissolved in 100 ml. of benzene, and 100 ml. of 10% sodium hydroxide solution is added. The mixture is shaken, and the layers are separated. The aqueous layer is extracted with 100 ml. of benzene, and the original benzene layer is washed with 100 ml. of water (Note 5). The benzene solutions are combined and dried over magnesium sulfate. Removal of the benzene by distillation yields 4.0-4.7 g. (82-96%) of biphenyl as a white powder, m.p. 68-70° (Note 6). The infrared spectrum is identical with that of an authentic sample, and a purity of at least 99.5% was indicated by gas chromatography analysis. [Pg.126]

Di-p-chloro-bis(i74-l,5-cyclooctadiene)dirhodium(I) is a yellow-orange, air-stable solid. It can be used directly as obtained for preparative purposes5 or as a precursor for homogeneous catalysts.3,4 It can be recrystallized from dichloro-methane-diethyl ether to give orange prisms. The compound is soluble in dichloro-methane somewhat less soluble in acetone and insoluble in pentane and diethyl ether. Characteristic strong bands occur in the infrared spectrum at 819, 964, and 998 cm 1 (Nujol mull). The cyclooctadiene vinylic protons resonate in the 1H NMR spectrum at t 5.7 and the allylic protons at t 7.4-8.3 (deuteriochloroform solution). Other physical properties are given by Chatt.1... [Pg.219]


See other pages where Ethers infrared spectrum is mentioned: [Pg.631]    [Pg.111]    [Pg.487]    [Pg.913]    [Pg.913]    [Pg.521]    [Pg.42]    [Pg.44]    [Pg.98]    [Pg.695]    [Pg.325]    [Pg.117]    [Pg.316]    [Pg.66]    [Pg.17]    [Pg.383]    [Pg.150]    [Pg.98]    [Pg.101]    [Pg.111]    [Pg.140]    [Pg.822]    [Pg.186]    [Pg.200]    [Pg.201]    [Pg.203]    [Pg.262]    [Pg.228]    [Pg.125]    [Pg.87]    [Pg.87]   
See also in sourсe #XX -- [ Pg.688 , Pg.690 ]

See also in sourсe #XX -- [ Pg.688 , Pg.690 ]

See also in sourсe #XX -- [ Pg.688 , Pg.690 ]

See also in sourсe #XX -- [ Pg.524 ]

See also in sourсe #XX -- [ Pg.641 ]

See also in sourсe #XX -- [ Pg.581 , Pg.709 ]

See also in sourсe #XX -- [ Pg.551 , Pg.670 ]

See also in sourсe #XX -- [ Pg.482 ]

See also in sourсe #XX -- [ Pg.30 , Pg.50 , Pg.51 ]




SEARCH



Dibutyl ether infrared spectrum

Diethyl ether, infrared spectra

Dipropyl ether infrared spectrum

Infrared spectra of ethers

Infrared spectrum, benzaldehyde diethyl ether

© 2024 chempedia.info