Ethers, alkynic

The stereochemistry around the double bond was exclusively trans in the case of disubstituted olefins and it was also noteworthy that the hydration of methyl propargyl ether alkynes was regioselective, which was not the case with other alkynes. 

Gagosz extensively investigated on the gold-catalyzed cyclizations of ether-alkyne systems 145 and 147 bearing both terminal and internal alkynes in 2010. A wide range of structurally important spiro or fused dihydrofurans 146 and dihy-dropyrans 148 were dexterously constructed via a 1,5-hydride shift/cyclization sequence using alkyne as hydride acceptors (Scheme 12.64) [68]. This hydroalkylation process, which could be applied to the terminal as well as ester-substituted alkynes, allows the efficient conversion of secondary or tertiary C(sp )—H bonds into new C-C bonds under practical conditions. The stereoselectivity of the cycloisomerization process toward the formation of a new five- or six-membered cycle appears to be dependent on steric factors and alkyne substitution. 

In the flask was placed a solution of 0.44 mol of butyllithium in about 300 ml of hexane. To this solution were added, with coaling below -20°C, 800, 600 and 400 ml of dry diethyl ether (note 1) in the case of R = CH3, C2H5 and tert.-CuHj or Me3Si, respectively. Subsequently 0.46 mol of the alkyne [in the case of R = CH3, C2H5 a cooled (-30°C) solution in 50 ml of diethyl ether] was added in about 10 min, while keeping the temperature below -20 c. The suspension (in the... 

The a-bromo-7-lactone 901 undergoes smooth coupling with the acetonyltin reagent 902 to afford the o-acetonyl-7-butyrolactone 903[763j. The o-chloro ether 904, which has no possibility of //-elimination after oxidative addition, reacts with vinylstannane to give the allyl ether 905, The o -bromo ether 906 is also used for the intramolecular alkyne insertion and transmetallation with allylstannane to give 907[764],... 

Addition of a hydroxy group to alkynes to form enol ethers is possible with Pd(II). Enol ether formation and its hydrolysis mean the hydration of alkynes to ketones. The 5-hydroxyalkyne 249 was converted into the cyclic enol ether 250[124], Stereoselective enol ether formation was applied to the synthesis of prostacyclin[131]. Treatment of the 4-alkynol 251 with a stoichiometric amount of PdCl2, followed by hydrogenolysis with formic acid, gives the cyclic enol ether 253. Alkoxypalladation to give 252 is trans addition, because the Z E ratio of the alkene 253 was 33 1. 

The cyclic enol ether 255 from the functionalized 3-alkynoI 254 was converted into the furans 256 by the reaction of allyl chloride, and 257 by elimination of MeOH[132], The alkynes 258 and 260, which have two hydroxy groups at suitable positions, are converted into the cyclic acetals 259 and 261. Carcogran and frontalin have been prepared by this reaction[124]. 

The addition proceeds in three discrete steps and the intermediates can be isolated. Simple alkenes are less reactive than alkynes and do not undergo the addition to aHylic boranes, but electron-rich alkyl vinyl ethers react at moderate temperatures to give 1,4-dienes or dienyl alcohols (440). 

In 1959 Carboni and Lindsay first reported the cycloaddition reaction between 1,2,4,5-tetrazines and alkynes or alkenes (59JA4342) and this reaction type has become a useful synthetic approach to pyridazines. In general, the reaction proceeds between 1,2,4,5-tetrazines with strongly electrophilic substituents at positions 3 and 6 (alkoxycarbonyl, carboxamido, trifluoromethyl, aryl, heteroaryl, etc.) and a variety of alkenes and alkynes, enol ethers, ketene acetals, enol esters, enamines (78HC(33)1073) or even with aldehydes and ketones (79JOC629). With alkenes 1,4-dihydropyridazines (172) are first formed, which in most cases are not isolated but are oxidized further to pyridazines (173). These are obtained directly from alkynes which are, however, less reactive in these cycloaddition reactions. In general, the overall reaction which is presented in Scheme 96 is strongly... 

In the case of vinylfurans and vinylpyrroles there is the possibility of cycloaddition involving either the cyclic diene system or the diene system including the double bond. 2-Vinylfuran reacts in high yield with maleic anhydride in ether at room temperature to form the adduct involving the exocyclic double bond. Similarly, 2- and 3-vinylpyrroles react with 7T-electron-deficient alkenes and alkynes under relatively mild conditions to give the corresponding tetrahydro- and dihydro-indoles (Scheme 51) (80JOC4515). 

Hi) Preparation of isoxazoles from nitrile N-oxides The reaction between a nitrile //-oxide and an alkyne is so facile that it is usually sufficient to leave an ether solution of the reactants at room temperature to obtain the desired isoxazole in good yield. The reaction is in general sensitive to the size of the substituent on the alkyne but not on the nitrile -oxide. In the case of poorly reactive alkynes, the difficulty may be overcome by generating the nitrile -oxide in situ and keeping its concentration low. 

Alkynic esters react with nitrile oxides in a pH dependent reaction to product isoxazolin-5-ones (Scheme 145) (71JCS(C)86). Alkynic ethers also react with benzonitrile oxide to produce an isoxazole-ether which on treatment with HCl or HBr gave an isoxazolinone (Scheme 145) (63CB1088,58MI41600). The reaction of benzonitrile oxide with dimethoxyketene yielded a dimethyl acetal which was split with acid into the isoxazolinone (Scheme 145) (59G15H). 

The alkynylation of estrone methyl ether with the lithium, sodium and potassium derivatives of propargyl alcohol, 3-butyn-l-ol, and propargyl aldehyde diethyl acetal in pyridine and dioxane has been studied by Miller. Every combination of alkali metal and alkyne tried, but one, gives the 17a-alkylated products (65a), (65c) and (65d). The exception is alkynylation with the potassium derivative of propargyl aldehyde diethyl acetal in pyridine at room temperature, which produces a mixture of epimeric 17-(3, 3 -diethoxy-T-propynyl) derivatives. The rate of alkynylation of estrone methyl ether depends on the structure of the alkyne and proceeds in the order propar-gylaldehyde diethyl acetal > 3-butyn-l-ol > propargyl alcohol. The reactivity of the alkali metal salts is in the order potassium > sodium > lithium. 

The regio- and stereoselectivities of cycloadditions of trifluoroacetonitrile oxide, which is generated m situ by treatment of the tnfluoroacetohydroxamyl bromide etherate with tnethylamine in toluene (equation 31), have been determined in a senes of studies by Tanaka [55, 36, 37, 5 ]. The highly reactive nitnle oxide reacts regioselectively with a variety of activated terminal alkenes and alkynes (equations 32 and 33)... 

The reaction of tnfluoromethyl-substituted A -acyl umnes toward nucleophiles in many aspects parallels that of the parent polyfluoro ketones Heteronucleophiles and carbon nucleophiles, such as enarmnes [37, 38], enol ethers [38, 39, 40], hydrogen cyanide [34], tnmethylsilylcarbomlnle [2,47], alkynes [42], electron-nch heterocycles [43], 1,3-dicarbonyl compounds [44], organolithium compounds [45, 46, 47, 48], and Gngnard compounds [49,50], readily undergo hydroxyalkylation with hexafluoroace-tone and amidoalkylation with acyl imines denved from hexafluoroacetone... 

FITS reagents), has undergone considerable development recently [141,142,143, 144, 14S. These compounds, available fromperfluoroalkyhodides (equation 76), are very effective electrophilicperfluoroalkylating agents They react with carban-lons, aromatic compounds, alkenes, alkynes, silyl enol ethers, and other nucleophiles under mild conditions to introduce the perfluoroalkyl moiety mto organic substrates (equation 77) (see the section on alkylation, page 446). 

---