Epoxides catalyst

Arsenic Peroxides. Arsenic peroxides have not been isolated however, elemental arsenic, and a great variety of arsenic compounds, have been found to be effective catalysts ia the epoxidation of olefins by aqueous hydrogen peroxide. Transient peroxoarsenic compounds are beheved to be iavolved ia these systems. Compounds that act as effective epoxidation catalysts iaclude arsenic trioxide, arsenic pentoxide, arsenious acid, arsenic acid, arsenic trichloride, arsenic oxychloride, triphenyl arsiae, phenylarsonic acid, and the arsenates of sodium, ammonium, and bismuth (56). To avoid having to dispose of the toxic residues of these reactions, the arsenic can be immobi1i2ed on a polystyrene resia (57). 

Dihydronaphthalene is often used as a model olefin in the study of epoxidation catalysts, and very often gives product epoxides in unusually high ee s. In 1994, Jacobsen discovered in his study on the epoxidation of 1,2-dihydronaphthalene that the ee of the epoxide increases at the expense of the minor enantiomeric epoxide.Further investigation led to the finding that certain epoxides, especially cyclic aromatically conjugated epoxides, undergo kinetic resolution via benzylic hydroxylation up to a krei of 28 (Scheme 1.4.9). 

It seems that silver is a unique epoxidation catalyst for ethylene. All other catalysts are relatively ineffective, and the reaction to ethylene is limited among lower olefins. Propylene and butylenes do not form epoxides through this route. ... 

The second major discovery regarding the use of MTO as an epoxidation catalyst came in 1996, when Sharpless and coworkers reported on the use of substoichio-metric amounts of pyridine as a co-catalyst in the system [103]. A change of solvent from tert-butanol to dichloromethane and the introduction of 12 mol% of pyridine even allowed the synthesis of very sensitive epoxides with aqueous hydrogen peroxide as the terminal oxidant. A significant rate acceleration was also observed for the epoxidation reaction performed in the presence of pyridine. This discovery was the first example of an efficient MTO-based system for epoxidation under neutral to basic conditions. Under these conditions the detrimental acid-induced decomposition of the epoxide is effectively avoided. With this novel system, a variety of... 

There are, however, numerous cases where electronegative additives can act as promoters for catalytic reactions. Typical examples are the use of Cl to enhance the selectivity of Ag epoxidation catalysts and the plethora of electrochemical promotion studies utilizing O2 as the promoting ion, surveyed in Chapters 4 and 8 of this book. The use of O, O8 or O2 as a promoter on metal catalyst surfaces is a new development which surfaced after the discovery of electrochemical promotion where a solid O2 conductor interfaced with the metal catalyst acts as a constant source of promoting O8 ions under the influence of an applied voltage. Without such a constant supply of O2 onto the catalyst surface, the promoting O8 species would soon be consumed via desorption or side reactions. This is why promotion with O2 was not possible in classical promotion, i.e. before the discovery of electrochemical promotion. 

Electrochemical promotion has also been used to determine the optimal alkali promoter coverage on Ag epoxidation catalysts as a function of chlorinated hydrocarbon moderator level in the gas phase (Chapter 8). 

The preparation of novel triazole-containing 20-22 membered macrocyclic azacrown ether-thioethers was reported <96JCR(S)182> and the first selective synthetic method fra the synthesis of dicyanotriazolehemiporhyrazines was published <96JOC6446>. 1,2,4-Triazole-containing polyimide beads were prepared and employed as Mo(VI) epoxidation catalyst supports, liie 1,2,4-nitronyl nitroxide 29 was also synthesized and found to have remarkable magnetic properties <96AM60>. 

Figure 4.6 An enantioselec-live MOF epoxidation catalyst. Zn-(l,4 -biphenyldicarboxylate) sheets in the ab direction are connected by functionalized Mn-salen ligands to form a doubly...

Entry equjv. equiv Recovered Epoxide Catalyst Catalyst Loading Time (h) % YieldCee) ... 

In this work, highly active epoxidation catalysts, which have hydrophobic surface of TS-1, were synthesized by the dry gel conversion (DGC) method. Ti-MCM-41 was synthesized first by a modifed method and the TS-l/MCM-41 catalysts were subsequently synthesized by the DGC method. The catalysts were characterized by the XRD, BET, FT-IR, and UV-VIS spectroscopy. TS-l/MCM-41 catalysts were applied to the epoxidation of 1-hexene and cyclohexene with aqueous H202to evaluate their activities for the epoxidation reaction. ... 

Scheme 4.1 Epoxidation catalysts tested in two-phase solvent systems.

A heterogeneous olefin epoxidation catalyst containing both V and Ti in the active site was prepared by sequential non-hydrolytic grafting. The silica was exposed first to VO(OiPr)3 vapor followed by Ti(0 Pr)4 vapor. Formation of propene is evidence for the creation of Ti-O-V linkages on the surface. Upon metathesis of the 2-propoxide ligands with BuOOH, the catalyst becomes active for the gas phase epoxidation of cyclohexene. The kinetics of epoxidation are biphasic, indicating the presence of two reactive sites whose activity differs by approximately one order of magnitude. 

By complexation of MnNaY with 1,4,7-trimethyltriazacyclononane, a new heterogeneous catalyst was obtained for olefin epoxidation with H202. Excellent epoxide selectivities were obtained, with limited epoxide solvolysis. The oxygenation appears to go through a radical intermediate. The manganese trizacyclononane epoxidation catalyst was also heterogenized via surface gly-cidylation.103... 

These reports sparked off an extensive study of metalloporphyrin-catalyzed asymmetric epoxidation, and various optically active porphyrin ligands have been synthesized. Although porphyrin ligands can make complexes with many metal ions, mainly iron, manganese, and ruthenium complexes have been examined as the epoxidation catalysts. These chiral metallopor-phyrins are classified into four groups, on the basis of the shape and the location of the chiral auxiliary. Class 1 are C2-symmetric metalloporphyrins bearing the chiral auxiliary at the... 

Another method for generating an epoxidation catalyst on a solid support is to simply absorb or non-covalendy attach the catalyst to the solid support <06MI493>. Epoxidation of olefin 6 with mCPBA and catalyst 8 provides 7 in quantitative yields and with 89% ee. The immobilization of 8 on silica gel improves the enantioselectivity of the reaction providing 7 with 95% ee. Recycling experiments with silica-8 show a decrease in both yield and the enantiomeric excess for each cycle (45% ee after 4 cycles). This is attributed to a leaching of the catalyst from the silica gel. Two other solid supports, a Mg-Al-Cl-LDH resin (LDH) and a quaternary ammonium resin (Q-resin) were also examined. It was expected that ionic attraction between 8 and the LDH or Q-resin would allow the catalyst to remain immobilized through multiple cycles better than with silica gel. Both of these resins showed improved catalytic properties upon reuse of the catalyst (92-95% ee after 4 cycles). 

Dimethylchromene has also proven to be a useful substrate for the assessment of various transition metal complexes as epoxidation catalysts. Chiral Mn(III)-salen complexes are efficient <00CC615 00T417> and can be recycled when used in an ionic liquid <00CC837>. The enantioselective aziridination of a chromene has been achieved using a chiral biaryldiamine-derived catalyst (Scheme 22) <00JA7132>. 

As long as the pore diameters are large enough for easy entry and exit of reactant and product molecules, the catalyst porosity features do not have a significant influence on the epoxidation activity. In a comparison between two epoxidation catalysts obtained by grafting Ti( o-PrO )4 on MCM-41 and an amorphous silica gel, respectively, the former showed a lower activity (189). 

The authors postulated that on these materials complete site isolation is not mandatory in order to have active and selective titania-silica epoxidation catalysts . The 100% selectivity of the dinuclear, silica-supported... 

Later, Jacobsen and co-worker (31) reported the use of a parallel approach for the discovery of new epoxidation catalysts. With a focus on catalyst activity, a three-phase approach was taken. Four different linkers to the polystyrene support... 

Epoxidation catalysts, organic titanium compounds as, 25 135 Epoxide determinations, 10 385 Epoxide equivalent mass (EEM), 10 355 Epoxide equivalent weight (EEW), 10 355, 361-363, 385... 

---