Epoxides products

A large number of methods have been used to prepare perfluoroepoxides (5). AH of these methods must contend with the great chemical reactivity of the epoxide product, especially with subsequent ionic and thermal reactions which result in the loss of the desired epoxide. 

The alkene is allowed to react at low temperatures with a mixture of aqueous hydrogen peroxide, base, and a co-solvent to give a low conversion of the alkene (29). These conditions permit reaction of the water-insoluble alkene and minimise the subsequent ionic reactions of the epoxide product. Phase-transfer techniques have been employed (30). A variation of this scheme using a peroxycarbimic acid has been reported (31). 

The direct oxidation of fluoroalkenes is also an excellent general synthesis procedure for the preparation of perfluoroepoxides (eq. 8). This method exploits the low reactivity of the epoxide products to both organic and inorganic free radicals. 

While generation of a Mn(V)oxo salen intermediate 8 as the active chiral oxidant is widely accepted, how the subsequent C-C bond forming events occur is the subject of some debate. The observation of frans-epoxide products from cw-olefins, as well as the observation that conjugated olefins work best support a stepwise intermediate in which a conjugated radical or cation intermediate is generated. The radical intermediate 9 is most favored based on better Hammett correlations obtained with o vs. o . " In addition, it was recently demonstrated that ring opening of vinyl cyclopropane substrates produced products that can only be derived from radical intermediates and not cationic intermediates. ... 

Molybdenum hexacarbonyl [Mo(CO)6] has been vised in combination with TBHP for the epoxidation of terminal olefins [44]. Good yields and selectivity for the epoxide products were obtained when reactions were performed under anhydrous conditions in hydrocarbon solvents such as benzene. The inexpensive and considerably less toxic Mo02(acac)2 is a robust alternative to Mo(CO)6 [2]. A number of different substrates ranging from simple ot-olefms to more complex terpenes have been oxidized with very low catalytic loadings of this particular molybdenum complex (Scheme 6.2). The epoxidations were carried out with use of dry TBHP (-70%) in toluene. 

The synthesis shown in Scheme 13.66 starts with the Sharpless asymmetric epoxidation product of geraniol. The epoxide was opened with inversion of configuration by NaBHjCN-BFj. The double bond was cleaved by ozonolysis and converted to the corresponding primary bromide. The terminal alkyne was introduced by alkylation of... 

The kinetics of epoxidation were measured in situ as the rate of uptake of olefin by the catalyst, since the epoxide product remains adsorbed on the catalyst surface in the absence of solvent. Addition of 2 Torr cyclohexene vapor (30 pmol) to a 14.2 mg sample of 3 (9.0 pmol Ti, 4.5 pmol V) at room temperature resulted in the loss of the o(C=C) mode in the gas phase IR spectrum over the... 

A number of additional metal-catalyzed epoxidations have been reported in the past year. Platinum is a rarely used catalyst in oxidation reactions. The use of chiral Pt-catalyst 2 in the epoxidation of terminal alkenes provides the epoxide products in moderate yield and enantiomeric excess <06JA14006>. The chiral hydroxamide 3 is used with a Mo catalyst to provide the epoxide product in excellent yields and moderate enantioselectivity <06AG(I)5849>. A bis-titanium catalyst, 4, has also been used to epoxidize the usual set of alkenes with H202 as the oxidant <06AG(I)3478>. 

Figure 4. Diol epoxide products of BP-7,8-dihydrodiol oxidation and their hydrolysis products.

In order to rationalize the complex reaction mixtures in these slurry reactions the authors suggested that irradiations of the oxygen CT complexes resulted in simultaneous formation of an epoxide and dioxetane36 (Fig. 34). The epoxide products were isolated only when pyridine was co-included in the zeolite during the reaction. Collapse of the 1,1-diarylethylene radical cation superoxide ion pair provides a reasonable explanation for the formation of the dioxetane, however, epoxide formation is more difficult to rationalize. However, we do point out that photochemical formation of oxygen atoms has previously been observed in other systems.141 All the other products were formed either thermally or photochemically from these two primary photoproducts (Fig. 34). The thermal (acid catalyzed) formation of 1,1-diphenylacetaldehyde from the epoxide during photooxygenation of 30 (Fig. 34) was independently verified by addition of an authentic sample of the epoxide to NaY. The formation of diphenylmethane in the reaction of 30 but not 31 is also consistent with the well-established facile (at 254 nm but not 366 or 420 nm) Norrish Type I... 

The titanosilicate version of UTD-1 has been shown to be an effective catalyst for the oxidation of alkanes, alkenes, and alcohols (77-79) by using peroxides as the oxidant. The large pores of Ti-UTD-1 readily accommodate large molecules such as 2,6-di-ferf-butylphenol (2,6-DTBP). The bulky 2,6-DTBP substrate can be converted to the corresponding quinone with activity and selectivity comparable to the mesoporous catalysts Ti-MCM-41 and Ti-HMS (80), where HMS = hexagonal mesoporous silica. Both Ti-UTD-1 and UTD-1 have also been prepared as oriented thin films via a laser ablation technique (81-85). Continuous UTD-1 membranes with the channels oriented normal to the substrate surface have been employed in a catalytic oxidation-separation process (82). At room temperature, a cyclohexene-ferf-butylhydroperoxide was passed through the membrane and epoxidation products were trapped on the down stream side. The UTD-1 membranes supported on metal frits have also been evaluated for the separation of linear paraffins and aromatics (83). In a model separation of n-hexane and toluene, enhanced permeation of the linear alkane was observed. Oriented UTD-1 films have also been evenly coated on small 3D objects such as glass and metal beads (84, 85). 

An important finding is that all peroxo compounds with d° configuration of the TM center exhibit essentially the same epoxidation mechanism [51, 61, 67-72] which is also valid for organic peroxo compounds such as dioxiranes and peracids [73-79], The calculations revealed that direct nucleophilic attack of the olefin at an electrophilic peroxo oxygen center (via a TS of spiro structure) is preferred because of significantly lower activation barriers compared to the multi-step insertion mechanism [51, 61-67]. A recent computational study of epoxidation by Mo peroxo complexes showed that the metallacycle intermediate of the insertion mechanism leads to an aldehyde instead of an epoxide product [62],... 

It should be added that many other groups have contributed to the predevelopments of these inventions and also to later developments. All four reactions find wide application in organic synthesis. The Sharpless epoxidation of allylic alcohols finds industrial application in Arco s synthesis of glycidol, the epoxidation product of allyl alcohol, and Upjohn s synthesis of disparlure (Figure 14.4), a sex pheromone for the gypsy moth. The synthesis of disparlure starts with a Ci3 allylic alcohol in which, after asymmetric epoxidation, the alcohol is replaced by the other carbon chain. Perhaps today the Jacobsen method can be used directly on a suitable Ci9 alkene, although the steric differences between both ends of the molecules are extremely small ... 

The organic phase was separated from the aqueous phase containing biomass by centrifugation. Epoxide products were recovered from the organic phase by vacuum distillation. 

The stereochemistry of the resnlting epoxidation products using chiral ketones, such as ketone 26, could provide new insights about the epoxidation transition states. Studies showed that the epoxidation of trans- and trisubstituted olefins with ketone 26 mainly goes through the spiro transition state (spiro A) (Fig. 10). Planar transition state B competes with spiro A to give the opposite enantiomer [53, 54]. Hence, factors that influence the competition between spiro A and planar B will also affect the enantiomeric excess of the resulting epoxides. Spiro A can be further... 

In conjunction with the chiral anion TRIP (156) (10 mol%), diamine 157 (10 mol%) can be used in the catalytic asymmetric epoxidation of a,p-unsaturated ketones (>90% ee) [196], while the secondary amine 158 (10 mol%) can be used for the epoxidation of both di- and trisubstituted a,P-unsaturated aldehydes (92-98% ee) (Fig. 15) [211], The facile nature of these reactions, using commercially available peroxides as the stoichiometric oxidant, together with the synthetic utility of the epoxide products suggests application in target oriented synthesis. 

For several alkene substrates, the yield of the epoxide product was lower when the reactions were carried out in pure CH2CI2 than in a mixed solvent system consisting of [BMIM]PFg/CH2Cl2 (3 1, v/v). The catalyst was also highly active for the epoxidation of aromatic alkenes. Although PhIO is an oxidant commonly used in organic solvents, it was found that the use of PhI(OAc)2 under the same conditions in the mixed solvent led to higher yields of the epoxides. 

---