Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Epoxides metal catalysts

The tert-huty hydroperoxide is then mixed with a catalyst solution to react with propylene. Some TBHP decomposes to TBA during this process step. The catalyst is typically an organometaHic that is soluble in the reaction mixture. The metal can be tungsten, vanadium, or molybdenum. Molybdenum complexes with naphthenates or carboxylates provide the best combination of selectivity and reactivity. Catalyst concentrations of 200—500 ppm in a solution of 55% TBHP and 45% TBA are typically used when water content is less than 0.5 wt %. The homogeneous metal catalyst must be removed from solution for disposal or recycle (137,157). Although heterogeneous catalysts can be employed, elution of some of the metal, particularly molybdenum, from the support surface occurs (158). References 159 and 160 discuss possible mechanisms for the catalytic epoxidation of olefins by hydroperoxides. [Pg.138]

Physical and Chemical Properties. The (F)- and (Z)-isomers of cinnamaldehyde are both known. (F)-Cinnamaldehyde [14371-10-9] is generally produced commercially and its properties are given in Table 2. Cinnamaldehyde undergoes reactions that are typical of an a,P-unsaturated aromatic aldehyde. Slow oxidation to cinnamic acid is observed upon exposure to air. This process can be accelerated in the presence of transition-metal catalysts such as cobalt acetate (28). Under more vigorous conditions with either nitric or chromic acid, cleavage at the double bond occurs to afford benzoic acid. Epoxidation of cinnamaldehyde via a conjugate addition mechanism is observed upon treatment with a salt of /-butyl hydroperoxide (29). [Pg.174]

Wagner was first to propose the use of solid electrolytes to measure in situ the thermodynamic activity of oxygen on metal catalysts.17 This led to the technique of solid electrolyte potentiometry.18 Huggins, Mason and Giir were the first to use solid electrolyte cells to carry out electrocatalytic reactions such as NO decomposition.19,20 The use of solid electrolyte cells for chemical cogeneration , that is, for the simultaneous production of electrical power and industrial chemicals, was first demonstrated in 1980.21 The first non-Faradaic enhancement in heterogeneous catalysis was reported in 1981 for the case of ethylene epoxidation on Ag electrodes,2 3 but it was only... [Pg.7]

There are, however, numerous cases where electronegative additives can act as promoters for catalytic reactions. Typical examples are the use of Cl to enhance the selectivity of Ag epoxidation catalysts and the plethora of electrochemical promotion studies utilizing O2 as the promoting ion, surveyed in Chapters 4 and 8 of this book. The use of O, O8 or O2 as a promoter on metal catalyst surfaces is a new development which surfaced after the discovery of electrochemical promotion where a solid O2 conductor interfaced with the metal catalyst acts as a constant source of promoting O8 ions under the influence of an applied voltage. Without such a constant supply of O2 onto the catalyst surface, the promoting O8 species would soon be consumed via desorption or side reactions. This is why promotion with O2 was not possible in classical promotion, i.e. before the discovery of electrochemical promotion. [Pg.31]

Chiral epoxides and their corresponding vicinal diols are very important intermediates in asymmetric synthesis [163]. Chiral nonracemic epoxides can be obtained through asymmetric epoxidation using either chemical catalysts [164] or enzymes [165-167]. Biocatalytic epoxidations require sophisticated techniques and have thus far found limited application. An alternative approach is the asymmetric hydrolysis of racemic or meso-epoxides using transition-metal catalysts [168] or biocatalysts [169-174]. Epoxide hydrolases (EHs) (EC 3.3.2.3) catalyze the conversion of epoxides to their corresponding vicinal diols. EHs are cofactor-independent enzymes that are almost ubiquitous in nature. They are usually employed as whole cells or crude... [Pg.157]

R)-epoxide. It is noteworthy that this stereoselective reaction cannot be accomplished with transition-metal catalysts. [Pg.159]

Epoxides can also be rearranged to aldehydes or ketones on treatment with certain metallic catalysts.A good way to prepare p-diketones consists of heating a,P-epoxy ketones at 80-140°C in toluene with small amounts of (Ph3P)4Pd and 1,2-bis(diphenylphosphino)ethane. ... [Pg.1398]

A variety of reactions have been conducted. Catalysts based on noble metals on Deloxan amino poly siloxane supports have been used. Hitzler et al. (1998) have reported alkylation of mesitylene with propylene or wopropanol in SC propylene or CO2 using a solid acid Deloxan catalyst. Pesiri et al. (1998) have carried out selective epoxidation in SC CO2 with transition metal catalysts (V, Ti, Mo) and tert-BHPO high conversion and selectivity have been reported. [Pg.173]

The catalysts which have been tested for the direct epoxidation include (i) supported metal catalysts, (ii) supported metal oxide catalysts (iii) lithium nitrate salt, and (iv) metal complexes (1-5). Rh/Al203 has been identified to be one of the most active supported metal catalysts for epoxidation (2). Although epoxidation over supported metal catalysts provides a desirable and simple approach for PO synthesis, PO selectivity generally decreases with propylene conversion and yield is generally below 50%. Further improvement of supported metal catalysts for propylene epoxidation relies not only on catalyst screening but also fundamental understanding of the epoxidation mechanism. [Pg.404]

All schemes presented are similar and conventional to a great extent. It is characteristic that the epoxidation catalysis also results in the heterolytic decomposition of hydroperoxides (see Section 10.1.4) during which heterolysis of the O—O bond also occurs. Thus, there are no serious doubts that it occurs in the internal coordination sphere of the metal catalyst. However, its specific mechanism and the structure of the unstable catalyst complexes that formed are unclear. The activation energy of epoxidation is lower than that of the catalytic decomposition of hydroperoxides therefore, the yield of oxide per consumed hydroperoxide decreases with the increase in temperature. [Pg.418]

In summary, the formation of optically active compounds through hydrolysis reactions is dominated by biocatalysis mainly due to the availability and ease of use of a wide variety of esterases, lipases and (to a lesser extent) acylases. Epoxide ring-opening (and related reactions) is likely to be dominated by salen-metal catalysts while enzyme-catalysed nitrile hydrolysis seems destined to remain under-exploited until nitrilases or nitrile hydratases become commercially available. [Pg.11]

The key factor is the action of the metal on the peroxo group making one oxygen atom electrophilic. Whether or not the metal is bonded to carbon in the intermediate is not known, but also considered unlikely naturally this will depend on the particular substrate and catalyst. Epoxidation will be discussed in Chapter 14, with special emphasis on asymmetric epoxidation with chiral metal catalysts. [Pg.52]

The reaction sequence is summarized below using isobucane as the hydrocarbon. The crucial and nearly incredible part of the process is in two parts itself but only shows as one. It is the second equation where the oxygen molecule transfers to the propylene molecule and the ring closes to form the epoxide. (Thats why they call it epoxidation). The magic that causes all that to happen is in the metal catalysts, molybdenum naphthenate or the soluble salts of titanium, vanadium, or tungsten. This molecular fancy-dance is but one of nniany examples in chemistry where catalysts can cause atoms to slide around molecules in unlikely ways. [Pg.162]

Silylformylation, defined as the addition of RsSi- and -CHO across various types of bonds using a silane R3SiH, CO, and a transition metal catalyst, was discovered by Murai and co-workers, who developed the Co2(CO)8-catalyzed silylformylation of aldehydes, epoxides, and cyclic ethers [26]. More recently, as described in detail in Section 5.3.1, below, alkynes and alkenes have been successfully developed as silylformylation substrates. These reactions represent a powerful variation on hydroformylation, in that a C-Si bond is produced instead of a C-H bond. Given that C-Si groups are subject to, among other reactions, oxidation to C-OH groups, silylformylation could represent an oxidative carbonylation of the type described in Scheme 5.1. [Pg.103]

Quan Z, Min J, Zhou Q, Xie D, Liu J, Wang X, Zhao X, Wang F (2003) Synthesis and properties of carbon dioxide-epoxides coplymers from rare earth metal catalyst. Macromol Symp 195 281-286... [Pg.47]

Aiming at easier workup conditions, immobilization of several transition metal catalysts, which show activity for the epoxidation of allylic alcohols, on polymer support has been investigated. For example, Suzuki and coworkers incorporated an oxo-vanadium ion into cross-linked polystyrene resins functionalized with iminodiacetic acid or diethylenetri-amine derivatives (Scheme 57), which afforded a heterogeneous catalyst that can promote... [Pg.391]

L Ti, Zr, Hf. Characteristic for group IV transition metal catalysts for epoxidation reactions is the intermediate formation of a mono- or bidentate coordinated alkyl hydroperoxide, hydrogen peroxide or a bidentate coordinated peroxo group in the catalytically active species. [Pg.417]

Without additives, radical formation is the main reaction in the manganese-catalyzed oxidation of alkenes and epoxide yields are poor. The heterolytic peroxide-bond-cleavage and therefore epoxide formation can be favored by using nitrogen heterocycles as cocatalysts (imidazoles, pyridines , tertiary amine Af-oxides ) acting as bases or as axial ligands on the metal catalyst. With the Mn-salen complex Mn-[AI,AI -ethylenebis(5,5 -dinitrosalicylideneaminato)], and in the presence of imidazole as cocatalyst and TBHP as oxidant, various alkenes could be epoxidized with yields between 6% and 90% (in some cases ionol was employed as additive), whereby the yields based on the amount of TBHP consumed were low (10-15%). Sterically hindered additives like 2,6-di-f-butylpyridine did not promote the epoxidation. [Pg.443]

The same Pt species that epoxidize double bonds are active in Baeyer-ViUiger oxidation of ketones. Strukul has shown that this synthetically interesting process can be carried out also enantioselectively, in the presence of appropriate diphosphine ligands For this reaction a mechanism has been proposed that involves again a quasi-peroxo metallacycle intermediate, even though in this reaction the metal catalyst plays primarily the role of a Lewis acid while the real oxidant is H2O2 itself (Scheme 9). [Pg.1073]


See other pages where Epoxides metal catalysts is mentioned: [Pg.2]    [Pg.2]    [Pg.40]    [Pg.35]    [Pg.186]    [Pg.187]    [Pg.188]    [Pg.203]    [Pg.243]    [Pg.162]    [Pg.186]    [Pg.223]    [Pg.324]    [Pg.51]    [Pg.216]    [Pg.416]    [Pg.29]    [Pg.55]    [Pg.669]    [Pg.161]    [Pg.1]    [Pg.260]    [Pg.186]    [Pg.115]    [Pg.117]    [Pg.12]    [Pg.323]    [Pg.369]    [Pg.391]    [Pg.501]    [Pg.525]    [Pg.1494]    [Pg.575]   
See also in sourсe #XX -- [ Pg.470 ]

See also in sourсe #XX -- [ Pg.470 ]

See also in sourсe #XX -- [ Pg.6 , Pg.470 ]




SEARCH



Asymmetric epoxidation transition metal catalysts

Catalysts epoxidation

Epoxidation Using Metal-Porphyrin-Based Catalysts

Epoxidation hydrogen peroxide - metal catalysts

Epoxidation with metal-porphyrin-based catalyst

Epoxides catalyst

Epoxides metalation

Epoxides transition metal catalysts

Metal epoxidations

Metallated epoxides

Porphyrin metal complex catalysts, alkene epoxidation

Transition metal catalysts olefin epoxidation

© 2024 chempedia.info