Endo product

Theoretical work by the groups directed by Sustmann and, very recently, Mattay attributes the preference for the formation of endo cycloadduct in solution to the polarity of the solvent Their calculations indicate that in the gas phase the exo transition state has a lower energy than the endo counterpart and it is only upon introduction of the solvent that this situation reverses, due to the difference in polarity of both transition states (Figure 1.2). Mattay" stresses the importance of the dienophile transoid-dsoid conformational equilibrium in determining the endo-exo selectivity. The transoid conformation is favoured in solution and is shown to lead to endo product, whereas the cisoid conformation, that is favoured in the gas phase, produces the exo adduct This view is in conflict with ab initio calculations by Houk, indicating an enhanced secondary orbital interaction in the cisoid endo transition state . 

The reaction between 2.4 and 2.5 yields four products two enantiomeric endo products and two enantiomeric exo products. In this section the effect of the solvent, the Lewis-acid and the substituents on the endo-exo selectivity are described. Chapter 3 will mainly focus on aspects dealing with the enantioselectivity of the reaction. 

In the alkylative cyclization of the 1,6-enyne 372 with vinyl bromide, formation of both the five-membered ring 373 by exn mode carbopalladation and isomerization of the double bonds and the six-membered ring 374 by endo mode carbopalladation are observed[269]. Their ratio depends on the catalytic species. Also, the cyclization of the 1,6-enyne 375 with /i-bromostyrene (376) affords the endo product 377. The exo mode cyclization is commonly observed in many cases, and there are two possible mechanistic explanations for that observed in these examples. One is direct endo mode carbopalladation. The other is the exo mode carbopalladation to give 378 followed by cyclopropana-tion to form 379, and the subsequent cyclopropylcarbinyl-homoallyl rearrangement affords the six-membered ring 380. Careful determination of the E or Z structure of the double bond in the cyclized product 380 is crucial for the mechanistic discussion. 

The reactions of trialkylboranes with bromine and iodine are gready accelerated by bases. The use of sodium methoxide in methanol gives good yields of the corresponding alkyl bromides or iodides. AH three primary alkyl groups are utilized in the bromination reaction and only two in the iodination reaction. Secondary groups are less reactive and the yields are lower. Both Br and I reactions proceed with predominant inversion of configuration thus, for example, tri( X(9-2-norbomyl)borane yields >75% endo product (237,238). In contrast, the dark reaction of bromine with tri( X(9-2-norbomyl)borane yields cleanly X(9-2-norbomyl bromide (239). Consequentiy, the dark bromination complements the base-induced bromination. 

Note that the endo product is predicted by the concerted mechanism. It is the major product, even though it is sterically more congested than the exo isomer. This stereospecificity is characteristic of the reaction. 

The TiX2-TADD0Late-catalyzed 1,3-dipolar q cloaddition reactions were extended to include an acrylate derivative [66]. In the absence of a catalyst, the reaction between nitrones 1 and acryloyl oxazolidinone 19b proceeded to give a mixture all eight regio-and stereoisomers (Scheme 6.23). However, application of in this case only 10 mol% of Ti(OTs)2-TADDOLate 23d as catalyst for the reaction of various nitrones 1 with alkene 19b, led to complete regioselectivity and high endo selectivity in the reaction and the endo products 21 were obtained with 48-70% ee (Scheme 6.23) [66]. 

Another stereochemical feature of the Diels-Alder reaction is that the diene and dienophile partners orient so that the endo product, rather than the alternative exo product, is formed. The words endo and exo are used to indicate relative stereochemistry when referring to bicyclic structures like substituted norbornanes (Section 4.9). A substituent on one bridge is said to be exo if it is anti (trans) to the larger of the other two bridges and is said to be endo if it is syn (cis) to the larger of the other two bridges. 

Endo products result from Diels-Alder reactions because the amount of orbital overlap between diene and dienophile is greater when the reactants lie directly on top of one another so that the electron-withdratving substituent on the dienophile is underneath the diene. In the reaction of 1,3-cyclopentadiene with maleic anhydride, for instance, the following result is obtained ... 

The situation grows more complex if, concurrent with racemization, chemical products are formed. The case of the optically active norbomyl cation comes to mind, since both exo and endo products can be formed in essentially irreversible reactions. This is diagrammed as follows ... 

Apart from the cyclopropanation reaction, only one example has been published of the application of ionic liquids as reaction media for enantio-selective catalysis with bis(oxazoline) ligands. In this case, the complex 6b-ZnCl2 was used as a catalyst for the Diels-Alder reaction between cyclopen-tadiene and N-crotonyloxazolidin-2-one in dibutyUmidazoUiun tetrafluorob-orate (Scheme 9) [48]. Compared with the same process in CH2CI2, the reaction was faster and both the endofexo selectivity and the enantioselectivity in the endo product were excellent. However, experiments aimed at recovering the catalysts were not carried out. 

Cyclic dienes give mainly endo-products through kinetic control. 

Endo product (86) is thought to result from thermal addition and is probably not a photoproduct. Cyclohexadiene yields cyclobutanes (87)—(89) and 1,4-cycloaddition product (90) with dimethylmaleic anhydride(87> ... 

As in the photoaddition of maleic anhydride to norbomene, the endo product (93) may arise from a charge-transfer complex. 

Since the rearrangement afforded endo product from endo zwitterion and exo product from exo zwitterion, the rearrangement follows the slither mechanism. 

Finally, Parker and coworkers [101] were able to use this approach for the total synthesis of SNF4435C (6/1-190) (Scheme 6/1.51). The Pd-catalyzed reaction of 6/1-191 and 6/1-195 gave a 4 l-mixture of 6/1-190 and its endo-diastereomer 6/1-199 in 53% yield. In this transformation, the tetraene 6/1-196 can be assumed as intermediate, which theoretically could undergo an 8jt/6jt electrocyclization to give the endo-products via conformation 6/1-197 and the exo-products via conformation 6/1-198. However, only the two endo-products 6/1-190 and its diastereomer 6/1-199 are found, and not 6/1-200, which is consistent with the most likely nonenzymahc formation of 6/1-190 and its diastereomer in Nature from their co-metabolite spectabilin. 

GuoetaLhavereported Diels-Alder reaction of differently substituted2-acetyl-[l, 2,3] diazaphospholes, 6 with cyclopentadiene and obtained both endo and exo cycloadducts in moderate yields depending on the reaction conditions (Scheme 28). By quenching the room temperature reaction after only 5 min, endo product 89 was obtained exclusively in 65-75% yields, while prolongation of reaction time to 3 days led to the isolation of only exo product 90 in 50-75% yields [19]. 

Palladium-catalyzed cyclization of alkenes and alkynes were reported by Balme and co-workers.143 144 Intramolecular carbopalladation occurs to give polycyclic compounds. It has been shown that the nucleophile type has a large influence on the cyclization process. Both 5-exo- and 6-endo-cyclization are observed for substrates with nitrile (116 and 118) and ester (120, 122, and 124) substituents, respectively (Scheme 36). When a mixed nucleophile (CN and C02Me) is used, a mixture of 5-exo and 6-endo products is obtained. The chemoselectivity is controlled by the size of the nucleophile used. The stereochemistry of the initial double bond plays an important role on the stereoselectivity of the cyclization. (Z)-olefins (118 and 120) and (/. )-olefins (116 and 124) afford as- (119 and 121) and trans-cyclization products (117 and 123), respectively. 

Linz et al.6 report the synthesis of enantiomerically pure cyclosarkomycin 6, a stable crystalline precursor of sarkomycin 5. As described in Scheme 5-3, 6 can be obtained from 8, an asymmetric Diels-Alder adduct of (E )-bromoacry-late. (E)-3-bromoacrylate 9a [the acrylate of (R)-pentolactone 11] and 9b [the acrylate of ( S )-A-methyl hydroxyl succinimide 12] undergo TiCL-mediated Diels-Alder reactions giving 10a or 10b, the endo-product, with high diaster-eoselectivity (Scheme 5-4). With the key intermediate 10a in hand, synthesis of compound 6 is accomplished by following the reaction sequence shown in Scheme 5-5. 

Collins and co-workers have also reported on an enantioselective catalytic Diels—Alder cycloaddition, in which zirconocene and titanocene bis(triflate) complexes were used as catalysts [104], The influence of the solvent polarity on the observed levels of stereoselectivity is noteworthy. For example, as shown in Scheme 6.34, with 108 as the catalyst, whereas in CH2C12 (1 mol% catalyst) the endo product was formed with 30% ee (30 1 endoxxo, 88% yield), in CH3N02 solution (5 mol% catalyst) the enantioselectivity was increased to 89% (7 1 endoxxo, 85% yield). Extensive 1H and 19F NMR studies further indicated that a mixture of metallocene—dienophile complexes was present in both solutions (-6 1 in CH2C12 and -2 1 in CH3N02, as shown in Scheme 6.34), and that most probably it was the minor complex isomer that was more reactive and led to the observed major enantiomer. For example, whereas nOe experiments led to ca. 5 % enhancement of the CpH proton signals of the same ring when Hb in the minor complex was irradiated, no enhancements were observed upon irradiation of Ha in the major complex. 

Pd(Ph3P)4 and Et3N in refluxing acetonitrile to form the intramolecular Heck cyclization product 152 [125]. The mechanism is akin to that of the Mori-Ban indole synthesis (see page 24). In another case, the intramolecular Heck cyclization of enamidone 153 with a pendant thienylbromide moiety furnished the 6-trig-endo product, indolizine 154, in 63% yield, along with the debrominated enamidone 155 in 37% yield [126],... 

Radical cyclization to macrolides.111 Cyclization of iodoalkyl acrylates (1) by reaction with Bu3SnH (1 equiv.) in the presence of AIBN is useful for formation of macrolides (2) containing 11 or more members. Similar cyclization of iodoalkyl fumarates (3) results in two macrolides with the endo-product predominating except when n is 16 or higher. Tertiary iodides undergo this free radical cyclization more... 

In these dimerisations one molecule acts as a diene and the other as the dienophile. The endo product is thermodynamically less stable and secondary interactions tend to reduce the activation energy. No such interactions are possible for the exo transition state. 

Some more examples of endo addition (1) Addition of maleic anhydride to cyclopentadiene. Here also two orientations are possible and the endo product predominates. Sometimes the exo adducts are completely excluded. 

---