Drinking membranes

In reverse osmosis membranes, the pores are so smaH, in the range 0.5— 2 nm in diameter, that they ate within the range of the thermal motion of the polymer chains. The most widely accepted theory of reverse osmosis transport considers the membrane to have no permanent pores at aH. Reverse osmosis membranes are used to separate dissolved microsolutes, such as salt, from water. The principal appHcation of reverse osmosis is the production of drinking water from brackish groundwater or seawater. Figure 25 shows the range of appHcabHity of reverse osmosis, ultrafiltration, microfiltration, and conventional filtration. 

Although the principal appHcation of reverse osmosis membranes is still desalination of brackish water or seawater to provide drinking water, a significant market is production of ultrapure water. Such water is used in steam boilers or in the electronics industry, where huge amounts of extremely pure water with a total salt concentration significantly below 1 ppm are required to wash siUcon wafers. 

Cg pH-sensitive film had a dynamic range from 6 to 8 and Cg-film responded at higher pH values (8-10).The membranes showed good reproducibility, reversibility and a short response time (<10 s). They also can be used for at least 3 months without any considerable absolution deviations. These sensors can be used for direct determination of pH in drinking water detergent and dishwasher liquid that have good agreement with pH meter data. 

ZENONEnvironmental Inc. Contains information on membrane technology and equipment descriptions and support services for drinking water treatment applications, http //www.zenonenv.com/zenon drinking water.html... 

Unrestricted use of reclaimed wastewater for drinking water, however, requires careful examination. While practically a complete barrier to viruses, bacteria, and other toxic entities that must be kept out of a potable supply, RO membranes could pose serious problems should any defect develop in their separation mechanism. Given the purity and clarity of RO-treated wastewaters, however, it might be advantageous to use RO and then subject the product to well-established disinfection procedures. 

The most significant application of reverse osmosis has been in the field of desalination to produce drinking water. Other important apphcations include the treatment of industrial waste water, concentration of fruit juices, and concentration of weak solutions such as aqueous ethanol [3-6]. The rest of the chapter will focus almost entirely on semi-permeable membranes used for reverse osmosis based applications. We chose this focus in view of the importance of reverse osmosis as a rather efficient separation technique for separating a wide range of solutions, especially very dilute solutions—which are usually notoriously difficult to handle using conventional techniques such as distillation. 

Oxidizing bleaches kill microbes by reacting with cell membranes and cell proteins. The most widely used is sodium hypochlorite for household and hospital uses, and calcium hypochlorite for drinking water and swimming pool disinfecting. 

Reverse osmosis can be used to purify water, because the liquid passing through the semipermeable membrane is pure solvent. A water purifier that uses reverse osmosis requires semipermeable membranes that do not rapture under the high pressures required for reverse osmosis. Recall that seawater has an osmotic pressure of nearly 28 atm and that red blood cells rupture at 7 atm. Nevertheless, membranes have been developed that make it feasible to purify water using this technique. Reverse osmosis currently supplies pure drinking water to individual households as well as entire municipalities. 

Applications RO is primarily used for water purification seawater desalination (35,000 to 50,000 mg/L salt, 5.6 to 10.5 MPa operation), brackish water treatment (5000 to 10,000 mg/L, 1.4 to 4.2 MPa operation), and low-pressure RO (LPRO) (500 mg/L, 0.3 to 1.4 MPa operation). A list of U.S. plants can be found at www2.hawaii.edu, and a 26 Ggal/yr desalination plant is under construction in Ashkelon, Israel. Purified water product is recovered as permeate while the concentrated retentate is discarded as waste. Drinking water specifications of total dissolved solids (TDS) < 500 mg/L are published by the U.S. EPA and of < 1500 mg/L by the WHO [Williams et ak, chap. 24 in Membrane Handbook, Ho and Sirkar (eds.). Van Nostrand, New York, 1992]. Application of RO to drinking water is summarized in Eisenberg and Middlebrooks (Reverse Osmosis Treatment of Drinking Water, Butterworth, Boston, 1986). 

This technique has been applied to the concentration of organochlorine and organophosphorus insecticide [7,8] and various ethers, glycols amines, nitriles, hydrocarbons, and chlorinated hydrocarbons. Although this work was concerned with drinking water, it is a useful technique which may have application in seawater analysis. Cellulose acetate [9], ethyl cellulose acetate [6], and crosslinked polyethyleneinine [8] have been used as semi-permeable membranes. 

---