Distribution coefficients temperature effects

In the molten salt extraction process, the variables that control the values of the americium and plutonium distribution coefficients are temperature, metal composition, salt composition, and total americium. To minimize the variables, the extractions are conducted at a fixed temperature of about 750°C. Slight changes of magnesium content in the metal have a negligible effect upon the value of the americium and plutonium distribution coefficients. The effect of americium concentration... 

It is clear that the separation ratio is simply the ratio of the distribution coefficients of the two solutes, which only depend on the operating temperature and the nature of the two phases. More importantly, they are independent of the mobile phase flow rate and the phase ratio of the column. This means, for example, that the same separation ratios will be obtained for two solutes chromatographed on either a packed column or a capillary column, providing the temperature is the same and the same phase system is employed. This does, however, assume that there are no exclusion effects from the support or stationary phase. If the support or stationary phase is porous, as, for example, silica gel or silica gel based materials, and a pair of solutes differ in size, then the stationary phase available to one solute may not be available to the other. In which case, unless both stationary phases have exactly the same pore distribution, if separated on another column, the separation ratios may not be the same, even if the same phase system and temperature are employed. This will become more evident when the measurement of dead volume is discussed and the importance of pore distribution is considered. 

In closing, recovery of technetium from waste solution should be touched upon. Studies of the base hydrolysis of technetium P-diketone complexes revealed that all of the complexes studied decompose in an alkaline solution even at room temperature, until technetium is finally oxidized to pertechnetate. These phenomena are very important for the management of technetium in waste solutions. Since most metal ions precipitate in alkaline solution, only technetium and some amphoteric metal ions can be present in the filtrate [29]. A further favorable property of pertechnetate is its high distribution coefficient to anion exchangers. Consequently, it is possible to concentrate and separate technetium with anion exchangers from a large volume of waste solution this is especially effective using an alkaline solution [54],... 

The choice of operating temperature can have a profound effect on a chromatographic separation due to the temperature dependence of the distribution ratio D of each solute or to be strict, of the distribution coefficient A , (cf. solvent extraction, p. 56). The relation is an exponential one,... 

Sablani, S.S. and Rahman Shafiur, M. 2003. Effect of syrup concentration, temperature and sample geometry on equilibrium distribution coefficients during osmotic dehydration of mango. Food Res. Int. 36, 65-71. 

Composite-based PTC thermistors are potentially more economical. These devices are based on a combination of a conductor in a semicrystalline polymer—for example, carbon black in polyethylene. Other fillers include copper, iron, and silver. Important filler parameters in addition to conductivity include particle size, distribution, morphology, surface energy, oxidation state, and thermal expansion coefficient. Important polymer matrix characteristics in addition to conductivity include the glass transition temperature, Tg, and thermal expansion coefficient. Interfacial effects are extremely important in these materials and can influence the ultimate electrical properties of the composite. 

Why discuss distribution coefficients Most everyone is familiar with the demonstration of iodine distributed between an organic and an aqueous layer. However, distribution equilibria are at the heart of many separation processes from liquid-liquid extractions to virtually every type of chromatography in which the distribution of the solute between the mobile phase and the stationary phase determines the effectiveness of the separation. In the practice of analytical chromatography, distribution coefficients are often called partition coefficients but the concept is identical, only the names have changed. The temperature dependence of a distribution coefficient is at the heart of temperature programming in gas-liquid chromatography (GC), and analyses of the temperature behavior depend on the heats of solution of the distributed solutes. Indeed, GC measurements have been used to measure heats of solution. 

The following, well-acceptable assumptions are applied in the presented models of automobile exhaust gas converters Ideal gas behavior and constant pressure are considered (system open to ambient atmosphere, very low pressure drop). Relatively low concentration of key reactants enables to approximate diffusion processes by the Fick s law and to assume negligible change in the number of moles caused by the reactions. Axial dispersion and heat conduction effects in the flowing gas can be neglected due to short residence times ( 0.1 s). The description of heat and mass transfer between bulk of flowing gas and catalytic washcoat is approximated by distributed transfer coefficients, calculated from suitable correlations (cf. Section III.C). All physical properties of gas (cp, p, p, X, Z>k) and solid phase heat capacity are evaluated in dependence on temperature. Effective heat conductivity, density and heat capacity are used for the entire solid phase, which consists of catalytic washcoat layer and monolith substrate (wall). 

Temperature Effects. The effect of a temperature increase from 25°C to 65°C is usually a small increase of the distribution coefficient (less than a factor of three). For the sorption of Cs on bentonite, which would correspond to an ion exchange process, the effect of increased temperature is the opposite. 

Monte Carlo simulation techniques are used for calculating the distribution coefficients of benzene between supercritical C02 and slitpores at infinite dilution. The Lennard-Jones potential model is used for representing the pair interactions between C02, benzene, and graphite carbon. The effects of temperature, slitwidth, and benzene-surface interaction potential on the distribution coefficients are explored at constant density and constant pressure. 

Temperature has a dramatic effect on the separation efficiency of conventional HS with both solid and liquid samples. The partition coefficient decreases slightly with increasing temperature. As a result, the headspace technique is more sensitive at high temperatures. Figure 4.10 illustrates the effect on equilibrium HS for liquid samples at three different temperatures [68]. Users tend to decrease the distribution coefficient... 

---