Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Dispersing DLVO-theory

DLVO Theory. The overall stabiUty of a particle dispersion depends on the sum of the attractive and repulsive forces as a function of the distance separating the particles. DLVO theory, named for Derjaguin and Landau (11) and Verwey and Overbeek (12), encompasses van der Waals attraction and electrostatic repulsion between particles, but does not consider steric stabilization. The net energy, AGp between two particles at a given distance is the sum of the repulsive and attractive forces ... [Pg.148]

The physicochemical forces between colloidal particles are described by the DLVO theory (DLVO refers to Deijaguin and Landau, and Verwey and Overbeek). This theory predicts the potential between spherical particles due to attractive London forces and repulsive forces due to electrical double layers. This potential can be attractive, or both repulsive and attractive. Two minima may be observed The primary minimum characterizes particles that are in close contact and are difficult to disperse, whereas the secondary minimum relates to looser dispersible particles. For more details, see Schowalter (1984). Undoubtedly, real cases may be far more complex Many particles may be present, particles are not always the same size, and particles are rarely spherical. However, the fundamental physics of the problem is similar. The incorporation of all these aspects into a simulation involving tens of thousands of aggregates is daunting and models have resorted to idealized descriptions. [Pg.163]

In a number of recent publications (1, 2) microcrystailine cellulose dispersions (MCC) have been used as models to study different aspects of the papermaking process, especially with regard to its stability. One of the central points in the well established DLVO theory of colloidal stability is the critical coagulation concentration (CCC). In practice, it represents the minimum salt concentration that causes rapid coagulation of a dispersion and is an intimate part of the theoretical framework of the DLVO theory (3). Kratohvil et al (A) have studied this aspect of the DLVO theory with MCC and given values for the CCC for many salts, cationic... [Pg.377]

The DLVO theory, a quantitative theory of colloid fastness based on electrostatic forces, was developed simultaneously by Deryaguin and Landau [75] and Verwey and Overbeek [76], These authors view the adsorptive layer as a charge carrier, caused by adsorption of ions, which establishes the same charge on all particles. The resulting Coulombic repulsion between these equally charged particles thus stabilizes the dispersion. This theory lends itself somewhat less to non-aqueous systems. [Pg.79]

The pair potential of colloidal particles, i.e. the potential energy of interaction between a pair of colloidal particles as a function of separation distance, is calculated from the linear superposition of the individual energy curves. When this was done using the attractive potential calculated from London dispersion forces, Fa, and electrostatic repulsion, Ve, the theory was called the DLVO Theory (from Derjaguin, Landau, Verwey and Overbeek). Here we will use the term to include other potentials, such as those arising from depletion interactions, Kd, and steric repulsion, Vs, and so we may write the total potential energy of interaction as... [Pg.49]

Dispersions of fine mineral particles can be stabilised by direct electrical charging of the particles or by steric/electrosteric protection from adsorbed polymers. Stabilisation by direct charging is well described by the classical DLVO theory. ... [Pg.6]

Throughout most of this chapter the emphasis has been on the evaluation of zeta potentials from electrokinetic measurements. This emphasis is entirely fitting in view of the important role played by the potential in the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory of colloidal stability. From a theoretical point of view, a fairly complete picture of the stability of dilute dispersions can be built up from a knowledge of potential, electrolyte content, Hamaker constants, and particle geometry, as we discuss in Chapter 13. From this perspective the fundamental importance of the f potential is evident. Below we present a brief list of some of the applications of electrokinetic measurements. [Pg.567]

What is the relation between the stability ratio and the DLVO theory How would you use the DLVO theory to predict the stability ratio of a dispersion ... [Pg.620]

Hunter, R. J., Foundations of Colloid Science, Vol. 2, Clarendon Press, Oxford, England, 1989. (Undergraduate and graduate levels. Along with Volume 1, these two volumes cover almost all the topics covered in the present chapter at a more advanced level. Volume 1 discusses DLVO theory and thermodynamic approaches to polymer-induced stability or instability and is at the undergraduate level. Volume 2 presents advanced topics (e.g., statistical mechanics of concentrated dispersions, rheology of dispersions, etc.).)... [Pg.621]

When two emulsion drops or foam bubbles approach each other, they hydrodynamically interact which generally results in the formation of a dimple [10,11]. After the dimple moves out, a thick lamella with parallel interfaces forms. If the continuous phase (i.e., the film phase) contains only surface active components at relatively low concentrations (not more than a few times their critical micellar concentration), the thick lamella thins on continually (see Fig. 6, left side). During continuous thinning, the film generally reaches a critical thickness where it either ruptures or black spots appear in it and then, by the expansion of these black spots, it transforms into a very thin film, which is either a common black (10-30 nm) or a Newton black film (5-10 nm). The thickness of the common black film depends on the capillary pressure and salt concentration [8]. This film drainage mechanism has been studied by several researchers [8,10-12] and it has been found that the classical DLVO theory of dispersion stability [13,14] can be qualitatively applied to it by taking into account the electrostatic, van der Waals and steric interactions between the film interfaces [8]. [Pg.7]

Roughly 60 years ago Derjaguin, Landau, Verwey, and Overbeek developed a theory to explain the aggregation of aqueous dispersions quantitatively [66,157,158], This theory is called DLVO theory. In DLVO theory, coagulation of dispersed particles is explained by the interplay between two forces the attractive van der Waals force and the repulsive electrostatic double-layer force. These forces are sometimes referred to as DLVO forces. Van der Waals forces promote coagulation while the double layer-force stabilizes dispersions. Taking into account both components we can approximate the energy per unit area between two infinitely extended solids which are separated by a gap x ... [Pg.103]

For small distances DLVO theory predicts that the van der Waals attraction always dominates. Please remember the van der Waals force between identical media is always attractive irrespective of the medium in the gap. Thus thermodynamically, or after long periods of time, we expect all dispersions to precipitate. Once in contact, particles should not separate again, unless they are strongly hit by a third object and gain a lot of energy. [Pg.103]

The stability of dispersions in aqueous media can often be described by the DLVO theory, which contains the double-layer repulsion and the van der Waals attraction. In some applications other effects are important, which are not considered in DLVO theory. At short range and for hydrophilic particles the hydration repulsion prevents aggregation. Hydrophobic particles, in contrast, tend to aggregate due to the hydrophobic force. [Pg.115]

In an aqueous electrolyte we have spherical silicon oxide particles. The dispersion is assumed to be monodisperse with a particle radius of 1 /rm. Please estimate the concentration of monovalent salt at which aggregation sets in. Use the DLVO theory and assume that aggregation starts, when the energy barrier decreases below 0ksT. The surface potential is assumed to be independent of the salt concentration at -20 mV. Use a Hamaker constant of 0.4 x 10-20 J. [Pg.117]

Additional influences on dispersion stability beyond those accounted for by the DLVO theory, like surface hydration and steric effects, have received considerable attention over the past several decades [194,278],... [Pg.132]


See other pages where Dispersing DLVO-theory is mentioned: [Pg.1740]    [Pg.397]    [Pg.533]    [Pg.148]    [Pg.149]    [Pg.442]    [Pg.248]    [Pg.249]    [Pg.251]    [Pg.47]    [Pg.18]    [Pg.90]    [Pg.150]    [Pg.540]    [Pg.544]    [Pg.677]    [Pg.201]    [Pg.532]    [Pg.579]    [Pg.144]    [Pg.498]    [Pg.498]    [Pg.103]    [Pg.122]    [Pg.127]    [Pg.132]    [Pg.265]    [Pg.305]    [Pg.310]    [Pg.134]    [Pg.134]    [Pg.46]   
See also in sourсe #XX -- [ Pg.371 ]




SEARCH



DLVO theory

© 2024 chempedia.info